Where is the abs sensor on 2003 Chevy S 10 V 6 located?
There are 4 abswheel speed sensors. One at each wheel.
Where is the computer located on a 1990 Chevrolet k1500 4.3 v6?
the computer on Chevrolet trucks 1988 to 1998 is located behind the glove box no matter if it is a v6 or v8. all you have to do is take your glove box out. you will see it on the far right. it is very simple. you can do it with basic hand tools. when you pull the computer out remember it has been in there a while. don't be afraid to use some muscle. hope this info helps.
Yes because chevys commonly break down and are far less dependable.
this guy is so right. chevys have worse transmission, worse clutches, and a lot more
What type transmission fluid is used in a 1992 Chevy c1500 w automatic transmission?
All GM cars use Dexron transmission fluid. It may say Dexron III or Dexron VI. You can put either in your car. It used to be Dexron II, but they stopped making it so you just use whatever Dexron currently is on stores shelves. It's fairly common. Dexron III ATF (Automatic Transmission Fluid).
How do you check transmission fluid in 2006 Chevy Equinox?
The transmission has a very small dipstick that is yellow located between the transmission mount and transmission on the side closest to the radiator. There is a 13mm bolt that holds the dipstick in place. Do not remove any bolts from the top of the transmission or you can end up having to have the transmission fixed.
If it's blowing black smoke and backfiring, then I would guess that it's dumping fuel into the engine (carb or injected? stuck float/choke or fuel injector problem). Bad throttle position sensor could cause it. Plug wires installed incorrectly. Check the distributor cap for cracks and any other damage.
How much does a 2010 Chevy Camero cost?
If you have to ask about this car, Then you cant afford it anyway.
Where is the camshaft sensor on 3.1L engine?
Th cam sensor is under the power steering pump; To service the sensor the pump has to be removed.
Is Chevy hhr front wheel or rear wheel drive?
Was just looking at at 2009 and it was front wheel but am hoping the SS is all wheel or rear even. Its is definitely a truck underneath not like the pt cruiser which is a neon.
What is the maximum cargo capacity of the 2013 Chevrolet Suburban?
The maximum cargo capacity of the 2013 Chevrolet Suburban is 137.4 cu.ft..
What is the base engine size of the 2012 Chevrolet Tahoe-Hybrid?
The 2012 Chevrolet Tahoe-Hybrid has a 6.0 L base engine size.
How do you bleed a power steering pump on a Chevy?
Generally with engine running, turning the steering wheel back and forth will bleed the system.
Do not turn until wheel can go no further; this is what blows seals. You should turn nearly all the way then back the other way.
Which fuse works the cooling fans?
The fuse that works the cooling fan(s) depend on the make/model/year of the car. In general cooling fans are controlled by a fan relay & fuse or by the ecm, bcm,pcm (ecm/bcm/pcm are computers)
Where is the ignition coil on a 2000 Chevy 5.3 Liter engine?
Each cylinder has it's own ignition coil on the 5.3. The coil is mounted on the valve cover in line with the spark plug and wire for each cylinder. Voltage ultimately comes to the coils from the PCM through the cam shaft timing sensor.
How do you take off the the steering wheel from an 83 Chevrolet Pick-up?
Pull the center horn mechanism, remove the single large nut in the center, connect a steering wheel puller to the 3 (sometimes 2) threaded holes around the center of the steering wheel splined hub and use the puller to loosen the wheel. It won't come off without a puller. Don't even bother to try.
Where is thermostat on 5.3 Chevy engine?
Find the upper radiator hose follow that and the where the hose meets the motor remove the bolts the thermostat is under the housing.
What is a chevy 327 4V engine?
It is a 327 cubic inch (5.4 liters) built by Chevrolet from 1962-69. The 4V means it had a 4 barrel carburetor. This engine produced 340 h.p. in 1962 and rose to 375 h.p in 1964. It is consider one of Chevrolets most dependable and powerful small block carburated V8s.
How much will it cost to make a 383 stroker?
To do it right about seven thousand total
The only thing you need to build a stroker is a four hundred crank and machine work which won't cost seven thousand all of the following will get you there though.
The fun comes with finding a trans that can handle six hundred horses.
here's the things we built my friends cutlass with sorry cant remember all the brands
forged connecting rods
forged flat top pistons.
good rings.
performance rod bearings
performance crank bearings.
(scat) forged 400 crank.
machine work, journals, cylinder work etc.
aluminum heads.
good studs, valves, retainers, springs, seats, etc.
(comp cams) Cam, springs, lifters.
Dual timing chain
(edelbrock) Intake
(edelbock) carb
seven quart oil pan
new fly wheel
high torque starter too much load for the stock starter
deep cycle battery
high flow oil pump
edelbrock water pump
msd setup
Hei cap w/super coil, proformance module, pick up coil, drive gear, rotor ect.
good plugs that wont foul in three hundred miles.
Good engine bolt kit
fuel pressure gauge
High flow air filter
three inch headers w/dump
royal purple oil. some kind of performance flow filter
Dyno testing
stand break in
tuning
Not a car for the street and definitely not economical.
I probably forgot something
lots of work involved but was worth it.
What year is a Chevrolet 3970010 engine block with 333882 heads?
It would appear to be a 1974- 1980 because the block # comes up as 69-80 on the year range and the heads come up as 74-80. These Heads have a decent valve size (1.94/1.50 76cc Chamber) but are smog style heads and crack easy. Be carefull