0
Chevrolet
A brand of vehicle, Chevrolet or Chevy was produced by General Motors Company (GM). The car was named after Louis Chevrolet and was set up to sell a variety of mainstream vehicles to compete with Model T by Henry Ford.
6,429 Questions
Where is the headlight fuse on my 1994 Chevy pick up?
It is in the fuse panel box under the steering wheel on the left hand side, if you are sitting in the the truck. Should be above the hood release handle. The panel cover just pulls out and it should say headlight above the fuse.
2003 Chevrolet won't start but the battery is in good condition?
Check to see if the battery is properly grounded, if it isn't the stater won't turn because the circuit is broken.
Where is the abs sensor on a Chevy Z71?
Antilock Braking System sensors are mounted at each wheel to directly monitor the rotation. Look for the wires going to each wheel near the brakes.
What is the estimated average mpg on a Chevy half ton pickup 1979?
You will be fortunate to get 15 mpg.
Where is the flasher unit 1997 Chevy astrovan?
It is located in the front seating area, driver side, driver side of steering column, under dash, mounted in upper left corner of fuse panel.
What cars have a lug pattern of 5x4.75?
chevy products:
camaros - 82+
corvettes - 68-96
el caminos - 64-87
s10,sonoma, blazer - 82+
g series vans - 71-96
Cadillac:
Most 76-85
How do you tighten the lifters on a Mazda MX3?
The motor on the Mx-3 is an overhead cam engine. Due to the nature of the Mx-3 overhead cam engine, the lifters never need to be tightened. There are spacers in between the valves and the camshaft that do wear out, and will need to be replaced every now and then(many miles may be accumulated before this needs to be done however). Any Mazda dealership, or Mazda certified mechanic can do this, as it takes special tools/knowledge to do so.
The lifters are also hydraulic and automatically adjust. If they are colapsed try using marvel mystery oil.
Firing order for a 1969 Chevy 396 big block?
All V8 engines have the same firing order. 1,3,5,7 is the left bank, 2,4,6,8 is the right bank and the distributor rotates clockwise. 1,8,4,3,6,5,7,2 Left bank is the drivers side and the right bank is the passenger side.
What are signs of leaking intake gasket?
By intake, I assume you mean intake manifold? Typically if your intake manifold gasket is leaking, it can have one if not several of these signs. First your Engine typically will run or idle rough, due to a vacuum leak. You could see visual signs of exhaust, anti-freeze, and or oil leakage. On some Engines you might even see your oil and anti-freeze getting mixed together in your oil pan. You also could see white exhaust fumes out of your vehicle's tail pipe, due to anti-freeze in your exhaust system. These are just a few of the signs of a leaky manifold. If you re-ask the question with make, model, and engine size I could answer with more precise answers.
Why is Engine still running dashboard lights dim but on key in hand?
What kind of auto is it. Sounds like you may have an ignition switch problem.
Torque arms are used to prevent axle rotation in hub motors.
How do you remove the grill from a Chevy C1500?
There are 10 screws in the grille that have to be removed. Remove all of them and then you should have the grille out. Simple as can be.
How do you replace a blower motor on 1994 K1500 Chevy pick-up?
take out glove box 4 small screws take off light on bottom of dash carefully pop loose electronic control box clips are on left side dis connect battery unplug both plugs out of box their are tabs top and bottom plugs may have to use needle nose pliers be careful not damage plugs and pins on box remove plastic bracket 2 front screws just loosen ,rear take out both screws remove bracket.
take off both connections to blower motor .take off rubber housing around blower motor .you must manipulate it to come off and out the bottom .take screws out of blower motor. one scew is a ground.note the clocking off blower motor and screw location of ground it must go back in the same positon after it is manuevered back in place.
and ground screw must go back in same hole. their are line up tits in aiding blower motor back to original position.
rotate blower around to come out its very tite. stick with it and have patients taking out and reinstalling blower.
its out now, do it all in reverse, i know its tight i did it take care reinstalling eveything its a little bit better now that you know were all the screws are.
How many Chevrolet Master Coupes were built in 1936?
Click the link to see production from 1927 to 1937 of every model they made.
Why don't the dash lights and running lights work in a Chevy?
Sounds like a blown fuse.
fuses are good light bulbs are new check the headlight switch pull wire harness from switch look close at all terminals you might find a melted wire on plug think its grey
What are the visual differences of a TH350 and TH400 transmission?
the th350 pan is more of a defined square shape with a corner cut off and the rear of the case is basically smooth.
the th400 has more an undefined and not square pan with ribs or fins at the rear of the case.
How can you tell what gear ratio is installed on a 1994 Chevy 1500?
a 10 bolt differential case has a 8.5 ring gear .a 14bolt has 2 different covers one is a 9.5 the other is a 10.5
How do you spell the word syphon like syphon gas?
It is normally spelled Siphon, but Syphon is an alternate spelling for the same word.
Can 2006 Chevy Equinox be flat towed behind motorhome?
A prerequisite for safe towing is use of a proper combination of vehicles. A variety of compact cars, sport-utility vehicles and trucks, including those with front-wheel drive and power steering, are approved by their manufacturers for towing over long distances without speed restrictions. In order to determine whether a vehicle is suitable to be towed behind a motorhome, check the owner's manuals of the models you are considering; this is the only way to be sure the vehicle can be towed without drive-train modifications. The owner's manual will have specific written instructions on how to tow behind a motorhome, if it is approved.
How do you change the pick up coil in a 1990 Dodge Daytona 2.2 hatchback?
The pick up coil for this engine should be right underneath the rotor inside the distributor cap. Unscrew the two screws holding the cap on, remove the rotor below it, then you should be able to lift out the pick up coil. I don't recall anything additional used to attach it, just the distributor cap screws.
