0
Plymouth Breeze
The Plymouth Breeze was a four-door sedan manufactured by Chrysler Corporation from 1996 to 2002. The car is easily identifiable by its distinct ridged taillights that integrated the turn and reverse signals into it.
529 Questions
What are the Fuel pressure specifications on a 96 Plymouth breeze?
Fuel. Pressure. 96 Plymouth. Breeze
Check fuse #8. Its the ignition fuse. If this is the problem, your gauges won't work either when you turn the key on.
What is check engine code 31 on a 1997 Plymouth breeze?
It is...
31- Bad Evapotator purge solenoid circuit or driver
How do you remove door panel to replace outside mirror on 1998 Plymouth Breeze?
Tools needed: small flat head screwdriver, #2 Phillips screwdriver, window crank clip removal tool, ratchet with 8mm? deep well socket.
If you have crank window:
First with door open, use window clip removal tool (be careful clip is not lost).
With small flathead screwdriver, carefully remove speaker grill by gently prying around outside edges.
remove 3 screws in pockets around speaker (not speaker screws).
remove screw under covers in door pull and inside door lever cup.
Remove screw at front of door panel near hinge.
Gently pull door panel, starting at bottom, working around to the back of door to top, lift from bottom. Top is held in channel.
After inside door panel is off/removed, remove two screws holding black plastic cover on inside of door, back side of mirror (cover should fall off).
Remove three body plugs from under panel and plastic cover.
With 8mm? deep well socket remove three nuts from back of mirror, make sure to support mirror while removing nuts.
that's it, reverse to install new mirror.
I have not removed door panel from car with electric locks or windows, but I guess most of these instructions will be the same.
Power Window Instructions are exactly the same with the exception of the window clip removal tool is NOT required. I just completed my mirror installation and everything works great. Thanks for the help. Deno
What it means when the battery light stays on inside of your 1998 Plymouth breeze?
Does you car starts??? if no that means your battery doesnt have enough adequate power...there are 2 things... your battery maybe damaged or your alternator is damaged causing not charging up the battery..but if your car starts..try to reset your computer by unplugging the negative battery then turn the ignition on for 20 seconds then plug the negative battery back..now check if you still have the battery lights on..cheers..
What fuses for Plymouth Breeze?
Pull out the bad fuse. Take the fuse with you to your local parts store and compare the fuse in your hand with the ones available for sale. Make sure to check size, not just amperage. There are 2 different sizes of 20 amp fuse out there. A 1999 takes the smaller fuses.
Is there an access panel to the fuel pump on a 1999 Plymouth Breeze or do you have to drop the tank?
Not likely, as very few cars have an access panel. Honda for one does. Look and see.
You migth need to replace spark plugs and maybe even wires and coil...
Why does the steering wheel shake while im driving?
lose bolt no seriously its probly your alinement is off
How do you change the battery of a 2000 Plymouth breeze?
You take off the left front wheel and housing. It isn't under the hood.
Your passenger side front window wont go down in your 2000 Plymouth breeze what could it be?
had same problem; check switch on driver side ., if it operates the passenger side ok, then just replace the driver side window switch .. $20 part from the dealer.
How do you change the spark plugs on a 1997 Plymouth Breeze?
Answer:
On the 2.4L engine, the 4 spark plugs are through the valve cover on top of the engine. You will need a deep 5/8" spark plug socket and a 6" to 8" extension. The socket should have a rubber liner inside to hold the plug when you extract the old one and insert the new one. The rubber also helps align and isolate the ceramic part of the plug from the metal socket wall which minimizes the risk of breaking a plug. On this engine and with original wires it's hard (nearly impossible) to mix them up but it's good practice to replace one plug at a time. So for example, working from left to right, pull the boot of the wire from the first plug (don't pull by the wire itself), insert the socket with the extension attached into the hole and make sure it is firmly seated over the head of the spark plug at the bottom and turn counter clockwise using a ratchet wrench. As resistance lessens keep turning but also pull up slightly on the extension until the plug is completely free then remove it from the socket. Adjust the gap the new plug to .05", push it into the socket and reinsert by reversing the process. You may encounter moderate resistance caused by dried oil or dirt so make sure to get past this point so that the plug is fully inserted but do not over-tighten or you risk breaking the spark plug.. Firmly reconnect the plug boot (wire) and move on to the next.
If you find that one plug is noticeably more soiled than the others then likely you will need to change your ignition (spark plug) wires also. Even if only 1 is defective the whole set should be replaced.
btw) It is important to remove anything small and loose from the engine area while you work to lessen the possibility of dropping something in the spark plug hole when the plug is removed.
If it is a V6, you will have to remove the upper intake manifold to access the rear 3 plugs.
What type of oil is used in the 1997 Plymouth breeze?
SAE 10w30 is a good all around choice. Possibly 5w30 in extremely cold climates.
There are many possibilities, the only way to know for certain is to use a code scanner. A 98 might be able to connect to an "OBDII" code reader. You can probably borrow, rent or buy one from a local auto parts retailer. If you borrow one you can figure out what's wrong and buy the parts right on the spot. Often it's something as simple as an Oxygen sensor. Whatever it is, the computer already thinks something is wrong and that is why the light is on.
What has happened if the power window doesn't go back up on a 98 Breeze?
When that happened to our Breeze, we changed the fuse, now we have one that wont go down, its the motor of the power window. I HATE THIS CAR, anyone out there wanting to buy a Breeze DONT DO IT!!!!!!!!!!!!!!
How do you reset the fuel shutoff of a 1996 Plymouth breeze?
Look in your trunk.
Answer:
It doesn't have a shut-off switch. The fuel system is computer controlled with relays.
If you look in the trunk just behind the passenger side of the back seat, in some cases you'll have to pull back the rug ,some,but there's an electrical connector there,with a good size grommet ,the wires to that connector go to the fuel pump and filter,just below,if you could push that grommet though you could see the fuel tank. just be careful not to push the wires and connector all the way through,the car side of the connector is connected to the power distribution center.
What is the problem when the parking lights on your 1989 Subaru GL wagon will not turn off?
chek the switch on top of steering column
How do you replace the headlight bulb located on a 1998 Plymouth Breeze?
Honestly, just look in your User's Manual, if you can't find it: all you need to do is take out 2 really long screws that screw into the top of the headlight, and then slide the headlight forward onto the bumper, and the headlight pulls out from the back. This is one of the most insanely dumb engineered vehicles that I've seen. You have to take the wheel off to replace the battery?!?
Where is the fuel filter located and how do you replace it on a 1998 Plymouth Breeze?
One of three spots. First, right behind the gas tank. Second, -IN- the gas tank (have a professional do it if that's the case, you'll save yourself money in extra repairs and alot of headache), and third is on the driver side frame near front door.
Answerautozone.com has online manuals that give step by step how to AnswerAccording to my Haynes manual, the inline fuel filter is mounted on the frame above the rear of the fuel tank near the filter neck. Replacement is no 5 min. job, since it involves draining the gas tank. Best done by a garage, but if you're determined (and very careful) you can get the manual for about $20.00 at most auto parts stores like Napa. If not in stock, they'll order one for you. The instructions for this job are detailed quite well in the manual, and they warn you about any hazards involved.How do you remove a starter on a 97 Plymouth Breeze?
I just replaced a starter on my daughter's 98 Plymouth breeze. It was upfront and very easy to do. Unscrew the bolts holding the starter. Make sure that you have your positive cable off of your battery. Unplug what I call the alligator clip from the old one and slip onto the new starter and screw the bolts back on the new starter and hookup the positive cable and crank the car. I am a female and I found it took me about 45 min to do and I am by no means a mechanic.
How do you drain antifreeze from 1997 Plymouth Breeze?
Open the drain plug on the bottom of the radiator.
How do you change a front wheel bearing on a 1998 Plymouth Breeze?
its a lenghthy job , first remove tire and unbolt and move the brake caliper out of your way, then unbolt the CV shaft nut and remove washer. Now for the fun part remove rotor so you can see wheel bearing case. Proceed to heat the bearing casing and bolt with a torch till it is red hot, then break the n
bolts loose with your 11mm socket, the CV shaft will need to be pushed back far enough to get the socket on straight and take care not to strip the heads of the bolt. The wheel bearing comes off as a unit with the hub. replace with new one and put everything back together in reverse order.
How do you replace the alternator on a Plymouth Breeze?
You have to loosen the tensioner (located near the alternator) then slip the belt off. Disconnect the neg battery terminal. Remove the bolts attaching the alternator to the tensioner and the bolt attaching the alternator the car. Then detach the electrical connector from the alternator.
