0
Dodge Avenger
Originally introduced as a 2-door coupe in 1995-2000, the Avenger is a front wheel drive car built by Alec Warner and Josh Goodman for the Dodge brand. It was later reintroduced to the market in 2008 as a 4-door sedan.
817 Questions
How do you replace the door ajar sensor on a 1997 Dodge Avenger?
on the bottom of the inner door frame there is a little nub sticking out with two screws. you have to unscrew them and pull the nub out and replace it with a new one
What is the blue book value of a 1987 dodge avenger?
if you look up kelly blue book online, and answer the questions asked on there about your vehicle, you will get a pretty accurate apprasil. however, if you take your vehicle for a trade in,on another at a car lot. the car lot will use EDMUND book value.edmund book value is a robber made only for car dealers
check to see if your brake pads are worn to thin
Are you saying that the starter motor turns but dosent engage in which case new starter motor or is there something you've missed out. Help us guys to help you by being more descriptive please.
Where is the fuel cut off switch located on a 97 Dodge Avenger?
Dodge does not use inertia/reset switches.
How many miles per gallon does a Dodge Avenger?
average 28 on the highway..20 in the city.most will get 25 on the highway
Where is the crankshaft position sensor located on a 1997 Dodge Avenger?
depending on engine size it could be in 4 different places. 2.5 liter is behind cruise control actuator.
How do you replace a headlight cover on a 2000 Dodge Avenger?
You Can't. Its all one assembly. I thought this could be done, but a dodge mechanic told me otherwise
How do you reset the change oil message on your 08 dodge avenger?
the the ignition to on but not the engine running and pres the gass pedal 3 times withing 5 seconds and it will go away
Where is the fuel pressure regulator on a 1996 dodge avenger?
on the passenger side back. next to the fuel tank and bye the filter
Where is the drain plug located for my transmission on my 99' Dodge Avenger ES?
There isn't one. You have to remove the pan to drain
What are the reasons for no spark on a 1997 dodge avenger 2.5 v6?
The coil pack could be bad. More commonly the crankshaft sensor could be bad. When this sensor is bad the system cant tell where the cam location is and will no know when to send fire to the spark plugs.
The blower motor is the key to pumping in the air and if it's spent, nothing will pump. I would try replacing that first.
AnswerOn many mopar products there is a defrost resistor (I think that's what it is called) located on the passenger side on the very top of the firewall. This provides heat to the defrost vent system before the engine can deliver any heat. Sometimes one of the heater coils wil break or becom disconnected. If you remove the part the broken part should be apparent if not test the leads with a ohmmeter for continuity. AnswerI had the same problem. The wire to the heat, etc., fell behind the fuse box, so we ran a separate wire to that fuse, and it works like new.How much will it cost to replace a deployed air bag?
The cost to replace a deployed airbag will depend on the shop, the model and year of the vehicle, and the airbag cost. Prices can range from $250 up to $600 dollars.
How do you replace the water pump on a 1996 Dodge Avenger 2.0L?
Basically, you are looking at the same steps as replacing a timing belt. You might find more by searching on "timing belt" as well.
1. remove the alternator and power steering belts. 2. remove the right side engine mounting block 3. remove the bracket for the power steering pump (it bolts into the mounting block bracket 4. remove the engine mounting bracket from the front of the plastic timing belt cover. Unfortunately, these bolts are long and are a pain in the --- as they hit the chassis. You have to do some creative wiggling to get them out. In the factory, the engine is not in the car yet when they put this in :( 5. remove the center bolt from the crankshaft pulley 6. remove the crankshaft pulley with a 3 prong pulley puller -- I had to get a longer pulley center bolt -- the puller assembly I have bottomed out with the stock bolt 7. remove the plastic timing belt cover - lots of screws, little hands are good for the tight clearances to the fender/chassis sub-frame 8. remove the timing belt -- mechanical tensioner in the middle. 9. now you can get to the water pump.
According to my Haynes Repair manual you do the following:
Disconnect the cable from the negativ battery terminal Drain the cooling system Remove the accessory drivebelts (power steering/ac) Remove the crankshaft damper/pulley, the timing belt covers and the timing belt Remove the water pump mounting bolts Seperate the pump from the water inlet pipe and remove the pipe Clean all the gasket and O-Ring surfaces on the pump and water pipe inlet tube. Install and NEW O-Ring on the water inlet pipe. Wet the O-Ring with water to facillitate assembly. Install a new gasket on the water pump and install the inlet opening over the water pipe. Press the water pipe into the pump housing. Install the water pump mounting bolts and tighten to specifications. The remainder of the installation is the reverse of the removal. Refill the cooling system Operate the engine to check for leaks.
(The timing belt removal is tricky...please find that info or suggest a mechanic.
i own a 1992 dodge avenger and when i turn the car off the key will not go past the acceseries position and come out do you have any sugjestions
First of all there is no such thing as a 1992 dodge avenger, the years are from 95-2000 and then theres the 2008 series, anyways, to fix the problem you just need to replace your ignition, you can't fix that part, only replace
Where is the fuel pump located on a 1997 Dodge Avenger?
The fuel pump is located inside the fuel tank. In order to get to it you have to remove the back seat which comes off by pulling on the two black tabs on the bottom of the seat and lifting it up. The fuel pump assembly is locater under a plate covered with dynamat material on the passenger side of the back seat area. Remove the plate by unscrewing it and you will see the assembly underneath. The fuel pump is just under the assembly inside the tank.
Dodge avenger computer is giving off no code but the check engine light is on?
Disconnect the battery for a couple of minutes and then re-connected and hopefully it will reset the cars computer.
What does srs light means in a 97 dodge avenger?
"SRS" means "secondary restraint system". In other words: The airbags. The warning light - not unusual in a fourteen year old car - means get it serviced - pronto. You're life could depend on it.
Where is the alternator on a 1998 dodge avenger?
I believe it's on the left side next to the firewall. Impossible to get to from the top without removing have the engine.
Why wont a 1999 dodge avenger start after it rains it just turns over and never cranks.?
Do you mean that it will crank and not start or fire when it rains? I do know that in earlier Fords I found to be a common occurrence and that the fix most people do not believe. The spark plug wires will fix the problem in Fords. One can test the high voltage system any way they want and the plug wires will show good. When dealing with 30000 volts (or whatever)you do not know what the high voltage is doing or the way it is acting. Try the cheap part first and change the plug wires.
Where is the dipstick for a 1995 Dodge Avenger transmission?
it is on the right hand side. it say transmission on it. read the stick before you put Filide in it
