Why will engine not crank when trying to start?
Diagnosis: Engine Won't Start or Run
Check related link below
Why does 2000 Dodge Durango not start?
Turn over?
Getting fuel?
Getting spark?
If you answered yes to all of these questions, your problem is a $15.00 relay you can buy at any auto parts store. It is located in the fuse box under the hood on the left side of the engine compartment. Plug in and go.
How do you change powersteering rack on 1994 Cadillac deville?
how do you change powersteering rack on 1994 cadillac deville concours
Where is the fuel pump located on 88 Cad?
It's electric and located in the fuel tank. The tank has to be removed to get to it.
How do you replace rear speakers on 89 cadillac deville?
go in trunk. you will see two different boxes below window ledge. unscrew with fingers two black plastic bolts. once unscrewed pull torwrd middle. remove speakers from box with screwdriver. disconnect wires follow instructions of new speakers.
How do you check the transmission fluid on a 1997 cadillac deville?
I couldn't find it on my '96 either at first. The dip stick is located under the large hose connected to the air filter housing. It's probably the same on a '97.
Will a 1999 Cadillac DeVille radiator work in a 2000 Cadillac DeVille?
Will a 99 Cadillac deville radiator work in a 2000 Seville
What does code po 732 mean on a 2001 Cadillac deville?
It means you put the wrong transmission in the car
What is the gas mileage for the 1996 Cadillac Coupe deVille?
I was consistently getting 30 miles per gallon on the highway at 65 miles per hour during many 500 mile trips between homes. Then, I had an engine tune up because I detected a slight roughness in the idle. Mileage was still good. I had new plugs and wires. Bad idea. Now my highway mileage is 22 miles per gallon and the engine knocks badly. It was a 91 Deville with 4.9 engine and 75,000 miles on it. I guess I should have taken it to the dealer for the tune up.
How do you remove a northstar engine?
Remove with gearbox and suspension. Split off theengine from the subframe and gearbox. A northstar engine in an eldorado or Seville can be removed in four hrs.
Where is the brake release on 1988 fleetwood Cadillac?
Cadillac brake release: All of the Cadillacs that I have had, there is no brake release. When you put the car in drive, the parking brake automatically releases. This is good, since if your brakes ever fail, you can use your emergancy brake like a regular pedal-thats if your emergancy brake is working good. To add to this Cadillac's have a manual release in case the auto fails. Most are at the top right of the emergency brake petal, there's a little lever that pulls forward. That should release it. ( I currently have a 89 that the petal doesn't want to release half the time)
Can you use unleaded gasoline instead of premium unleaded in a cadillac?
Yes. Though you didn't mention what year model. Usually it's stamped on the fuel door of what is recommended for your car. Typically if it is a low compression, 8 to 9:1 low to mid grade unleaded is all you need and high octane or premium isn't necessary.
Premium is necessary for high compression engines, typically in BMWs and Mercedes, that are usually 10 to 11:1. And it is stamped on the fuel door. If anything less you risk bad detonation or "pinging". Which would cause left deposits and engine deterioration.
Needless to say you could run premium, if it's not recommended, though it would be a waste of money at the pump.
What size wiper blade 2002 Cadillac deville need?
The 2002 Cadillac DeVille wiper blade sizes are 22" wiper blades on both sides front. See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.
How to change brake pads on Cadillac Deville?
How do you remove the front door panel on a 1999 Cadillac Seville?
1) Lower the window.
2) Remove the Phillips screw on the lower left of door (near the bottom).
3) Pry out the power window control assembly - use a flathead and pry from the front. Be carefull, it will come out, but remove it slowly - I had to stick the screw driver down about 3/4 inch to release the metal clip. There are two metal clips - one in front the other in back.
4) Disconnect the electrical connector to the power window control assembly.
5) OK, there is the handle you use to pull the door closed - behind that pannel is a flap covered with leather - fold it UP - it doesnt look like a flap, because it's covered - fold it up, and you will see 2 Phillips screws - remove them.
6) Now, there is the interior door handle(the handle used to OPEN the door) - in the back of the handle well there is a dark piece of flat plastic - approx 2" x 3" - it comes out to expose the last screw - use the flathead - push in on the front side, then pry it towards the rear and then out. Push, pry, out.
7) Remove the last screw - it should be a Phillips, identical to the two from the other handle.
8) Now it's like any other door panel - begin popping the fasteners from the door panel off first from the bottom, and then the sides. Use your hands to do this - don't scratch that paint. It requires some force - if you break a fastner, don't worry, they are standard GM fastners and are cheap to replace.
9) Raise the door panel above the lock, and the door panel should be physically free.
10) There are two more electrical connectors now exposed - disconnect them, and your door panel is off. (On the 1999 SLS I also had to unhook the door opener cable which is very simple.)
To reinstall, it is essentially the reverse - the most trouble I had was lining up those plastic tabs. Make sure all 4 screws are in. The power window control goes back in much easier than it came out.
Where is the thermostat located on a 1997 cadillac sedan?
GO TO WWW.AUTOZONE.COM AND LOOK FOR THE SPECS. LINK
First you unscrew the lightbulb then you screw the lightbulb in
Why does Cadillac Northstar stall at idle?
Re: 98 Seville STS stalling at idle ---- You need to perform the electronic Idle Learn Procedure
The instructions for entering the diagnostic mode using the dashboard buttons are below.
The TP sensor/IDLE LEARN should be preformed when-
* TP is replaced * throttle body replaced * PCM replaced * battery disconnected or replaced * PCM code 52 * IAC adjusted * TP sensor adjustment has been preformed * min idle speed adjust procedure has been preformed
IDLE LEARN PROCEDURE ***4.9L***
1-outside temp is 50 degrees or greater
2-start engine and idle 13 min
3-at end of 13 min- enter diagnostics (engine running)
4-turn engine off
5-wait min of 20 sec
6-turn ign on (engine off)
7-enter diagnostics
8-turn ign off
9-wait min of 20 seconds
10-turn ign on (engine off)
11-enter diagnostics
12-turn ign off
13-wait min of 20 seconds
14-start engine
15- appy brakes and shift into 'drive'
16- turn the ccp 'off' and allow engine yo idle 1 minute
17- turn the ccp to 'auto' make sure AC comp engages- idle for 1
minute
18- put car in park and turn ign off
DTC display; 1998-2004 Seville and other model years with 3 buttons on the RH side of DIC
Use the 3 switches located to the right (LH drive cars) of the Driver Information Center (DIC) to activate and respond to the OBD prompts on the DIC.
ON/OFF = YES
INFO RESET = NO
INFO DOWN or INFO UP = manual toggle
Ignition ON, acknowledge any warning messages; press ON/OFF and INFO UP together for 2 to 3 seconds. Everything in front of you lights up for 4 or 5 seconds, then you will see:
Display shows "ALL?"
Answering YES will display "ALL CODES?"
Answering YES will run automatic test sequence and display codes, if any. Systems and codes will scroll faster than I am able to read them and write them; not to worry.
"ALL CLEAR CODES?" will display at the end of the automatic test. If you are satisfied you have the information you need, answer YES to clear/erase all error codes.
Answering "ALL?" with INFO DOWN will toggle systems test manually in order.
Answering "ALL?" with INFO UP will toggle system test manually in reverse order.
Press INFO RESET to reset DIC to "ALL?" to start again.
Ignition OFF to exit.
How do you remove the oil pan from a 1995 cadillac sedan deville?
well you will have to take all the bolts off and if theres any thing in the way you will have to move to take oil pan off
Will 24inch rim fit on 2003 Cadillac cts?
No only 22" inch rims will go that's the minimum FOR A 2003 CADILLAC CTS.
What happens when the drive belt on a cars water pump is loose?
Could cause the belt to slip and the engine to overheat.
How do you reset or turn off Service Engine Soon indicator on a 2003 Cadillac DeVille?
Pushing the "OFF" button, and the "WARM" buttons TOGETHER, will read the codes. Pushing the "OFF" and "HI" buttons TOGETHER to clear codes. Assumingthe cause of the light initially to come on, was corrected, the light should go off. Good luck