0
Nissan Stanza
The Nissan Stanza was launched by Nissan in 1973, and was then separated into twin models – the A10 Nissan Auster and Nissan Violet – in 1977. All the three cars were manufactured in Hiratsuka and Oppama in Japan.
394 Questions
Where is the transmission dipstick located on a 1986 Nissan Stanza?
On the 1987, it's at the lower left corner of battery tray...mine has a little red bulb at top of stick.
A stanza is what some refer to as a verse; it is a group of lines read together and separated from the previous or next lines by a gap. e.g.
'Tis due to pigeons that alight
On Nelson's hat that makes it white
Spike Milligan
Where is the crank sensor located on 1991 Nissan Stanza?
Inside the distributer. Remove cap and rotor. Remove plate and there it is- small plastic piece.
Where is the egr valve on a 1988 Nissan Stanza?
Looking at engine from the front of the car. It is close to the firewall, in the center. Below the intake manafold. It is hidden from sight, had to feel around for it.
If gas cost 3.29 a gallon how much will it cost to drive 2400 miles if I get 17 miles per gallon?
$464.47
Where is the water pump located on your 1992 Nissan Stanza?
Attached to engine block right under alternator
What is the Torque for cam bearing caps 2.4 sohc?
Hi the correct torque is 10-12ft pounds as it is an aluminum and any greater torque will cause the bolts to stip out , beware mitchell on demand has two torque sequences and it is a misprint. I learned the hard way from the Machine shop $$$.
Handbrake sign constantly on in your Nissan almera what does this mean?
If the handbrake sign is constantly on in your Nissan Almera, this could mean various things. This may indicate that your handbrake is still engaged or it is faulty and not functional which needs to be fixed.
Where is the fuel filter located on a 1992 Nissan Stanza?
the fuel filter is located on firewall on drivers side......has 2 fuel lines going to it one on bottom and one out of the top
If you're checking the rear struts there's nothing under the seat; there are 3 bolts under the headrests but everything else is under the car. And FYI- it's a nightmare getting the struts off the rear of this car. I had to take mine to a mechanic cause it basically involves unbolting the entire rear end to get the struts off the vehicle.
Came up to a stop light and when the light changed the car would not move.
Why would a 1992 Nissan Stanza make a whistling sound when cold?
AH yes. I actually like mine! It's the Idle air control valve on the back of the throttle body. There is an idle adjust screw facing the front of the car. If not adjusted properly, or if you need a high idle due to vacuum loss from a nice extreme cam, it will whistle. Also, if it's a Cali car, it might be the vacuum valve for introducing air to the exhaust system, although I have never seen this myself.
How to change the fuel injector for Nissan Stanza 92?
There are a couple of ways to do it, cuz I did mine. So you can either take unscrew the bolts of the intake and pull it back, you have to disconnet hoses and intake air duct too, then unscrew the bolts of the rail assembly, i think there are two on the rail assembly, then unscrew the small screw on the left (your left, looking at the engine) just above the rail assembly, don't take off, this just relieves the pressure so the injectors won't spit when u wiggle them out, after that there out, unclip injector from electrical clip that sits on top, check the o-ring on top of injector and the seal that sits in the manifold, make sure there snug, then wiggle back in rail(thing all injectors are on), the put back togeather. OR you can remove the metal support that holds the cords of the accelerator, and unscrew just the rail screws, and if you have skinny fingers, wiggle it out, and proceed as above, that way you don't have to take off the intake, saves a whole bunch of time.
Where is thermostat location on Nissan sr20?
The thermostat is located behind the water neck. Follow your lower radiator hose up to the block. It will be just below the intake manifold on the front of the engine. The water neck has three 10mm bolts that hold it on. Place a catch pan under the engine and loosen the hose clamp and remove the hose from the water neck. Then remove the three bolts and the water neck and there it is.
How do you put the oil sencer on 92 Stanza?
The coolest place is off the oil pump to the left behind the harmonic balancer. This will give you PUMP pressure. Most tuners will install a second sensor at the head off of the oil galley on the driver side. This will give you real time oil lubrication of the block and head.
How do you know if you've blown a head gasket on a 97 Toyota Camry 4 cylinder?
If you see a lot of white smoke coming out of the muffler , that is the sign.
How do you replace brake pads on a 1992 Nissan Stanza?
You will need to remove the tire and wheel from your 1992 Nissan Stanza. Remove the brake pad spring and caliper. The brake assembly will come off. Reverse the process to install the new brake pads.
How much did a gallon of gas cost in 1966?
Some resources say 11 ct, some 32 ct. Since the gallon cost 35 ct in 1969, I'd rather say 32 ct is more accurate.
I was 18 years old and driving a 1965 Ford Mustang and living in Ventura. I was paying between 17.9 and 18.9...
In 1968 I bought a 68 GTO and was paying 19.9 and could fill could fill up for about 3 dollars
In my area of W-Ky a gallon of gasoline in 1966 cost .25 cents per gallon on average. Adjusted for inflation that is equal to $1.81 in 2013.
What factory size tires and rims come standard on a 1991 Nissan Stanza?
Your local Nissan dealer should be able to look this up and tell you. Give them a call, shouldn't be a fee for it...it's just information. That's all I did for my pontiac, except i called my GM dealer..lol.
