Where is the coolant level sensor located on a 1998 Chevy cavalier Z24 2.4?
The coolant level sensor on a 2.4 L is under front of the coolant reservoir towards the engine. It has a 2-wire connector on it.
What is the firing order for a 1986 Chevy cavalier 2-door?
the firing order is 1 3 4 2 for the 4 cyl engines, 1 4 6 3 2 5 for the V-6
How do you change the rear shocks on a 1991 Chevy Cavalier?
All you need to do to replace the rear shocks is open the trunk and you would see 2 black caps one on the left and one on the right and they are located unde rthe speakers. Once you have found these remove them by hand or with a flat headed screwdriver and you will see i large nut on the top and two smaller ones on the side. Remove the two smaller ones on the side and this will free the shock at the top. Do the same on the other side. With the car jacked up and the wheel off you can see where the shock attaches to the wheel assembly and then from there all you do is loosen the bolt that holds it and then put the new one in and attach it to the bottom bolt and then using a jack jack up the wheel assembly and then put in the top mounting bolts that you took off earlier.
Where is the radio fuse on a 1991 Chevy Cavalier?
Both are in the left hand lower dash fuse panel, one is Radio or RDO, and the other is CIG or DOME, all must work for the radio to Function. Relentless
How is the window crank handle removed on a 2004 Jeep Wrangler?
There is a "U" shaped clip on the handle. That is all that holds it on.
What is normal operating temp on a 2005 Chevy Trailblazer?
Your gauge should read just under of 210 deg F mark. I am guessing it is the 4.2 I6
How much does a timing chain for a 1999 Chevrolet Cavalier Z24 cost and where can I find it?
Just about any parts store in the country.....and they'll have a price also.
How do you replace the back passenger window of cavalier?
the rail, on the outside of the car at the bottom edge of the window can be pryed off (little clips hold it down) gently pry it off, also then, take skinny screwdriver and poke the pin threw the handle that lets it sway open, and whala, be carefull, HOLD the window in your HAND then open it from the outside of the car, and it comes off when ya open it wider than normal, wha la, its off and hopefully not on the ground in pieces lol good luck
How do you replace the radiator when car is overheating?
Are you sure its the rad? BMW suffered from viscous fan failure. Symptoms were overheating in stationary traffic but ok when driving along.
Why Chevy Cavalier will not start?
Check if all fuses are working and see if there is any circuit short. Also check if the ignition switch is in a proper working condition.
Where is the ECM ignition fuse on a 1988 Chevy Beretta GT?
Your ECM should be located on the passenger side of the car. remove the glove box and it should be on the outide wall. I am not sure that there is an acual fuse for this. but that is where the ECM is located. i hope that this is helpful.
How do you set the clock in a 2002 Chevy Cavalier?
How do youchange the clock on a 2002 zx2 ford escort?
How do you set the clock on a 1999 Dodge Intrepid?
Next to the clock are two indented dimples. One has an "H" next to it and the other an "M". Pushing in the "H" one will advance the Hours and the "M" will advance the minutes.
If there is oil in the rad what might that mean?
If it is a pink color then the Transmission cooler is bad in the radiator,
If it is oil for sure then the engine oil cooler that's in the radiator may be leaking oil into the radiator.
It would really help to know the year ,engine size and what you are working on. The above info may not pertain to your vehicle. Need to ask your question again with all information. THANK YOU NEUTZ.
How do you replace the head gasket located on a 1999 Chevy Cavalier?
Hey Karen==Get a shop manual from a parts store and it will give you the information and it has pictures also. GoodluckJoe
If you've never done this before it'll save you time and money to pay someone else to do it.
It's way to expensive at a shop or a dealer. Is there anywhere we can get simple "how to" instructions on how to do it?
Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
Two very important tips with the 2.4L... when installing the cams turn the crankshaft 90 degrees (3 o'clock position). This puts all the pistons half way,which leaves room for the valves to open until you get everything in time.Then when it's time to put chain on and the cams are set in time turn the crank backwards that 90 degrees to 12 o'clock ... and, make sure the cam followers(lifters) are spongy and not pumped-up solid.They will not let the valves close and will destroy the open valves,piston, and possibly the head
Where do you find the flywheel on an 86 Chevy Cavalier?
The flywheel- or in your case- it is really called a "flex plate" is bolted to the crankshaft, and it is what is used to bolt the torque converter to the engine. The starter's ring gear is also welded to the flex plate. If in the rare instance you do have a manual transmission, then the flywheel is used to transmit power from the engine through the clutch/input shaft of the transmission. In either case, it is located between the engine and the transmission.
If you can smell gas in your oil that is a bad thing. If you take off your oil cap and look at the inside of the cap if you see a greyish milky whitish color than you more than likely are on your way to a fully blown head gasket. When the head gasket seal starts going it leaks gas into the motor causing it to mix with your oil. After a short period of time your oil/gas mixture will cause and overload in friction inside the motor and this will "blow" out at the weakest point that being your already damaged head gasket.
How do you replace the belt tensioner?
This is not a easy job what engine do you have. You need the service manual without it it could be a impossible task.ps it a 3.8 engine
AnswerSupport the car with a jack stand and then support the engine with a jack under the oil pan (use a piece of soft lumber between the jack and the pan or you'll be removing the pan to fix it). Remove the passenger's front wheel. Remove the push pins holding the weather shield. Remove the shield. Remove the upper motor mount. Remove the belt. The belt tensioner is held in by two bolts. Raise the engine with jack carefully until you can get your hand in to remove the top tensioner bolt. Lower the motor with the jack very slowly until you can access the bottom bolt and remove it. The tensioner will come out through the fenderwell. Put the new one in the same way. Put the bottom bolt back, raise the engine, top bolt, level the engine, attach the belt, reinstall the motor mount, weathershield and wheel. If you forget the weathershield your belt might squeak when it rains. If this sounds like a pain in the neck, take it your local shop.Where is the clutch slave cylinder located on a 1994 Chevy Camaro?
should be located on the bell housing
Where is the oil pressure sending unit located on a 1994 Chevrolet Cavalier 3.1 V-6?
It is towards the front of the engine lower side between the starter and AC compressor. Sticks out about 2 inches from engine.
Where is the dimmer switch on Chevy Cavalier 1990?
IT IS LOCATED UNDER THE PLASTIC STEERING COLUMN COVER NEXT TO THE HEADLIGHT SWITCH
Where is the horn located on a '96 Chevy Cavalier?
The horn is under the hood in front of the radiator. to be more specific it's in the front right corner, at least on my 96 LS 4 door it is...may have to undo some inner fender screws to get to it...i'm installing an air horn that is activated when i press the horn on the steering wheel :)
How to disable buzzer in 1992 Chevy Cavalier?
i would say the easiest solution would be to look in youre fuse box and find the fuse that has "chime" on it. Make sure you look to see that the same fuse doesn't run anything vital like your tail lights or turn signals. if they aren't labeled u can look in youre owners manual or any chiltons guide on your car.
Check your owner's manual. The symptoms you describe sound like those that indicate that the "Fail Safe Cooling System" is being activated by high engine temp. Check your coolant level AND make sure the water pump hasn't failed.