0
VW Jetta
The VW Jetta is a compact car manufactured by Volkswagen since 1979. As of 2006, the company sold more than 6.6 million Jetta models worldwide, one-third of which was from the US.
5,220 Questions
Does the 2013 VW Jetta-Sportwagen include free maintenance?
The 2013 Volkswagen Jetta-Sportwagen has free maintenance for 3 yr./ 36000 mi..
hold open your door handle and push the lock back in to place where the jaws clamp on to the door post
How do you change struts on a 2001 Jetta GLX VR6?
For front struts: Jack up your car and secure it on jackstands and get underneath the car and look to see where the lower part of the stut bolts behind the rotor. take out that bolt and then go to the top of the strut tower (in engine bay) and take off those nuts( its best to use an impact wrench to take these on and off. Or go buy the special strut tool. After that bolt is out you should be able to maneuver the strut out of place. Repeat that for the other side.
For Rear Struts: Make sure your cars jacked up in the back and secured on jackstands. Then pop your trunk and you will have to move the carpet out of the way to get at the rear stut towers. Do the same thing as in the first by going under the car and taking out that bolt in the strut mount. Then go to the top and take out that bolt for the top strut mount. Maneuver strut out of place. Repeat for other side as well.
For removing springs from struts: USE EXTREME CAUTION WHEN REMOVING SPRINGS!!!!!! You will need to either go to your local auto parts store and rent a spring compressor. Or what i would recommend is take the whole strut and spring assembly to a local auto garage and have them remove them since they are experienced. Have them put your springs on your new struts as well while you are there. it shouldn't cost much money and you will be sure it was done correctly.
Installation is the reverse of Removal. Mkae sure you torque the bolts to the specified amount. Im not sure what it is, maybe like 35-40 ft/lbs. don't quote me on that though.
- I am not responsible for anything you do regarding this post. This is what i did to replace my springs. If anything goes wrong while you are attempting to do this its not my fault.***
There is a recall on the heated seats in the jetta for that particular reason. contact your dealer asap.
1998 navigator instrustrument cluster and ac cluster not working?
My dash lights went out and the cause was a bad alternator. new alternator fixed the problem
How do you reset the check engine light in a 1996 Pontiac Bonneville?
Disconnect the positive battery cable from the battery, and hook it back up. This should reset the internal cpu, if the problem still exists the light will come back on after about 50-100 miles of drive time.
What is the drag coefficient of the 2013 Volkswagen Jetta-GLI?
The 2013 Volkswagen Jetta-GLI has a drag coefficient of .30 Cd.
How wide is the 2014 VW Jetta-GLI?
The 2014 Volkswagen Jetta-GLI is 5 ft. 10 in. (70 in.)12V front and 12V rear power outlet(s) wide.
How do you clean the Mass Air Flow Sensor on a 2000 Lincoln Continental?
If a non hotwire sensor buy a can of CRC MAF cleaner and follow directions.
If a 2002 Jeep Wrangler will not start when it rains but does crank what could be wrong?
the possile cause could be spark plug wires , especially the coil wire. They frequently get wet where the coil wire attaches to the coil. New wire should help.
The spark plug wires may be cracked and hold moisture when it rains. Replacing them may solve this problem.
You can also spray the wires and inside of the distributor cap with WD40... That will drive all the moisture out.
Just like the above stated, it easily could be the distributor cap. Every time I go in water crossings, mud, or even wash my jeep, water gets in my distributor cap. I usually just unscrew the two Phillips head screws and wipe it dry with a rag, or spray it with WD40 and wipe dry. Should start right up.
How do you remove an airlock in the fuel line of a VW Jetta 2004?
put 4 or 5 wooden clothes pins on the fuel line just before the carburator.
How do you adjust front seat in 1990 vw jetta?
there are controlls located on the right dide of the seat under the front that allows you to move back and fourth, there's a wheel adjuster on the right back side that andusts the back of the seat and under the front lefs adjusts the tilt
It means you need a service aka...Oil change probably...I had the same light on and called my mechanic and that is what they said.
Is 2001 vw polo 1.4 engine damaged by cambelt failure?
yes engine damage will occur should the timing belt snap in service
Where is the OBD connector on a volkswagen jetta 2002?
The 2002 Volkswagon Jetta OBD 2 port is under dash at left side
What is the spark plug gap for a Jetta?
Open and read your owner's manual to find this information, Can also be found under the hood on a placard.
it is not in the owners manual for my 1998 jetta nor is it on any placard or sticker on the car. if you don't know just keep your dumb answers to yourself.
Why does a 1996 dodge stratus make a knocking noise when in reverse?
Where is the noise coming from? If its from the fenders or wheels is a much different problem than if its coming from the transaxle.
How do you remove bulb from Lexus rx300 low beam socket I can't get it out of the socket?
Turn black holder an 1/8 of a turn (pretty tight!) and then it will come off. Then you twist the wire off of it about an 1/8 of a turn. Then there are two wire clips that need to be unsnapped to remove the bulb.
How do you reset the check engine light on a 1994 Ford Probe?
For the 1994, you have to remove the negative battery cable, then depress the brake and hold it in for 5 seconds to reset the check engine light.
What kind of fuel does the 2013 Volkswagen Jetta-Sportwagen use?
The 2013 Volkswagen Jetta-Sportwagen runs on regular unleaded.
How do you adjust the clutch cable in a 1991 Jetta?
if your problem is a sloppy pedal......... then you probably need to bleed the slave cylinder, not adjust the clutch cable.
As you correctly point out, this is a cable, not hydraulic, system. The adjustment is on the top of the transmission, towards the front of the car, between the motor and the battery. IT is usually a big black "cable" leading into a 3" while plastic adjustment mechanism, before the actual cable itself exits and heads to the clutch release arm.
In this case, you need 2 wrenches (13mm as I recall) and need to turn the white plastic bits until the clutch cable snugs up a bit.
