0
Toyota 4Runner
The 4Runner is a mid-size sport utility vehicle (SUV) produced by Toyota Motor Corporation since 1984. This SUV is offered in four-wheel drive (4WD) and rear-wheel drive (RWD) layouts.
3,192 Questions
Where is the evap canister located on 2005 Toyota 4Runner?
It's in the rear just above the spare tire. You will need to lower the spare to get access to it
How to take srs light off 2004 Toyota solara?
SRS means 'Supplemental Restraing System' and if the light is on it means your airbag system has flunked the self test. There are many reasons this can happen ranging from a faulty car battery to being in an accident (full list below).
I'm going to guess you mean "how do you turn the srs light off" rather than "take" it off. It's fairly easy. Visit an auto supply store that will loan you an OBD II reader, It's an electronic gadget that plugs into the OBD II port under the dashboard (to the right of the steering column). Most readers have a 'reset' button that will erase trouble codes and turn the light off. BUT FIRST, check the code to see what the problem is with your SRS system. Turning the light off without fixing the problem is fruitless because the light will just come back on again.
Keep in mind, your airbag system is turned off when that fault light is on so if you're in an accident the bags won't deploy. Maybe you don't care about yourself and are willing to put a piece of tape over the light and forget about it but the lives of passengers could be at stake here too, so fix the problem.
Here's a partial list of reasons the SRS light could be on. The OBD II reader might zero in on one of these or offer another suggestion.
- Letting battery drain too low
- Bad Sensor
- Blown fuse
- Unplugging the car's battery
- Removing the gauge cluster/installing aftermarket gauges
- G-Force sensors that are under each of the front fenders ($250.00 each)
- Bad ECU
- Car was in an accident
- Airbag defective/unplugged
Why would a 1990 Chevy S10 parking brake sensor flash even though the parking brake is off?
You might have an ABS problem or a problem with the brake master cylinder. Check the fluid level in the brake reservoir.
You need a new transmision, your gears are shot.
How do you disarm a 1989 Toyota Cressida alarm?
use the ignition key to turn to on or to start and the system should reset. I stopped using mine because it would trigger at any time wothout an intrusion
Where is the automatic transmission fluid filler on a 1997 Toyota 4runner?
Same place you check the fluid level.
How do you replace a relay switch on passenger window of 1994 Dodge Stealth?
Go to this site it should show you where its located. Oh and you can download the whole manual on how to check from front to back of your stealth. yeah i just found it my self on the net. It was free. Other on eBay charge like 10 for the CD when you can down load it for free.
AnswerGo to this site it should show you where its located. Oh and you can download the whole manual on how to check from front to back of your stealth. yeah i just found it my self on the net. It was free. Other on eBay charge like 10 for the CD when you can down load it for free.http://www.ecanfix.com/users/manualcd/gift/3s/powerwindow_doorlock_wiring.pdfI have a Gas scooter xg 499 and i broke the pull starter how do you install a new one?
buy one off the internet: it should have instructions about how to install.
What size speakers fit in your 1990 Toyota 4runner?
4" in the dash and 5.25" in the rear panels, rumor has it that you can fit up to a 6.5" in those rear panels or a 6x9" with some trimming.
What size wiper blades for 2003-2009 Toyota 4 runner?
All 2003-2009 Toyota 4 Runners take 22" driver side and 20" passenger side replacement windshield wiper blades on the front. You can get aftermarket front wipers, however the rear is dealer-only although an aftermarket rear blade will be coming out in June or July 2010.
What is the maximum towing capacity of the 2003 Toyota 4Runner?
The maximum tosing capacity of the 2003 Toyota 4Runner is 5000 lbs..
How do you put the tension pulley on?
First is you have to releive the tension and take off the belt. What ever side the tension is on from the belt that's the way it will need to go to give the belt slack to be removed. When you go to release the Tensionor back it will go further then it was before so what ever your using to unspring it (long wrench, Ratchet and socket, or tensionor tool) may get wedged.
If you are replacing the whole tensionor then you need to remove the bolt through the center of the tensionor pulley. On the back side of the tensionor is a little tip (about the size of a new eraser on the end of a pencil) that sets in a spot on the surface it bolts too. You'll need to put the new tensionor back in that spot. Thighten the bolt down snug.
If you just need the pulley itself off the tensionor then just take the bolt out that is through it. Put new one on and tighten up snug. Make sure it spins fairly free when your down. If you overtighten (create excessive drag) it it will wear out the new pulley fast and possiblly lock up when the bearing inside fails and cause your belt to break cause it doesn't spin anymore.
Where is the ECU located in a Toyota 4Runner?
it is located inside the truck on the passenger side behind the removabe kick panel.
Where do you put the transmission fluid or oil on a 1998 Toyota 4Runner?
You put the Transmission Fluid in the Transmission (fill point transmission drip stick tube) and the Oil (fill point Oil Cap) in the Engine.
Hope This Helps.
Can the engine coolant contaminate the transmission on a 1999 Toyota four runner?
Yes. The transmission fluid is cooled by a separate set of cooling lines in the radiator that cools your engine. If the radiator has an internal leak, cross-contamination may indeed occur. Only a little amount of engine coolant in your transmission can cause a transmission malfunction.
How do you replace the front turn signal bulb located on a 2000 Toyota 4Runner?
How tall is the 2011 Toyota 4Runner?
The height of the 2011 Toyota 4Runner is 5 ft. 11.5 in. (71.5 in.).
What is the basic warranty on the 2009 Toyota 4Runner?
The 2009 Toyota 4Runner has a 3 yr./ 36000 mi. basic warranty.
Where can you find an engine for a 1998 Toyota 4Runner?
Where do you live? In Florida and Idaho I had several shops that sold them. Cheap you can try the local wrecking yards. Especial the pull and pay yards. Not want that route then there are several national engine rebuilders selling rebuilt engines. Just google it.
Lastly I would check with local machine shops and see about rebuilding yours.
Motor oil for 4runner 3L 1991?
Yes motor has oil. See the question is vague. So in hopes I can pinpoint the answer don't be surprised if I miss the mark. Just send a clearer question. The engine will take 5 quarts of oil. at oil change. You will need to change the filter and the oil at the same time every 3000 miles 5000 max. The type can vary with where you live. cooler climates a 10-40 is good. warmer climates I prefer a 20-40 or 30 weight. Synthetic blend is great but in an older engine it can cause the older seals to leak. The oil is thinner or slippier or flows better so slips through the minute gaps that regular oils don't. Lots of online inf about that. I like Mobile oil myself or Valvoline. My dad used it and when we would overhaul our engines after 250000 miles they were still clean looking inside and the cylinder walls didn't need machining for the overhaul. I know guys that think me a fool and recommend castrol only. The reports are good about it and I would use it if I couldn't find the other. Hope I caught it.
Where is the overdrive cancel switch on 2008 Toyota 4runner v8 limited located?
There is no "switch". To cancel overdrive move the gear lever from "D" to "4".
Is it difficult to replace the front shocks on a 1998 Dodge Stratus?
It doesn't have shocks, it has struts. Yes it is a very difficult and possibly dangerous job, that is best left up to the experts.
the "DUD: that left the reply up here needs to be banned.
improved error here:
not really a difficult task. time TOOLS and a little know HOW.
TIME about 1-2 hours depending on your tools ans expertise( along with your garage set up.)
TOOLS.. tire remover, standard sockets and wrenches, and spring compressors.
how to:
1. jack car and open hood.
2. remove tire.
3. under hood "loosen" the NUT holding the top of the strut.
4. remove the nuts/ bolts holding the bottom of the strut.
styles differ here, so the description is vague. SORRY.
(could also be a structure to remove)
5. remove the assembly from the car.
6. apply the spring compressors to the spring and compress evenly.
7. finish removing the NUT loosened in step 3, remove the strut from the center of the coil spring.
order the pieces for reconstruction, for later
8. make NOTE of the location of the pieces, sometimes there is a particular direction the parts need to be in for best results.. ( see 99 grand am)
9. re assemble in reverse order, with exception to the NUT. feel free to snug it up as tight as possible during "exterior" assembly.
10, now that you have re assembled the shock/ coil spring/ and top half of the parts and dust cover. put it back in the car and finish assembly.
11. double check your work.
12. attache your tire and remove JACK. torque your wheel to correct foot pounds. about 100.
SEE YA.
How do you lower the rear seats in a 1996 Suzuki Vitara?
On the outside top edge of each back seat there is a knob which needs to be pulled upwards to release the lock. Similarly once in the 'down' position you need to pull the knob to release the lock. On the outside top edge of each back seat there is a knob which needs to be pulled upwards to release the lock. Similarly once in the 'down' position you need to pull the knob to release the lock.
