0
Chevrolet
A brand of vehicle, Chevrolet or Chevy was produced by General Motors Company (GM). The car was named after Louis Chevrolet and was set up to sell a variety of mainstream vehicles to compete with Model T by Henry Ford.
6,429 Questions
What is the gross vehicle weight of the 2003 Chevrolet Tahoe?
The gross weight of the 2003 Chevrolet Tahoe is 6500 lbs..
What is the wheel base of the 2005 Chevrolet Suburban?
The 2005 Chevrolet Suburban has a 10 ft. 10 in. (130 in.) wheel base.
Where is coolant temp sensor located on a hhr?
Coolant temperature sensors are usually located on the radiator.
How much horsepower does a 454 have that is set up for a marine app lication?
Depends on the year and vehicle it was installed in. They all do not have the same H.P.
How do you change a headlight on a 2004 Chevrolet Epica?
To change the Low Beam headlight bulb on a 2004 Chevrolet Epica you need to:
1) Remove the 3 bolts (Metric size 10) holding the headlight assembly in place. There are 2 at the top and one on side beside the grill.
2) Gently start to slide the whole assembly out, while lifting slightly to get over the bumper.
3) Unplug the signal light to allow you to get additional length. (There is a little pressure connection you push in to allow you to unplug the signal light).
4)Without the signal light wire attached you can swing the whole unit out towards the grill and rest on the bumper.
5) Slide the two retainer clips holding the back cover of the headlights to their respective sides.
6) Removing the cover will expose the high/low beam light bulb. It is held in place by a wire and secured by two Phillips screws. Loosen the screw closer to the grill. Be-careful as it is under a bit of pressure.
7) Once loose enough you can pry the wire out and the bulb is freed.
8) Put in new bulb, be careful not to touch the glass part of the bulb.
9) Secure the wire again, and tighten the Phillips screw.
10) Replace the cover and slide the two clips into place
11) Check the high beam connection to ensure it has not disconnected or come loose.
12 Slide the assembly back towards proper place so you can hook up the signal light.
13) Slide into place, there are two plastic pegs that need to slide into their respective holes as you slide the assembly back into place.
14) Put in the three bolts and tighten.
15) Test the lights to ensure everything is working.
Presto, you've likely spent approximately 10-15 minutes and saved yourself $30-$50 and a ton of time at the garage or dealership.
Does a 2004 Chevy Aveo have a transmission filter?
Manual transmissions usually don't --- Automatic transmissions almost always do.
How much horsepower does a 1978 Chevy 454 have?
The 1978 Chevy 454 has a 240 horsepower and 360 foot-lbs. of torque. Many enthusiasts have built 454's that produce power outputs approaching 600 horsepower or more.
Where is the fuse box located on 2006 Chevy HHR?
Lift the hood, look to the right of the engine. You'll see a black box with two clips (front and back). Push clips to unlock box, lift straight up. You'll find your fuses ....... the fuse map is on the underside of the lid you lift off.
Chevy pickup hard to shift out of park?
I just had this problem with mine, and it was a loose nut on the linkage. There is also a brackett held on by the transmission pan bolts, they were loose too. After tightening all these up it shifts fine again now.
How rare is 1926 Chevrolet superior K?
Not sure how rare this Beaty is however I own one and it's in excellent condition and original, would love to know if any one has one in australia
Why doesnt my dome light come on in my chevy silverado when i open my door?
Most likely the fuse is blown for the dome light on the Silverado if the light doesn't come on.
How much torque does the engine in the 2006 Chevrolet Tahoe have?
The 2006 Chevrolet Tahoe's engine produces 295 ft-lbs. @ 4000 rpm.
How many gallons does the gas tank in the 2012 Chevrolet Suburban hold?
The gas tank on the 2012 Chevrolet Suburban holds 31.0 gal..
How do you remove a front axle from a 2001 Chevy truck?
I'd need to know if you had a solid front axle or a double wishbone independent front suspension in order to answer this.
What determined dash colors on a 1957 Chevy?
Main body color, or in the case of two tones, the color of the hood.
With the drive wheels off of the ground. Automatic transmissions depend on a pump to keep the internal transmission parts lubricated. If you tow ANY vehicle with an automatic transmission with the wheels on the ground (even in neutral) you will most likely burn the transmission up. The ONLY way around this is to let the car idle in neutral while being towed, or if it is RWD, disconnect the driveshaft. If the car has a manual transmission, you can simply tow it in neutral even with the wheels on the ground.
What was the last American car to be built with a hand crank starter?
The Model T Ford which switched to electrical start in 1919.
No it's like buying cheap plastic, but the automobiles are good enough to say a good car
Are you SURE your car is 16 volt?? I've seen 6 volt systems and 99.9% of the cars are 12 volt. So double check you numbers. I have NEVER seen a 16V battery in a car.
If the finish on the pressure plate looks rough, burned as in discolored, scratched or gouged in any way do yourself a favor and just replace it. Most shops worth anything won't turn them anymore anyway. The price of the new one is only around sixty dollars or less depending on where you get it. Be sure to check your tranny oil and replace the drive shaft seals as well they don't cost that much and when you're done your done. Good luck.
How much oil do you need for oil change?
For 1990's model vehicles, one will need 3.8 quarts of oil for an oil change. For newer models, one will need 4.5 quarts of oil.
