0
Chevy Lumina
Introduced in 1989, Chevy Lumina was produced by General Motor’s Chevrolet brand to replace both the Monte Carlo coupe and the Chevrolet Celebrity sedan. It has the longest length among its class at the time.
2,472 Questions
How do you replace a lost truck key for a 1996 Chevy Lumina?
Check with your local Chevy dealer. They should be able to create another key for you. Be sure to have you vin number and vehicle information handy.
If you live near a vocational school or career center, you might check their Automotive department. They might be able to help you out for a donation to the class.
What is the proper freon type to use in a 1992 Chevrolet Lumina 4 cylinder sedan?
Your car came with R12 but you can easly change it over to R134a with a inexpencive kit you can buy off Ebay for around $25.00 and it will come with everything you need. Ray
What are the codes to get the radio unlocked on a 1991 Lumina?
There are no general codes. Look at the serial number, call the dealer and they can tell you - after you ID yourself properly.
How do you remove the dash in a 1991 Chevy Lumina?
You would lower the steering column for starters. The dash panel pulls upward and the dash in front pulls toward you. Everything else is screwed in, so you need to unscrew everything else. This gets you to the nitty gritty of the dash.
Turn signals don't work on 1993 four door Chevy lumina where is the flasher located?
locate your fuse box it will be in their it will be round
Where is the Ecm location on 1993 Chevy c1500?
Take the inside of the glove box out and look in and down to the right and you will see it.
My 1992 Euro Lumina 3.1 just recently started doing this too. I have no sound reasoning but am exploring options to keep it on the road. Ive found shifting down to 1 or 2 will sometimes let you pull out, and then you can just put the car back in overdrive and carry on problem free. It seems to do it most at stop lights or stop signs after driving a while.
My car has around 184,000 miles as a point of reference. I will try to respond if I find any real mechanical repairs or solutions.
How long have you been experiencing the same problem? Been going about a month with only slight worsening for me.
Where is the fusible link for a 1994 Chevy lumina?
can you tell me where my fusible link is for my 1994 Chevy lumina
How do you change a water pump on Chevy lumina 1996 3100 engine?
Haynes Repair Manual covering 1995-2001 Chevrolet Lumina, Monte Carlo, and Impala (FWD) page 3-5 states....WATER PUMP REMOVAL... 1. Disconnect negative battery cable (CAUTION: on models with Theftlock audio system, be sure the lockout feature is turned off before disconnecting the battery). 2. Drain the antifreeze. 3. Loosen the water pump pulley bolts by using belt tension and a prybar to hold it still. 4. Remove the serpentine belt. On 3.1 L/3.4 L OHV engines, remove the small belt guard just above the water pump. 5. Remove the bolts/nuts and remove the water pump from the engine. WATER PUMP INSTALLATION... 1. Clean bolts, and other areas very well. 2. Make sure the old pump and the new pump are exactly the same (Note how the old one is located on the engine). 3.Clean the engine and water pump attaching surface with lacquer thinner or acetone. 4. Carefully attach the pump and gasket to the engine and tighten the bolts/nuts finger tight. 5. Carefully tighten the bolts/nuts to correct torque specs. 6. Reinstall other things you had to remove for access. 7. Refill the radiator. 8. Run the engine and check for leaks. I just did this and would add just a couple of minor things. You may well need more than belt tension and a pry bar to hold the pulley in place to remove the bolts. That didn't work for me. The pulley spun anyway. I used a box end wrench on one of the other bolts to hold the pulley in place while I loosened the remaining bolts. That worked until I got to the last one of course. Then I had some longer bolts with the same threading that I screwed in and held a pry bar against those to get the last one. I found that the pump would only go on one way. Unfortunately mine fell out before I was ready so I didn't know which way it had gone. But if you don't have it just right all the holes will not line up. Four of the five might but they that last one won't until you have it right. This was actually one of the easier repairs I've done. I'm not a very experienced mechanic and was freaked at first when I thought I'd have to take off the whole thing. I was relieved to find out you don't have to remove the housing. Just get the pulley off, remove five bolts and that's it.
How do you remove the radiator and condenser on a 1997 Chevrolet Lumina with a 31L engine?
The best way to find out is go to your local auto parts store, ask for a haynes or chiltons manual on your vehicle. This will tell you everything you need to know about working on your vehicle.
sounds like you have a problem with your charging system (alternator) a lot of diffrent auto parts and repair stores I.E Walmart , sears , napa offer free charging system checks
Unfortunatly you haven't alot of choices for the alt. your vehicle is equipped with a CS130D 100A factory #10480119 or 10480071, GM only produced CS103D's up to 105 Amp, I would suggest as a licensed mechanic and alt rebuilder, your better bet is to get a battery that has a longer reserve capacity. Just remember an alternator is not a battery charger , its actually designed and meant to maintain the battery .
Why won't your speedometer and RPM gauge work in your 1993 Chevy Lumina?
The 1991 > 1994 Chevy Lumina Speedometer, Odometer and maybe the RPM gauge gets a signal from the ECM computer. This ECM signal is feed to a module in the instrument panel, which feeds the three items above. If all three are not working replace the instrument panel or the module (which is inside the panel), but swap the odometer to keep your mileage correct for the vehicle. Note: The ECM gets its signal from a VSS on the Transmission and the ECM feed three areas in the car: Speed Control, Speedometer and one other (?). If the speed control works, the problem is not the VSS or the ECM. The problem is in the Instrument Panel.
Could the timing cause a 1996 Chevy lumina 3.1 from starting?
if it cranks and does not start. most common on your model bad crank sensor,bad fuel pump or relay or fuse.or bad ignition control module. must check fuel pressure while cranking,check spark and then check for injector pulse signal at injector
How do you change front brake rotor on 1997 Chevy Lumina?
Remove wheel Remove caliper (2 15 mm head bolts) Remove caliper mounting bracket ( requires special large torx socket, forget exact size, available at Sears) Rotor will now fall off practically. after machining or replacement, reverse process above. Should take less than an hour
The torx socket size is T-60.Where is the blower motor in a 1988 Chevy Caprice classic?
Under the hood on your pass side next to your heater ac box. It has a plug on it and another connector on it like 6 small bolts to take it out. Hope this helps
Why is a 3.8 liter lumina flooding the cylinder?
on 3.8 liter v6 they have problems with fuel pressure regulator or stuck open injector
Where do you add r134-a refrigerant on a 1997 Chevy Lumina V6 automatic?
if u have not done any work on the a\c before and u need to "add coolant" then u more than likely have leak somewhere wich needs to addressed first.
Where is the low ac service port for 97 lumina?
Follow the larger hose from the compressor Could be near the drier at the passenger side firewall its located between the evaporater and compressor. if that helps any
How do you add brake fluid to Chevrolet Lumina?
The fluid is added to the brake master cylinder. it is mounted under the hood on the firewall on the driver side.
