Hand Tools

It means your engine needs attention.

Depending where it was built, a 3/8 Allen key or 15 mm regular wrench.

No. 2008 highlander has a aluminum filter housing you need to remove with a special type of filter wrench. I was able to tap mine loose without a wrench but it could be at 24n-m tight which is difficult to loosen.

You need a 3/8 Allen key

That's a 7mm Allen key.

I believe that would be a 7mm Allen key.

Like a regular wrench

15mm

17mm socket will work fine

This week, I have changed the brake pads and water pump on three vehicles that I have never worked on before. I jack them up and get in there with a full set of Allen keys and small wrenches within reach. I look and see if it needs an Allen key or wrench and approximately what size. Then I try tools that may fit till I find the correct one -usually within 2 tries. - This is not a complicated exercise. . . .

if you want the Harley oil filter wrench its part no. hd-44067

If you're strong enough, you can take it off by hand with a small piece of sandpaper for grip.

it's a 3/8 wrench for both 2003 and 2004 caliper.

11/16th, 12 point for the back bolt / use a 3/8 drive wrench along with extensions

sorry should be 9/16 , 12 point socket , the two easy bolts are 15/16 inch

the lid would open the same way. it only would open different if one screwdriver moved different. this is all because of friction.

All vehicles have many Allen screws on them. The only sensible and economical thing to do is buy 2 sets of Allen keys, usually 1/32 up to 3/8 in SAE and 1-10mm in metric. They only cost about $ 12 per set and will save you a lot of hassle if working regularly on cars.

Loosen and remove the caliper retaining bolts. Torx T-40 or T-45

For a 2000 you still have the 5S-FE motor I believe, which would be 15mm. If you have a 1zz-FE, probably 1/2 in or 17mm.

You need a 3/8 Allen Wrench

This is part of GMs Oil Life Management System. It is telling you it's time to change the oil. It must be reset after you change the oil and instructions will be in your manual under Oil Life Management System.

www.trailvoy.com - All the answers for the GMT360 platform trucks!

it should be a 10 millimeter

If it's the Hex type bolts I'm thinking of, which are the ones on my 2001 z24, it would be a 3/8.

only if it's off

The plastic body of the battery, or one of the terminals, yes, BUT... disconnected from the vehicle or not, DO NOT allow any metallic object to touch BOTH of the battery's terminals [Positive and Negative] AT THE SAME TIME.

This is because that touching both terminals at the same time with any conducting metal such as a wrench will create a SHORT CIRCUIT, and COULD cause the battery to explode, throwing shrapnel and battery acid everywhere for several feet around the shorted battery.

Either 7/16ths or 10mm

It means the engine needs attention in some way. If you ignore this,you will possibly experience rough running soon.