1995-2005 Chevy Cavaliers

Water becomes a gas at 100°C (212°F) at sea level. This is known as the boiling point of water.

Tail gas refers to the final output of a process or system, typically containing the remaining gases or components after various stages of purification or treatment. It is often the residual gas stream that exits a unit or process operation and may require further treatment or disposal.

Water is a gas when it reaches its boiling point of 100 degrees Celsius (212 degrees Fahrenheit) and changes from a liquid to vapor. At this point, water molecules gain enough energy to overcome the intermolecular forces holding them together as a liquid, causing them to escape into the air as water vapor.

Things that are viscous (pours out thick) are , but are not limited to, molasses, tar, honey, etc.

The color of the sky is mostly determined by the scattering of sunlight by air molecules and particles in the atmosphere. At sunset or sunrise, when the sun is lower in the sky, the sunlight has to pass through more of the Earth's atmosphere, causing shorter blue wavelengths to be scattered away and longer red and orange wavelengths to dominate, giving the sky its orange or red appearance.

Maple syrup is a liquid that pours out thick due to its high sugar content. It has a viscous consistency that allows it to flow slowly.

On a 5-speed I'm pretty sure it is right next to where the shift tower gets bolted to the trans. It is a little ball that rides on the shifting rail. Should be pretty much the only sensor that is on the top center section of the trans.

To disable the daytime running lights on a 1997 Mercedes S430, you may need to consult the vehicle's owner's manual for specific instructions. In some cases, it may require disconnecting or removing a fuse related to the daytime running lights system. Keep in mind that disabling or modifying safety features like daytime running lights may not be legal in all areas.

Maple syrup is a thick liquid that pours out slowly. Honey is another example of a thick substance that pours out in a slow stream. Tar is a thick black substance that also pours out slowly.

The direction of light can be changed through reflection, refraction, or diffraction. Reflection occurs when light bounces off a surface, changing its direction. Refraction happens when light passes through a medium with a different optical density, causing it to bend. Diffraction occurs when light encounters an obstacle or aperture, causing it to spread out and change direction.

Brake pads typically need to be replaced every 30,000 to 70,000 miles, but this can vary depending on driving habits and conditions. Signs that your brake pads need replacing include squealing or grinding noises when braking, reduced braking performance, or a pulsating brake pedal. It's important to have your brakes inspected regularly by a mechanic to ensure they are in good working condition.

probably a stone caught in the brakes, it will eventually go away, but may damage your brake rotor, worst case.

if it really annoys you, listen to what wheel it is coming from & remove the dust plate from the back & the stone should fall out (if that's what it is)

another test that you can do befor desid to change the battery ,first get a good mulimeter or DC voltmeter , then start the car, switch OFF all electrice devices like interior light , outsid light , radio, offcorse AC ,while the engine is runing disconect the posittive batery conector from it ,then test the voltag between the car chasse and the disconected positive battery pole .. if it reades from 12 to 14 volt this mean the car ulternator is ok . then the battery need to be replaced ,,, dont forget to choose good brand with same AMPS capacity..... good luck

If you smell gas in your 1995 Chevy Cavalier when the heater is on, it could indicate a leak in the fuel system that is being drawn into the ventilation system when the heater is running. This could be due to a faulty fuel line or fuel injector. It is important to address this issue immediately as it presents a potential fire hazard and can affect the vehicle's performance.

A potential problem could be a faulty fuel injector in cylinders 1 and 3, causing the excess gas in the exhaust. It could also be an issue with the ignition system, such as spark plug or ignition coil failure, preventing proper firing in those cylinders. Additionally, a problem with the engine's compression or timing could be causing the misfire.

The headlight power supply in a 1997 Chevy Cavalier is typically located near the headlight assembly or the front of the engine bay. It is usually connected to the vehicle's fuse box or electrical system. You may need to consult the owner's manual or a repair guide for specific instructions on accessing and replacing the headlight power supply.

In very hot climates with the AC on while the car is moving slow or idling, the temperature gauge of a 1998 Pontiac Grand Am should ideally stay in the middle of the gauge or slightly above, indicating that the cooling system is effectively regulating the engine temperature. If the gauge goes into the red zone, it may indicate a cooling system issue that should be addressed promptly.

You would typically use a serpentine belt tool or a breaker bar with the appropriate socket to loosen the tension pulley on a 2002 Cavalier. These tools help you apply enough force to release tension on the pulley so you can easily remove or install the serpentine belt.

Robert Mundell, a Nobel laureate economist, has previously recommended a system of fixed exchange rates using gold as a reference point, known as the "gold standard," as an alternative to the IMF. He believes this would help stabilize global currencies and prevent financial crises.

15-20 ft lbs

I have just replaced the door and dash speakers on a 2001 Toyota Echo and it wasn't an easy task. You have to remove the screws in the door panel and the C-clip from the window crank. Following, pull from the bottom of the door to release several snaps, and finally remove the door panel by pulling upwards.

The real pain about these door speakers is that the factory speakers are custom built into a plastic bracket which is attached with rivets. These can be drilled out to remove the factory speaker. Another headache is that due to window clearance, you only have two options when mounting new speakers. Option 1) buy slim-type speakers. After talking with a Crutchfield representative, it was determined that there is only 1.6" of clearance between the door panel and window when completely down.

The other pain is that the window curves and when completely rolled down, such that the top of the speaker hole is deeper than the bottom of the speaker hole.

Option 2) Buy any speaker and fabricate risers to make fit. This is the route I chose as I already had 6 & 3/4" for the doors. I fabricated four risers for each speaker out of half inch PVC pipe, each with its own custom height, to allow enough clearance for the window. After, I drilled new speaker holes and mounted with 2" #8 metal screws.

I have several detailed drawings of my install if you are interested.. please let me know...

hope this helps

When an engine overheats and loses coolant, it can lead to serious damage to various components. Overheating can cause the engine to operate outside its optimal temperature range, which can result in the following issues:

1. **Warped Cylinder Head or Engine Block:** Overheating can cause the metal components of the engine, such as the cylinder head and engine block, to warp. This can lead to leaks, reduced compression, and other problems.

2. **Blown Head Gasket:** Overheating puts a tremendous amount of stress on the head gasket, which seals the gap between the engine block and the cylinder head. A blown head gasket can result in coolant and oil mixing, leading to further engine damage.

3. **Damage to Pistons and Rings:** High temperatures can cause pistons to expand, leading to scoring or scuffing of cylinder walls. This can result in reduced compression and increased oil consumption.

4. **Damage to Bearings:** Overheating can cause damage to engine bearings, affecting the lubrication system's effectiveness. This can lead to increased friction and wear on moving parts.

5. **Coolant System Damage:** Overheating can damage various components of the cooling system, including the radiator, water pump, and hoses.

If your engine is running weird after overheating and losing coolant, it's crucial to have it inspected by a qualified mechanic as soon as possible. Continuing to drive with an overheated engine can exacerbate the damage and lead to more severe issues. The specific repairs needed will depend on the extent of the damage, but it may involve replacing gaskets, machining or replacing components, and addressing any issues with the cooling system.

In some cases, severe engine damage may require an engine rebuild or replacement. It's important to address overheating issues promptly to minimize the risk of long-term damage. Always consult with a professional mechanic for a thorough inspection and an accurate assessment of the damage to determine the best course of action.

gallon Four quarts make 1 gallon.

Note:The accumulator/drier should be replaced whenever the compressor is replaced Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Have the AC system discharged.Disconnect the neagtive battery cable * Clean the compressor thourghly around the refrigerant line fittings * Remove the serpentine belt * Raise and support it securely vehicle on jackstands * Disconnect the electrical connector from the AC compressor * Disconnect the suction and discharge lines from the compressor.Both lines are mounted to the back of the compressor with a plate secured by one bolt.Plug the open fittings and discard the seals between the plate and compressor * Unbolt and remove the rear compressor mount.It may be necessary to remove the right side engine mount bolt and raise the engine to access the rear compressor mount bolts * Remove the compressor to front bracket bolts and nuts and remove the compressor from the engine compartment