0
Oldsmobile Cutlass
The Oldsmobile Cutlass was a compact/mid-size car produced by General Motors from 1961 to 1999. The Cutlass was one of the most popular nameplates in the vehicle industry during the 1970s.
1,158 Questions
Which of the three relays on the left front of a 1993 Olds Cutlass Ciera is the AC fan relay?
I have a 1993 olds cutlass ciera and the AC fan relay is the one in the middle on my car.
Would 22 inch rims fit on a 87 cutlass?
Yes, i have them on my 86 and they look great. Order the cups from universalcarlifts.com.The 5inch ones will clear 22s and ur car wont looked jacked up too crazy.
What is the firing order for a 1991 Oldsmobile Cutlass?
1991 Cutlass supreme LS 6 cylinders firing order is 123456. This is V6 engine, While looking at the motor from the front, number 1 cylinder is on the inside of engine compartment near the firewall. The 3 Spark Plugs facing you directly are (From left to right) 246 and the ones in the back, (firewall)are 135. To have an easier access to the ones in the back (firewall) you will have to loosen the Front mountings and either strap pull the motor forward or push the vehicle while in Park and jam the front wheels from behind with a stopper. This will make the motor tilt forward and create an enough space between the firewall and the motor. When using Spark plug wrench, you will need 2 extensions; longer one and a shorter. The spark plugs are not facing outward straight, they are slightly slant.
Where is the oxygen sensor located in an 89 Oldsmobile Cutlass Cierra?
v-6 located between the center firewall and on the top rear of engine. has one wire connector on it. In the exhaust header between the engine and the radiator. Couldn't be easier to find and work on.
Why don't the coolant fans on your 99' Cutlass work?
The coolant fan may have a blown fuse. The electric motor, on the coolant fan may be not working. The ground wire on the cooling fan may be corroded or loose.
Inertia is the tendency of all objects to resist change in motion.
How do you get power window up when it won't work on 1995 Olds Cutlass?
you must determine weather the switch or window motor is bad and replace.
how do you fix a serpentine belt tensioner. the belt is moving up and down. aslo side to side. thats a question moron ha ha
What are some common problems with the 425 cubic inch engine by Oldsmobile?
Certainly, this big-inch 1960s V8 engine was fairly thirsty by today's standards, but there weren't a lot of downsides it that I can recall. The 425 Olds was a fairly high compression engine which required premium fuel, and so it might not perform too well on today's unleaded pump gasoline. The horsepower reported in the 1960s up to 1971 was in the so-called "SAE Gross" rating, so it would be difficult to compare this engine with later models which use "SAE Net" rating. A general rule of thumb is that net horsepower is about 75-80 percent of gross horsepower. In case you don't know, the chief difference between this engine and the more common 455 Oldsmobile was the crankshaft. The 425 Olds had a stroke of 3.975 inches, while the later 455 had a stroke of 4.25 inches.
Maybe a short somewhere...did you replace the flasher unit? No - it was blinking spuradically(?) - now I have to blink it manually and it won't blink at all with lights on.
How do you change out the flasher relay and where is it located on a 1993 Oldsmobile Cutlass Ciera?
To replace the cylindrical flasher relay, pull out the ash tray to its fullest, and remove the top two bolts inside, one on each side. Push the ash tray mostly in so you can access the bottom two bolts, one on each side. Pull out and lower the ash tray until the tube-looking bulb in the center, which is hidden behind the panel, appears. Don't pull out too far, as wires still connect this bulb. With a pliers, grab the left plastic side of the bulb where the wires connect, and slowly twist away from you, pulling out at the same time, until the bulb is freed. Lower the ash tray rear and pull a bit to the left until the cylindrical flasher appears. It is clamped to the very right side end of the ash tray. Pull it out of its clamps. Remove the flasher from the pair of wire plugs. You may have to use a regular screw driver to jimmy them loose. Replace the flasher. Reverse the process.
under dash on drivers sideOn my 87 Cutlass Ciera it was located under the dash, fairly close to the steering column. I had to remove a section of plastic to get at it. I changed mine out a few years ago so cant remember in any more detail where it was.93 Olds Cutlass Ciera (Canadian)
Had the emergency flasher fail on my Ciera. Found it behind the glove box on
the passenger side of the car inside a brown coloured cover (about 3 in long,
2.5 in high and about 1.5 in wide). The turn signal flasher was mounted on the passenger side of the fuse box - you can see it when you remove the glove box. Hope this helps someone.
What are Error codes on 92 olds cutlass supreme?
u can call atuo zone and tell them what codes ur getting and they can tell u what they mean
How do I replace the starter on a 2003 Chevy Silverado?
Remove - battery cable
Raise and support vehicle
Disconnect wiring harness at top of starter
Remove starter mounting bolts
Remove starter
What is the firing order for 1980 3.8l Oldsmobile cutlass?
When owning a car it is important to know its firing order. The firing order of a 1980 3.8L Oldsmobile Cutlass is 1-6-5-4-3-2.
How do you remove the brakes from a 1994 Oldsmobile cutlass supreme?
You have to remove the calibar which is removed by the two pins that is held on by the two pins on the calibar. Most times these bolts are 3/8 heads Allen wrench. Then the calibar should lift off.
Where is the temp sensor for 93 olds cutlass ceirra 3.3?
The temperature sensor on a 93 Olds Cutlass Cierra 3.3 is located on the back of the engine. It is on the intake manifold.
How old is Wedgewood Roma Pattern?
Not absolutely sure but I have two Roma soup bowls on top of Patrician saucers (don't ask why) and they were given to my Nana as wedding presents I believe. Nana would have been married during the 2nd world war, around 1944.
hth
Where is the alternator on the 1990 Oldsmobile Cutlass Supreme?
the alternator is located on the upper left hand side of the engine. just follow the belt and you will find it located at the top.that is where mine is.
It is the practice of supplying unordered items seeking payment for them. This act is totally prohibited by law.
