Where is the alternator for a 1998 Mazda 626?
The positive battery terminal cable will always run to the alternator- just follow it down.
The alternator is in the car for two purposes. One ... to charge the battery. Two ... to run anything and everything electrical within the car when it's running. So basically, the battery is only there to start the car and that's it, the alternator has nothing to do with the starting of the vehicle.
If the car won't start, it's probably NOT the alternator. It's a possible problem with the battery or within the starting system. It could be caused by something as simple as making sure the shifter is in the park position all the way. (automatic transmission only of course) If this is an automatic, you can also try placing the car in neutral but MAKE SURE YOU USE THE BRAKES OR PUT THE EMERGENCY BRAKE ON before and while starting it. If it starts in neutral but not in park, it's the neutral safety switch gone bad.
If the car is a manual, the clutch safety switch located (usually) above the clutch pedal may be the culprit.
Now ... there are many things in the starting system that can go wrong from a fuse, to a starter solenoid, a starter relay, the starter itself, the ignition switch, a bad connection somewhere, a broken wire or a security system within the car. There are other things that can go wrong, but without knowing the year make and model of the vehicle, this is the best I can do for ya. Good Luck!
Sounds Like You Have A Voltage Drain, That Is Something Is On Or Grounded In The Car. To Test This Buy A Test Light At Parts House. Rermove The Negetive Cable From Battery, Leaving The Positive Cable Attached To The Battery. Connect Test Light Between Negetive Cable And Negative Battery Terminal: If Light Comes On You Have Something On Or Grounded. Remove The Bulb From Hood Light First ( The On That Lights Up When You Open Engine Compartment--HOOD }. Turn Off Ignition When And If You Find The Problem The Light Will Go Out. This Is The Best Way To Find Your Problem. PLEASE NOTE ++++++++ If The Light Don`t Come On. Your Battery Is Probably Bad. In Fact Go Have The Battery Tested First !!!! Then Replace If It Is Weak Or Bad. If That Don`t Work Try The Things Above. HOPE THIS ISN`T TOO MANY THINGS. GOOD LUCK --Try look for a fuse. There should be a Fuse that connects the Battery to Alternator. It by be burn out
Will a dead alternator drain a battery?
Yes. If the alternator is dead and you drive the vehicle, all the power is coming from the battery and it will eventually drain completely.
Also, if a diode is shorted inside the alternator, that can drain a battery.
My s3 mini battery won't charge?
Your S3 mini battery won't charge because your charger is faulty or because your charging system is faulty.
How do you replace the alternator on a Ford Taurus show picture where is it location?
We cannot show pictures, however replacing the alternator on most models and years of Taurus is very easy. It is at top right of engine and even the belt tensioner is easy to access. If you are careful and don't totally remove the belt from the lower pulleys, the entire replacement of alternator can easily be done in less than an hour.
We cannot show pictures, however replacing the alternator on most models and years of Taurus is very easy. It is at top right of engine and even the belt tensioner is easy to access. If you are careful and don't totally remove the belt from the lower pulleys, the entire replacement of alternator can easily be done in less than an hour.
You need a new belt, it has nothing to do with the battery, but rather the new alternator. The belt is probably old, dry and cracked so it is slipping during the acceleration period due to the load from the engine.
It uses a permanent magnet which is rotated by a crank. The spinning magnet is positioned so that its north and south poles passed by a piece of iron wrapped with wire. It was discovered that the spinning magnet produced a pulse of current in the wire each time a pole passed the coil. Furthermore, the north and south poles of the magnet induce currents in opposite directions. By adding a commutator, it is possible to convert the alternating current to direct current.
It smells out a victom and eats it and then it goes to the brain and reports that thr rainbow zombie unicorns have been exterminated
Why would the alternator heat up and destroy the belt?
alt are easy to turn at low speed,But as the engine speed up it has a higer out put of amps so this makes it harder to turn. So by being harder to turn more Friction is created.thus more heat!
Where is alternator fuse on 1990 Ford Thunderbird?
Some 1990s had a fusible link. I am not aware of any with a fuse. The fusible link is between the alternator and the battery, connected with heavy wire. Kind of easy to miss. http://www.marksatterfield.com
The part of the circuit that is tied to a ground rod that is usually 6-8 ft long and is driven in the actual ground outside a building. Most local electrical codes require the ground circuit also be tied to the neutral bar in the electrical service panel. Effectively, you are causing the neutral bar to be grounded electrically to physical earth ground.
A ground circuit can also be on a vehicle. It usually is the car body and chassis used as a return path for electrical currents back to the battery negative post. Some vehicles use a positive ground instead of a negative ground (European vehicles usually).
How do you change the alternator on a 1989FZR 600 Yamaha?
To change the alternator on a 1989 Yamaha FZR 600, start by disconnecting the battery and removing any necessary body panels for access. Next, locate the alternator, which is typically mounted on the engine's left side, and remove the bolts securing it in place. Disconnect the wiring harness and carefully remove the old alternator. Install the new alternator by reversing the process, ensuring all connections are secure before reassembling the body panels and reconnecting the battery.
Had alternator checked they said was good but when positive is disconected car dies?
If the alternator is computer regulated it may not run with battery disconnected. The alt. may be good, but the wires to it are open/shorted.
Most alternators need a voltage present to operate. This is because the voltage is used to create the magnetic field used to generate power. If you are directly replacing another alternator, the wiring should already be correct for it. If you think that your alternator is not receiving power (for its field windings) then you should check for the presence of the voltage with a meter when the ignition switch is on. The proper place to check will depend on the vehicle, and some newer alternators will only apply the voltage when a start signal is recognized. This would make troubleshooting much more difficult.
How do you replace the alternator on a 2003 Chevy Silverado?
I just wrote an article for this procedure on a 1990 Silverado if it helps!
http://blog.jamestilberg.com/archives/274-Replacing-an-Alternator.html
<a href="http://blog.jamestilberg.com/archives/274-Replacing-an-Alternator.html">http://blog.jamestilberg.com/archives/274-Replacing-an-Alternator.html</a>
Where is the an alternator located on 1999 Buick lesabre?
Where is the a Alternator located on 1999 buick lesabre
How do you replace alternator 2002 Chevy Cavalier?
Remove the belt from your 2002 Chevy Cavalier alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
How do you loosen the belt to install a new alternator on a 1996 caprice?
you will see a 1/2" square slot in the tensioner, use a 1/2" breaker or a standard ratchet with a short extension, pop that into the slot, release the tension on the belt.
jr
How long will your car run with a dead alternator?
It will run until the battery is too low to support the engine systems, could be 10 minutes or several hours.
How often would you change an alternator for a Ford Taurus?
As often as the alternator fails... ;)
The alternator is not a 'consumable' type of part that requires routine maintenance/replacement - like a serpentine belt, brake pads, etc.
Many repair shops and auto parts stores offer inexpensive or free alternator & battery testing.
Be sure to test before replacing!
NOTE: it is a little known fact that a weak or failing battery is a major contributor to premature alternator death. Any battery that is 4 years old is a prime candidate for replacement.
See "Related Questions" below for information on how-to replace Taurus / Sable alternators
How do you replace the alternator belt on a 1997 Dodge Avenger 4 cylinder?
PROBABLY ISNT MUCH DIFFERENT THEN A 1995. GET YOURSELF A LONG 15MM RENCH AND LOSEN THE TOP BOLT OF THE ALTERNATOR YOU CAN SEE IT RIGHT BEHIND THE TIMEING BELT COVER. NOW JACK UP THE CAR , REMOVE THE TIRE AND CRAWL UNDERNEATH. LOSEN UP THE BOLT ON THE BOTTOM OF THE ALTERNATOR. HERE COMES THE FUN PART. ON THE BACK PART OF THE TOP ALTERNATOR BRACKET IS A TENSIONING BOLT, AND IF DODGE HASNT CHANGED THE SIZE ITS A 13MM. YOU HAVE TO GET YOUR ARM BACK HEHIND THERE AND WITH A 13MM ON A RATCHET WRENCH LOSEN THE TENSIONER UNTIL YOU CAN PUSH THE ALTERNATOR FORWARD ENOUGH TO GET THE BELT OFF OF THE CRANK SHAFT PULLY. REPLACE THE SAME WAY YOU TOOK IT OFF.
Where is the alternator on a 97 Chevy Monte Carlo?
Thast depends on which engine you have. The 3.l v6 it is on top of the engine nxt to the firewall. On the 3.4 dual overhead cam engine, it is located on the bottom of the passenger side of the engine. The rear of the frame will have to be lowered in order to remove it. Very involved job.- Tech JK
Why wont my Honda magna v45 hold its battery charge after riding?
Two possibles. Either the battery needs to be replaced, or the stator is not charging. First check the battery with the engine off, should have 12. 2 volts or more, if under 12 volts, then charge and check again. If under 12 volts, then replace. If over 12 volts, run engine, check the battery volts, should have over 13 volts at idle, rev up, should get over 14 volts. If battery still shows only 12. 2 or so volts, then the stator in the engine has to be replaced.