0
Oldsmobile Aurora
The Oldsmobile was a mid-size 4-door luxury sports sedan produced by General Motors from 1994 to 2003. It was powered by a 4 cam 32 valve 4.0L V-8 engine and featured a 4-speed automatic transmission.
1,019 Questions
all 3 codes lead to the trans
How do you change the plugs and wires on a 1997 Olds Aurora and what is the firing order?
the library has chilton repair manuals,i just copy the page,pages that i need for .10 cents a copy
Changing the plug wires on an Aurora(I have a 1996) is really easy. Take the cover off the top of the engine. Remember the nuts are fragile and will crack because they are actually nut covers made of plastic. The firing order is cast onto the manifold at each plug location and the distributor has the numbers of them also. Use a swival type of plug remover that is rather long. The plugs in the back are the hardest to take out. But, if you take your time an use an extension with the plug socket on it and slide it into position. Then use the 3/8 drive breakover bar to loosen the plug. You should be able to get the plugs out. I buy my plugs and plug wires at O'reilly's. The plug wires are already numbered. Also I have found that using regular A/C plugs work the best and work longer.
How do you reset oil life display on 1999 Oldsmobile Aurora?
On my aurora, I just hold in the reset button.............
Program keyless entry remotes for 1996 olds aorora?
To resynchronize the remote press and hold both the lock and unlock buttons for about 8-10 seconds. If you do it right, the horn will chirp and the lights will flash once.
You have to be in range of the car.
Too much grease in the switch you use to turn your lights,,,dealer charge 500$ to change that switch I have a solution the with 22$ you fix your problem
How do you clean a key that's has the Pass Key II?
your key for ignition is made for that specific computer in your car,i had to replace my whole steering column,the salvage yard told me the key coming with it would work..it didnt it kept telling me to clean the key,so i had to pop out the old ignition outa the old steering column and it started first time!
How do you remove Aurora hubcaps?
On my 96..... this should help. If you have the original stock wheels. The lug nut caps are made of plastic so take care when removing them. There is a small slot on the edge where you insert the end of the lug wrench to pop them off. The lug wrench is in the spare tire compartment in the trunk if you're not sure. The equipt lug wrench is designed to fit. The slot on the cap could be damaged if you use the wrong size tool. To replace, just line it up and gently tap the center to snap them back in place. Look for the slot on the edge of the hubcap. Insert a wide blade screwdriver in this slot and pry it off.
What makes low oil pressure light come on?
On G cars from the 80s, low voltage list the oil pressure light. There have been many improvements since. May still need some.
Where is the battery in a 2001 Olds Aurora?
I think it's under the back seat. I'm assuming you don't mean the one under the hood.
How are headlights replaced in 2001 Aurora?
Open the hood and you will find 2 bolts to remove the entire headlight assembly. You can then replace the bulb.
Where can you get diagram for fuse block on 1995 aurora?
Try your public library they have auto repair manuals and you can copy the wiring diagrams out of them --I have a complete set for mine and they have really been a money saver.
Need a 1995 aurora Cooling system diagram?
The public library has automotive manuals and you should be able to find what you want there. also may I suggest that you print some wiring diagrams also.
Where is the alternator on a 1998 Oldsmobile Aurora?
Tha alternator on this car car is very hard to see and to get to to replace. On the front of engine, down low between the radiator and engine, above the A/C compressor.- techJK ----------------------------------------
Location of the thermostat in a 1997 Olds Aurora?
standing in front of your car facing it on the driver side there will be a small hose coming out of the upper corner of the radiator below that there will be a larger hose follow it to a small hose connector about two inch hose the small hose runs above it i found it easy to replace buy moving the air filter box and the small hose there is no gasket but make sure the old rubber ring it cleaned out and check the trans mission fluid is much easy then to only two srews hold on the hose housing and the thermostate is in there
There is a child window lock button under the driver's window controls, it could be activated of faulty.
How do you remove the headlight assembly located on a 1998 Oldsmobile Aurora?
BRING SOME TOOLS TO THE JUNK YARD--GO PRACTICE.......
your lights won't shut off because more than likely the multifunction switch is bad in the car. This is a very expensive part, usually 400-600 dollars. did you hear a constant clicking coming form the right hand side of the dash? It will run your battery down if not fixed, of course you probably realize this. Good luck!! Just to clarify. It maybe obvious, but we aren't talking about the Daytime Runnings lights that GM has been using since '95 are we? With the DRL system your headlights are on any time your ignition is on and your parking break is disengaged.
How do you pull the drivers door panel off a 1996 Chevy suburban?
The door panel is held on by plastic push pins from the inside. First though remove the window crank if you have manual windows (there's a circlip that needs to be removed around the shaft), you can see it with a flashlight if you shine it onto the shaft while pushing the plastic door panel inward. You also need to remove the inside door handle trim, and the padded arm rest. They are both held on with screws. If you have electric windows and door locks, they must be romoved firs. For the door panel itself, you really need a special tool the auto body industry has which makes the job much easier for loostening the door panel from the plastic push pins. It can be done though if your very careful with a screw driver, and gently pop the push pins away from the panel. Once you've loosened the door panel from all of the push pins,(about 8 or so), then the panel pulls up and out of the slot that the window goes down.
What are the symptoms of a bad heater control switch on a 1997 Oldsmobile Aurora?
It will not respond to all speeds...
It will not change from high to low...
It does nothing at all...
It loose or smells burnt...
Will 22s fit if you use 245 30 22 tire on a 2001 Oldsmobile aurora?
yep my cousin has those on his white one yep my cousin has those on his white one
Where is the oil pump in a Oldsmobile Aurora?
it is an external pump that is run by the timing chain... right by the oil filter...
Where is the BCM on a 2001 Oldsmobile aurora?
The Body Control Module For a 2001 Olds Aurora Is underneath your steering column, you have to remove 3 or 4 screw on the bottom black panel....then if you look under there, its in a white mount...and its the one closest to your driver side door...there is two, one is your ECM and the other is the BCM....the ECM is the one most visible, and like i said the BCM is the one closest to your driver side door
How do you replace the low beam headlight located on a 2000 Dodge Intrepid?
There are 2 large 7/16ths screws (both colored black), both on the top of the headlight assembly. Remove both of them, then pull the assembly out towards the front of the car. You might have to pull out on the bottom of the assembly first to remove it. Once the assembly is removed, look at the back of it...The Low beam bulb is the one closest to the yellow signal bulb. The other one, furthest away from the signal bulb is the high beam. Remove the wire clip from the bulb you want to change (you might have to use a small screwdriver to release the plastic catch). Once the wiring is removed, turn the light socket counterclockwise (looking at the back of the assembly) to remove the bulb from the assembly. Just reverse the procedure to put the new bulb into the assembly. When done, put the assembly back in place and replace the two long screws.
