0
Lincoln Mark VII
The Lincoln Mark VII is a rear-wheel drive luxury car manufactured by Ford from 1984 to 1992. It was offered in a two-door coupe body style, equipped with a four-speed automatic transmission and 108.5-inch (2,756 millimeter) wheelbase.
421 Questions
How do you replace the heater core in a 86 Lincoln mark 7?
You have to drop the steering column and pull the dash. Then after locating the heater core case below windshield you have to cut out a piece with a Dremel. After replacing the heater core you have fun putting everything back together..(use plastic weld to seal the case back up).in other words don't do it yourself it is a huge pain.
Where's the fuse box located in the engine compartment of a 1986 Lincoln Mark VII?
look up underneath the dash, drivers side towards the outside of the car
What size bolts fit a Lincoln mark viii alternator?
The top are 8 mm and the bottom are 10 mm
Remember, that is wrench size.
How do you take off the motor mount on Toyota corolla 2004?
there are tree engine mounts im going to take a guess and say it is tha one closer to the lower part of radiator you will need a floor jack a square piece of wood to protect your aluminum oil pan im trying to remember the size of the bolts i think the top youll need a 17 mm deep socket a long extension 14 18 inches long a wratchet pref 1/2 drive remove the top bolt of motor mount wd40 make job a bit easier. nut is expost to water and heat all the tim after nut is off get floor jack with the wood between the jack and a flat part of pan do not let metal pad from jack touch oil pan just the wood jack up very slowly the upper bracket mounted will start to lift off the mount. now not knowing what engine you have i will tell you both types of mounting for 2 different types. hold you new mount in hand does it have a stud(bolt) on top and bottom if oit does slide under car a lokk where motor mount is located on bottom frame when you find this spot there will be a oval plastic cap you need to pop out of frame rail very easy and thin plastic now look up in the hole and you will see the bottom stud and nut remove nut usually the same size as top now look down a mount from top and jack motor just high enough to snake the mount out pay attention the way the mount comes becuse ther is a top and bottom. pay attention to alignment pins that they seat correctly. remember alum cracks very easy when pushed the wrong way. take new mount instal stud in bottom then lower engine slowly but not all the wat give reme to put pin and stud on upper mount you might have to wiiggle engine by hand to get back in once its in lower jack mount upper and lower nuts fairly tight is ok put plastic access cover back in this keep water fom sitting a rotting frame rail the othe type of mount uses 2 14mm bolt from the top i hope this helps you email is ok g
Why when my Abs brakes get warm on a 86 Mark the the steering wheel shakes?
Sounds like your rotors need to be turned (replaced if necessary). Does the shake happen worse when braking at higher speeds? Id recommend you pull the rotors off and check for variances in thickness with a proper guage, get them turned, and go from there.
AnswerI agree. Sounds like the rotors are warpped.I've had this problem and it turned out it was a bad caliper Do any of the wheels smoke when you stop ? Do you have a strong smell from any of the wheels? I would check to see if any of the wheels are locked up or rotate harder than should be.
Where is the ecm located 1990 Lincoln mark 7?
Right side kick panel (panel under dash right side where your feet would be) Hope this helps Mark VII Heaven
How do you change the front brakes on a 1990 Lincoln mark VII?
Purchase front brake pads for a Lincoln Mark VII with ABS. Purchase DOT 3 brake fluid for a Lincoln Mark VII with ABS. Purchase a disc brake piston tool. Park the vehicle. Disconnect the battery. Raise and support the front of the vehicle. Remove the wheels. Remove 1/2 of the brake fluid from the reservoir and disguard. Remove the caliper pins. Raise and support the caliper. Remove the outer brake pad. Return the inner brake pad and piston into the caliper with a disc brake piston tool. Remove the inner pad. Install new brake pads. Fill brake fluid to correct level. Reassemble. www.TheLincolnMarkVIIClub.org NOTE: Be sure to use metallic pads - you won't get the brake dust mess on your rims.
Leak at airbag or fitting "dump valve" not closing
How do you remove top starter bolt 91 Lincoln Mark VII?
Try this: you will need a very long (or several short extensions) for a 3/8 drive rachet
and a 6 point swivel socket( NOT a socket & swivel put together)
pass the socket & extension thru the side motormount along the block coming from the
front. You will literally have to reach up & get the socket on the bolt head by feel.
be sure it's on correctly- rounding off the head would be a disaster.
Also, the small crossmember needs to be undone & swung out of the way.
starter needs to be tipped on end to remove- it's a tight fit.
I've done mine twice.
I think the flat rate book gives well under an hour labor like.6 or so.
better figure on twice that with home tools and conditions
hope this helps
How do you manually close sunroof on 1994 Lincoln Mark?
you pull down the motor cover over the back seat (pull down the front first) remove the 2 screws on the side, remove the motor. Put a pair of vise grips and turn
How do you repair the rear air bag suspension on a 1988 Lincoln Mark VII?
the 88 may be one of the years that after market Taurus struts will fit in with a conversion package to replace the air bag suspension entirely. The alternative is dealer item only, and very very expensive.
I agree that this system can be expensive BUT: Bagmasters, American Air suspension, Arnott Ind. and Strutmasters all have replacement parts for much less than the dealers. Take a look here -> http://www.lincolnsonline.com/tech/tech.html <- for all the info you could possibly want.
I agree. Go to strutmasters.com, Its cheap either way (bags or springs)and you get instructions with any thing you buy. I have put springs all around on My 1989 Mark VII and trust me its easy, while your down there you might want to go ahead and replace struts and shocks.
www.lincolnsonline.comfirst of all the 88 mark seven has a sraight axle a taurus has rear struts a mark7 has rear air springs if your problem is your back end sinks while parked a goes up when started you need to change both rear springs they take about 1 hr to install. if you can tell me what kind of problems you are experiencing i can help you. if the air sprins are over ten years old there shot just look at the rubber cracks from dryrot i also have a place in florida that has incredable prices for all you needs i could give you info if you just let me know what up i dont make a dime of this i love themk7 i had 7 of them over the years and learned the dealer charges 3000 dollars for a job you can do in one day for 500 bucks thats front and rear call my cell ill help you out 2018703339 gary northern bergen county nj ther are also special places wher wires brake that cause havoc on air suspension. i dont want a dimeHow do you charge the oil on a 1988 Lincoln Mark VII?
p.s. I might be a lot easier and less troblesome to just take it to a walmart or whatever is available and have a certified mechanic take care of that for you.
Shoot a little starting fluid into the air intake and try to start it. Sometimes it just takes a little extra to get the fuel to flow.
ADDED 04-25-06 by Guycaron: Also, consider the possibility that residue at the bottom of your fuel tank has clogged the fuel filter.
or the fuel strainer on the in tank pump, or burnt the pump out, but i know when my mark ran out of gas it took almost 3 gallons to get it back going
Where is the mass air flow sensor in a 1990 Lincoln mark VII?
mark viis are speed density based not mass air there is no sensor
Why when I turn on the headlights of my 90 mark 7 the fuel gauge and tach stop working?
Its a bad ground, but its easy to fix. By the fuse block/hood open latch (in side the car) there is a bundle of wire, find the light blue wire, cut it and connect each end to the car body. I did mine and it works. But quarter tank is now empty, rpm guage is fine... Hey check out www.lincolnsonline.com and go to the tech part, and see "dash ground fix" that's how i learned this very helpfull tip.
How do you repair your Lincoln mark vii sunroof it just stopped working?
Check all your fuses first Then I would check for power at switch with a test light With key on you should have power on one side of switch .If you have power going in next step is to check with switch activated you should have power out . If you have power in and out of switch chances are motor is bad but you should check for power at motor also.Hope this helps.
You may have a very dirty air filter. If you have a check engine light on pick up a cheap scan tool that may tell you what the problem is. Good luck
Is a 1990 Lincoln Mark 7 LSC Special Edition rare with Grey exterior with black interior?
its rare but they can be found. I have one with a grey interior. Do you want to sell it? If so, email me project97@aol.com
Thermostat location on 1997 Lincoln Mark vIII?
On 1998, 4.6 32 valve engines, the thermostat is located in the radiator to block hose. if you look directly under the power steering reservoir you should see it.
The thermostat has 3 hoses running from it. 2 are approx. 1.5" in dia. and one is approx .750" in dia. The .750" hose leads up to the coolant reservoir. and yes it is under the power steering reservoir. Access to the thermostat is from the bottom side. You will need an 8mm socket to remove the two bolts. Removal of the bottom radiator hose is mandatory.
What is the location of the MAP Sensor for a 1992 Lincoln mark vii?
On he firewall just behind the engine.
What causes oil in spark plug boots on a 1995 Lincoln mark 8?
Valve cover gaskets are leaking. The valve cover gasket has seals as well around the sparkplug openings. These seals leak and leak oil into the sparkplug wells. drl
Why does alarm sound for no reason on a 1993 Lincoln Mark VIII?
my '94 Lincoln would do that if i had raised the hood but not shut it all the way down; after about 2-5 minutes, alarm went off after i had locked up the car, but hood was not shut
Try lowerin the panel mounted in the trunk, and turning down the sensativity on the unit located on the left, as you look into the trunk. Worked for me. Good luck.
Answertake the positive battery terminal wire off and wait about 30 min. this should reset the alarm. AnswerOnce on my Lincoln my alarm kept sounding off for no apparent reason at all, what I did to solve the problem was to spray my inside door latches with WD-40. When you lock the doors and the lock sometimes pop up, you may need to lubricate the door lock latches.The electronics on the Mark VIII are extensive and they tend to get screwy after however many years you've had the car. I had the same problem, except mine was that any time I'd lock the car, the alarm would go off at random. I went to Car Tunes and had the wire grounded and the alarm system disabled. The green light still flashes, but it doesn't go off at all.
Where is the air ride suspension compressor in a 1991 Lincoln mark vii?
its on the drivers side under the hood mounted to the top of left wheel well you will see a round filter that has air lines on top, this is mounted to air compressor it keeps the moisture out of air system
Where is the air bag On-Off switch on a 2006 impala?
There is no on or off switch because the vehicle has more than one row of seats. It may have a sensor that shuts off the passenger side front airbag if the occupant is to short or does not weigh enough.
