European Ford

To connect a heater control valve on a mark 5 fiesta all the terminals must be correctly connected. The color coding is used to ensure that the terminals are correctly connected.

Bonnet release on escorts is usually on the underside if the steering column, below the steering wheel. The bonnet will pop and then you have to do the bonnet release catch around the badge on the front grill.

The thermostat is inside of the water inlet on top of the motor. Disconnect the top water hose, then unbolt the water inlet. The thermostat can then be changed.

All ford diesels from around 2002 onward have a timing chain, I have an 05 mondeo 2.0tdci ghia estate and this has the timing chain, so no cambelt worries or costs.

under the glove compartment covered with a piece of carpet fixed with two screw fixings

No the 2004 a6 3.0 is located no the front of the engine and the hole front end needs to be removed, its a holle lot of Work to be done at Home consult a Profetional Mechanic .....

you have to remove the caliper and the discs sieze on the hub plenty of wd40 and a big hammer make sure there are no grub screws holding the disc to the hub first

hai

my car is ford fiesta zetec 2003 5door ,in my cay o2 sensor have fault .can you tell me how many o2 sensor are there and were is location

h11 i believe.

emulsification and frothing of fluid causing pump to sound like it is rattling to death. seals on rack will fail some time later, replace rack, flush system, pump may be o.k.

top part of the fuel filter housing on a peugeot 206 2.0 hdi

As the engine speed increase so does the speed of the oil pump.

the faster the pump turns the higher the pressure becomes.

When changing gear the engine speed drops along with the oil pressure.

Ifound out how to change pollen filter 2002 ford focus tdci,on passenger side below wiper there is a plastic cowel the screw is under the round plastic disc on the left the other two are not screws.prise off the disc and remove the screw then carefully lift away from from the back.If there is silicon on it you will have to run a knife along the side nearest the windscreen.when plastic cowel is removed you will see the filter.lower the front of filter housing and pull out the filter,replace with new filter and silicon the cowel to stop water leakage into foot well replace screw and round disc job done.if water gets in it will blow the blower resister which is behind the glove box. 10 pounds for a new one off e bay.easy to change.

stage1 25 nm 18 ft stage 2 55 nm 40 ft stage 3 turn 90 degrees stage 4 turn 90 degrees job done

Take it to a specialist, I've looked on here and nobody knows!

I currently get about 40 mpg from my Ford ka, this is driving it about three quarters at 60 on B Roads and a quarter crawling through urban traffic.

In the MK3 Mondeo on the back seat under the cover, you need to cut the drape.

Check to make sure ther is not water in the fuse box. The fuses sit right under the dashboard on the drivers side and when the seal around the windscreen gets old it can leak water right on top of the fuse box. hope this helps The answer above is a last resort check....after wrking in a ford garage i find a lot have them have fuse prob, if u still have the owners manual which would of come with the car when bought it shows a diagram of wht fuses are wht and where do they go and how many amps there are, also they will be on the cover of the fuse box. but to answer ur question no these are all on seperarte fuses but fuses are easy to replace, u will ned to replace thm in the BOTH fuses cos of ur head lights cos each light has a fuse for the right light and a fuse for the left light. U will find one fuse box in the over from the bonet release (Usually under a special carpartment for change and stuff like tht) and the other one will be in the top corner of the engine bay on the pasanger side.

go to halfords, buy engine degreaser, (that u add to oil to clean engine.... then follow instructions, an drain oil from sump plug located underneath engine, and then replace with new oil, and also replace oil filter. if ne more help just let me know

The neutral switch is located in the console conected to the shifter. You can unplug it and put a jumper wire to test if this is your problem.

Wiring diagrams for my mondeo are in the Haynes Manual. Go to www.haynes.co.uk or go to a Halfords wher they stock most of the manuals. Always get a haynes manual :)

well ive got 2 so that helps a little great cars

well ive got 2 so that helps a little great cars

well ive got 2 so that helps a little great cars

I left on on the road a couple of years ago. Piece of crap.

ive had the same problem i think it's something to do with your indicator stalk switch

like loose connections or connecting plug it can be a pain because i have checked the fuses and they seem fine and my sidelights aren't working either. I'm only getting my main beam and dip headlights from ny stalk.

1 Kilometer per liter = 2.35 miles per US gallon So, 10 kl per liter = 23.5 mpg A close estimate (if you're converting in your head) is to double the kilometers per liter value, and increase the result by 15%.