Chevy Corvette

== == The ECM is under the dash, on the passenger side of the car.

You have to undo the two wiring harnesses in the middle of the passenger area, under the dash. The next thing you see is the bottom of the ECM. It has two rectangular plugs going into it on the bottom.

== ==

Every Corvette since the first one has fuel injection. Corvette was the first fuel injected automobile in the US. Every Corvette since the first one has fuel injection. Corvette was the first fuel injected automobile in the US.

The auxiliary fuse box is located under the passenger side knee bolster

I saw it done, once. Now, the ZR1 wheels were pretty big, but had a ton of offset, to the negative, or back. But, with the transverse mounted spring settup, there is really not much to hit back there. Make sure to check the brake lines, that they do not rub. And, remember to use the ZR1 lug nuts. As I said, I saw it done once, however, I do not know if they used spacers, or even went to a more narrow tire. The ZR1 was physically wider, than its stock version, to hug the road better. If they used the stock width rear axle, that would leave a lot more wheel well space. If you are going to have spacing trouble, it will probably be in the front, though, and on a sharp turn. Remember to crank the wheel all the way, one direction, then the other, checking clearance each time, remembering that the suspension will allow the wheel to travel a small amount. My concern here is not the width, but the offset. Those wheels are just so offset to the negative, and wide. But, they make spacers, and adapters, and though they have come a long way with them, I do not advise them. They put a ton of force on the wheel bearings, and sometimes, they break. They are not for competition driving.

possibly the long plastic strip with teeth on it for the motor gear is stripped and can be replaced by yourself. unscrew nut on top to pull out from top and run a new one back in using power on radio to help for both.

new white plastic gear strip is cheap , about 1/4 or less of new antenna.

The 2014 Chevrolet Corvette-Stingray has a 6.2 L base engine size.

The answer is yes and no it depends.

there is a release button mounted behind the dash on the back of the switch it is a small button on top while holding the button down push and pull the switch till the whole handle pulls out of the dash. then unscrew the round plate retainer untill the switch drops behind dash ps always disconnetc battery before anay electrical work, also check the hi beam foot button for broken or rotted connections. good luck. i have a 61 with a 454 ls7.

first test pressure with a professional test kit a mechanical one let engine reach operating temp. this will be you true pressure, sometime the electric oil pressure sending unit is not compatible with your gauge and give a inaccurate reading.your pressure is way to high,did you put a high pressure race pump in? if not you have a bad pressure regulator valve in your pump 60 psi is plenty to much will start blowing oil seals

Grab ahold of the light switch under the dash you should feel on the side of the light switch a spring button. Push the button in poll the light switch knob out. Then you unscrew the nut that holds the switch in. Once you get the switch out play around with it so you can see how it works. That way it's a lot easier to install it. By the way disconnect the battery or your lights will stay on.

my wipers quit working, got a new wiper motor , it did not work either, found out that it has lost ground, attached a ground wire to engine and wiper motor and it worked.

The 1987 Chevrolet Corvette oil pressure should be between 45 PSI and 40 PSI. The idling oil pressure will be slightly less.

left of steering column, way under dash.

Bad fuel filter or pump?I would check the filter first cause that' s the most likely cause and the cheapest fix.

Yes, it is counted as a muscle car, although many people try and disprove this.

I have a 2004 Vette which should be the same. The interior fuse box is located under the passenger footboard. Tilt the footboard back slightly then lift it out, then unscrew the thumbscrew on the fuse cover.

lots, first there were different engines offered in both years, second 03 was corvettes 50th anniversary, so 03 had a different logo and an optional 50th anniversary package not available in 00. There was also a $3,000 price difference in both years. The 03 corvette had more color option's. Their were also many improvements between the years.

== ==

Seating arrangements for you and two females.

Begin by removing the water supply hoses to your heater core. Remove the heater core retaining bolts. The heater core will come out. Reverse the process to install the new heater core.

If you are talking about CDs you have burnt or copied on a computer, it should play them. You may need to change the format to get the right ones. Most CD players will play WMV & MP3. If it's the stock CD player that came with the car, it won't play MP3's as this is newer technology than 1991. Any music file with the CDA extension will work. These are much larger files and your CD will only hold about 15-20, whereas an MP3 CD can hold a couple hundred.

According to the service manual... -Turn key to the on position with the engine off.

-Press ENG MET button on the trip monitor and release, then press and release again within 5 seconds.

-Within 5 seconds of step 2, press and hold GAUGES button on trip monitor. Change oil lamp will flash

-Hold GAUGES button until Change Oil lamp stops flashing and goes out.

-When light goes out, the engine oil life monitor is reset. If it does not reset, turn ignition switch off and repeat procedure. -BewstAdd1ct

Don't do that!The airbag is a safety device which can save the life of the passenger in case of an accident!However,as the Corvette is a 2-seat car,if you are talking about a child,I strongly recommend you to install an aftermarket Passenger Airbag ON-OFF switch.That is possible even for older car models.Contact a Chevrolet dealer.