0
VW Jetta
The VW Jetta is a compact car manufactured by Volkswagen since 1979. As of 2006, the company sold more than 6.6 million Jetta models worldwide, one-third of which was from the US.
5,220 Questions
Need of a gear box in automobile?
- to get different speed
- to get reverse speed
- helps the vehicle to move against friction
How do you change a radiator in a 1995 Volkswagen Jetta?
i didnt know there was a volkswagon that has a radiator
Is a 00 vw jetta 2.0 liter an interference motor?
Yes
Manufacturer says replace the timing belt every 60,000 to 90,000 miles. I go with 75,000 personaly.
Where is the temperature sensor on a 1995 Isuzu Rodeo?
on the themostat housing where the upper rad hose meets the intake manifold
Hey, I had a problem like this and solved it. Take a test light and check at the ecm for power (with the key on) at the orange and black wire. My car had a broken connector in the engine compartment that feeds power to the ecm. Take some electrical tape and wire covers off. It is where two large orange wires meet three small orange wires. After repairing that, my car started right up. Good luck, Ken- Martin Auto Body
How do you change cabin filter Hyundai xg350l?
To remove existing filter: 1. Open the glove compartment, locate and remove the spring-loaded stop cord on the right hand side of the glove compartment. This is done by slightly pulling the cord into the glove compartment then feeding it back through the hole. It is spring loaded but will park in an easily reachable position. 2. Locate and remove the rubber stoppers on each side of the glove compartment and remove by pulling them out on the leading edge and slide them toward you. 3. Swing the glove compartment door down to the floor. 4. Locate and remove the 10MM bolts one each side of the lower portion of the panel behind the glove compartment. 5. Locate and remove the Phillips head screws one on each side of the upper portion of the panel behind the glove compartment. There is also one on the lower right side.
6. Locate and remove the 10MM nut located in the center portion of the panel. 7. Carefully pull out the glove compartment panel releasing the two locking clips and disconnect the two electrical connections. 8. Remove the bottom panel by carefully releasing the two locking clips and a tab that hooks onto the front lip of the blower housing. 9. Locate the filter access door and remove by pulling down and outward on the bottom lip. 10. Pull the dirty cabin filter out by the small handle located in the center of the filter. 11. Install the new filter paying close attention to the airflow directional arrows. 12. Reverse the procedure to complete assembly
Why won't my 2007 jetta key go in the ignition?
I just had this happen to me over the July 4th Holiday. Luckily I was parked at home when it happened. The first time I realized something was wrong was when I pulled into my driveway, turned off the car, and pulled the key out of the ignition. The metal part of the key was extremely hot. I thought it was unusual but I didn't pay it too much attention. About an hour later I got into my car and went to crank it up - the key would not go into the ignition. I thought the steering wheel was locked - it wasn't. I tried all of my keys and none worked. The key fobs didn't work all of a sudden either. It sounds strange, but the car car is acting as if there is a key in the ignition because the door dings when it is open, and it shouldn't. Waited until Monday and called Roadside Assistance. It was towed to my local VW dealership. I called the dealership to touch base with them. They told me there was another Jetta sitting out in the lot with the same problem. I should hear from them this afternoon. I'll send a second reply when I know what caused it.
What is the wheel base of the 2002 Volkswagen Jetta?
The 2002 Volkswagen Jetta has a 8 ft. 2.9 in. (98.9 in.) wheel base.
What do the obd code P0141 and P0140 on a 1997 Volkswagen jetta mean?
These codes are for the O2 Sensor - One is for the heater core inside the O2 Sensor, the other is the sensor. It's gone bad! - No Activity, is what it will read. It's the (Bank 1 Sensor 2) Not sure where it's located, ibelieve it's right in front of the Cat. good luck.
What does the light EPC on a 2002 Jetta mean?
An electronic powertrain control warning light means a problem in the powertrain control system. It may also mean faulty brake light switch, throttle body issue or mass air flow sensor issue.?æ
What are the four main types of SAE programs?
Ownership/Entrepreneurship, Placement, Exploratory, and Research.
Where is the crankshaft position sensor on a 1997 Saturn SW2?
UNDER HOOD, CENTER, REAR ENGINE AREA, BELOW EGR VALVE, MOUNTED IN ENGINE BLOCK You can only get to the crankshaft sensor from the bottom of your car, it's gonna be like a feeling game. It's right behind and above the starter. You're gonna need a 10mm 1/4" drive rachet. You may be able to see it from the top to get a good idea. Green connector with one yellow wire and one purple. I just changed mine today. It's pretty easy, if you jack the car up high enough. Please be sure to block your wheels and use heavy duty jackstands for safety (not cheap aluminum ones). Also remove the negative battery cable first so you don't burn yourself on starter connections. Be sure to where your safety glasses under vehicle.
Where is the blower motor resistor pack on a 1995 gmc jimmy?
Not sure about a 1995 model but on the 1993 model.....
...pop the hood, against the firewall/bulk head on the left you'll see a large black box. There is a connector with 4 wires going to it. There is a (almost) diamond shape piece of plastic with 2 bolts at each corner that the 4 wires are connected to. Remove those 2 bolts and lift out the resistor pack.
Hope this helps.
Where is cabin air filter 08 jetta 2.5L?
The cabin air filter is located on the firewall. It is on the inside of the car behind a cover just under the glove box.
How long is the 2013 VW Jetta-Hybrid?
The 2013 Volkswagen Jetta-Hybrid is 15 ft. 2.8 in. (182.8 in.) long.
What kind of fuel does the 2014 Volkswagen Jetta use?
The 2014 Volkswagen Jetta runs on regular unleaded.
How do you reset a check engine light on a 1996 Toyota Camry LE?
First, if it is something like a loose gas cap, just tighten it and it will reset itself in the next 100 miles or so. If it is something else, like a leaky gas cap it will never reset. But to reset the OnBoardDiagnostic (OBD)Computer... Go to eBay and search "obdII" and buy one, they run about $50.00 including shipping. There are two types, ISO for Chrysler and some Japanese, and the other one for all the others like Ford and GM. There are several that are both, that is the kind you want. Be sure to email the eBay seller and ask if it is used with your year and model. (1996 was a changeover year for OBDII technology, so this advice may not apply to everybody--but the dealer service guy can tell you over the phone--ask him if it is OBDII compliant.) When you get it, you just plug it in and let it cycle 4 or 5 times and it resets everything. You then have to drive your car for 50 to 100 miles for the onboard computer to test everything, and in the meantime your car will fail smog checks because it has no history in the computer and the smog test procedure demands a history even if there is no pollution. Cut and Paste http://search.ebay.com/OBDII for a list of them for sale on eBay. Most units come with a list of generic fault codes so you can tell what the problem is, this could be very helpful.
How do you replace the water pump on a 1998 volkswagen jetta 2.0?
I had mine done at a foreign car shop when I had all three rubber belts changed.
By the time you take all three belts off it's already disassembled nearly to the water pump.
How do you remove ignition lock cylinder in 97 vw jetta?
if you have a drill and center punch it is easy,
1. remove steering wheel, turn stalk housing, and everything else attached to the column
2. expose the lock cylinder housing (aluminum thing attached to steering column)
3. draw a line 10 mm from the end of the aluminum housing on the top inside (the part facing the steering wheel and shaft)
4. put a key into the lock (as long as it fits, this is for measurement purposes)
5. draw a line continuing from the key, down the side of the housing.
6. where the lines meet drill a 1/8" hole and then drill a second hole along the 10mm line north of the first hole
7. insert small center punch, or small Allen wrench into hole, press the clip inward, and pull the lock out
if you need better directions, or pics refer to the following thread:
http://forums.vwvortex.com/zerothread?id=4283438
Where are the oil pressure sensors on 1995 VW Jetta GL 2.0L?
The oil pressure sensor on a 1995 VW Jetta GL 2.0L is located on the bottom of the engine, near the oil pan. It provides oil pressure information to the vehicle's computer.
What is correct tire pressure for a volkswagen jetta with 16 inch wheels?
If your Jetta came with 16 inch wheels as original equipment the correct tire pressure is located on a plaque mounted on the driver's side door post. If the 16 inch tires are not original to your car, the tire pressure on my 2007 jetta with 16 inch wheels is 34 pounds front and rear.
Where is the water pump located on a 1996 Mazda 626 V6?
The water pump on the Mazda 'KL' V6 motors is on the passenger's side of the engine, in the center, under the motor mount, right beside the strut tower. The power steering pump belt also runs the water pump. To replace the pump you will need to remove the timing belt and tensioners, so it is advised to do everything at once when one or the other needs changed.
