0
VW Vanagon
The VW Vanagon was a Transporter model manufactured by Volkswagen from May 1979 to July 1992. Some of the features of this vehicle are power steering, power door locks and a tachometer.
495 Questions
How do you get defrost to work on 1982 vw vanagon?
There is a switch on the right side of the instrument cluster near the hazard (4-way) switch. If that doesn't work check the fuse. If that is not the problem check the connectors at the rear window. There are testing procedures for testing the heating elements, they may not be working.
Where is the turn signal flasher located on a 1994 Chevy Silverado?
the switch is in the steering colum you will have to remove the steering wheel to acess it. the flasher fuse is round shaped about the size of a quarter in the fues panel under dash
The top of the master cylinder is filled with brake fluid (resevoir)
Where are the turn signal flasher and emergency flasher located on a 1988 CRX SI?
located on fuse box under dash
How do you remove and replace the ignition switch in a 1994 Explorer?
To change out the ignition switch (key lock): I found you can follow the instructions in Haynes, autozone.com, etc. up to the point of the release pin. Instead of approaching from the bottom with the punch or awl - you won't find any hole, you need about 8 - 10 inches of wire like bailing wire (stiff, about 3/32" diameter). Look down from above at the key/lock housing. At about the middle of the housing you will see a cylindrical shape in the housing that will be pointing toward the driver's seat. This contains the channel to reach the release pin. You will be able to see (still looking from above) a rectangular slot where you can reach the channel. Take the wire and bend in a "L" shape with a gentle arch so the shortest end has about 1 1/2" straight wire. Insert the short end in the opening to find the pin and push it in to release the lock mechanism. I have a 94 Ford Ranger XLT v6 4L that this description fits exactly!! I even took my old door key with the new ignition key to a locksmith and had them finish cutting the new ignition key for the old door locks. Total costs for me to do the change ~$35.00 the local Ford dealership wanted $325.00. Total time including install, buying part, getting keys cut 1.5 hours. This site is great!
Where is the signal flasher located on a 2000 intrepid?
FRONT SEATING AREA, DRIVER SIDE, UNDER LEFT HAND SIDE OF INSTRUMENT PANEL BETWEEN JUNCTION BLOCK AND BRAKE PEDAL.
Where is the turn signal flasher located on a 1997 Ford 150 econo van?
Under the dash board under the steering column. The left side wall next to the break look up under there. There should be a fuse box and near it should be the flasher. silver cylinder about 1 " long Hope this helps.
Where is the turn signal flasher located on a 1997 Chevy Malibu?
I believe that one in under the dash on top of or along the steering column.
Where is the turn signal flasher located on a 1995 Chevy S10?
The turn signal and hazard flashers are located on the bottom right hand side of the driver's side dash below steering column, to the left side of the ashtray. Take out the three screws and pull down. The hazard flasher is on the left and the blinker flasher is on the right.
.....I found that it was more then three screws but it was where the above stated it was.
.....You may not be able to get the whole dash down, I just bent it down enough to get my arm in there and put the new flasher in... good luck but it fixed my problem so i was happy
I had the same problem, but after asking everyone I knew, I found the answer online. The above is correct, but to make it easier to get to the flasher, you may want to take out the ashtray and remove the screw that was hidden by the ashtray. This will make it a little easier to spread the dash apart to get to the flasher.
Where is the turn signal flasher in the 1997 jimmy?
I answered a similar question about fixing the flasher, so I'll pearoast a slightly modified version of it here. It will answer your question, too. By "changing the flasher", I am assuming you mean the emergency flasher switch, or the turn signal switch. In either case, it is an integrated unit, along with cruise control (if you have it) on the steering column. Fixing it, in this case, means replacing it. Your best bet is to buy a replacement from a junkyard. When I did mine, I had to buy an entire steering column and take the unit from that; the yard wouldn't sell me the signal unit alone. Even then, it only cost me $80 - a bargain. The process isn't hard, but I couldn't explain it well enough to do it justice. It boils down to basically this: 1) Disconnect the battery and remove the airbag fuse. 2) Remove the airbag from the steering wheel. (Be careful!) 3) Remove the steering wheel and drop it from it's mounting bolts. 4) Remove the plastic housing. 5) Disconnect the signal unit and mount the new one. 6) Put it back the way you found it. I PROBABLY MISSED A STEP OR TWO! Get a good manual (I use Haynes) and read it thoroughly before starting a project like this. Good luck to you! Mr. Dog
Where is the turn signal flasher on a 1997 Ford Crown Victoria?
there is no flasher! well not in the since you think. all the lighting goes there a lighting control module, (lcm). its a black box about 4 by 7 inches and is located under the drivers side dash towards the radio area.
Where is the turn signal flasher located at on a 1993 Buick Skylark?
I am not 100% shure wear it is but am almost positive it is located above the fuse box under the left hand side of the steering wheele
Where is the turn signal flasher in a 1997 Sebring Coupe LXI?
the flasher unit is under the dashboard...kust to the right of the brake pedal...its a little black plug in box. you'll have to remove the panel under the dash to reach it...but once done...it unplugs easily
Where is Turn signal flasher on ford 2003 pu?
Unknown if towing a trailer,disconnect before test.Check turn signal's on truck alone. If problem continues,check turn signal lamp(s) and socket(s),adjoining connectors wires/pigtails (blown,broken,burnt,corroded).Rapid or no flashing can be result of these defects.Let's look for now your turn signal relay switch as you requested, replace, then retest.F-150's have small fuse panel(about hand size)lower left side of dashboard. F-250's on up,use a flat screwdriver and remove the panel.(Four pastic screw fasteners 1/4 turn counterclockwise)Check for blown fuses.Early model trucks had flasher units (looks like a small can)on the fuse block or very near to it.Some models in the car and truck lines also had signal and/or four-way flashers under the dashboard/instrument panel along the wiring harness sometimes under the dash along the firewall itself. If found, replace,retest. Still problem? then go to beginning on lamp/socket. Also,there is a power distribution panel under the hood.This will be checked later for the trailer problem. (usually on the driver side fenderwell,black box about 2"x 8" in dimension)With fuses/relays.We'll get back to this later. The turn signal lever also has a module built in itself on the steering column. Notice we are starting from the cheapest route then go up. If possible,check wire harness to signals for breaks etc. Repair if needed, then retest.Still problem,replace turn signal switch module. If a trailer is used being the problem,check trailer plug and socket for full installation.Sometimes you have to work the plug to clean the contacts to get good connection due to dirt,corrosion etc.Also socket/pigtail going to harness Clean if needed,replace broken parts. then reinstall and retest. If trailer is encountering lighting/signal problems,truck lights/signals can possibly still operate normally. Trailer power comes from a relay in the power distribution box. Replace relay,retest.Still problem? it's on the trailer.
Where is the turn signal flasher located on a 2000 Toyota 4 runner limited?
right by the oil filter you should see a gold color one wire sensor.
How do you remove a starter on a 2000 cavalier?
Note:It may be necessary to remove the exhaust pipe(s) or frame crossmember to gain access to the starter.In extreme cases it may be necessary to unbolt the mounts and raise the engine slightly to get starter out
- Disconnect the negative battery cable.If the vehicle is equipped with a delco loc 2 or theftlock audio system make sure to have the activation code before disconnecting the battery.
- Raise the front of the car and support it securely on jackstands.Apply the parking brake and block the rear wheels.
- On 2.2L engines with manual transaxle remove the brace between the engine and the transaxle.On 2.3L and 2.4L OHC engines remove the air intake ducts to gain access to the top starter motor bolt locatedon the transaxle
- Remove the mounting bolts and detach the starter.Note the location of the spacer shims they must be reinstalled in the same position (if used)
- Working under the car clearly label then disconnect the wires from the terminals on the starter motor and solenoid
Where is the turn signal flasher located on a 1997 Crown Vic?
Should be in the fuse panel inside the car on the brake pedal side.
Where is the turn signal flasher on a 2004 Impala?
The turn signal flasher is combined with the hazzard switch. It is connected to the back of the hazzard switch.
How to remove a starter from a 1999 Kia Sephia?
http://www.kiatechinfo.com/ it's free to register and has tons of info on any kia look under the "shop" link to get your answers in Set by set pictures
Where is the turn signal hazard flasher located on a 2004 ford ranger truck?
The 2004 Ford Ranger pickup truck signal hazard flasher unit can be found beneath the drivers side dashboard. The signal hazard flasher unit will be above the brake pedal.
