Where is the number one cylinder on a 3.1 Chevy?
in back of engine by the alternater. 1-3-5 is in back 2-4-6 is in front!!
How do you change the thermostat sensor on a 2001 Chevy cavalier?
how do you change a thermostat sensor in a 2001 Chevy cavalier and where is it
How do you replace a driver's side mirror on a 1994 Chevrolet Cavalier?
Where is the PCV Valve located on a '99 Chevy Cavalier?
The PCV valve is attached to the intake by a hose and is located in the valve cover held by a plastic retainer on the passenger side of the engine near the power steering reservoir.
Where is the air temperature sensor on a 1990 Chevy cavalier?
They were not use on that year. It don't have one.
Why are you not getting heat 95 cavalier replaced heater core no different?
Well First is the blower motor working if not probably good reason why very little heat is coming out but some would come out. Also you might want to check the thermostat if the thermostat is stuck open you would be getting some heat if stuck closed heat would not be the best.
If blower motor is bad short term fix is to just get a hammer and give it a whack on the bower motor b/c there is a motor ..... and brushes need to connect to the motor to complete the circut if the brushes get clogged then the blower motor will not work properly.
The thermostat should be on the (looking at the car from the front) on the right hand side coming from the rad.(raditor) Into the engine block. should look like a bubble at the end of the hose.
Ps. I really hopes this helps its hard to diag. problems with out actually looking at the car
Why do your Chevy Cavalier driving lights flash and go out when put in gear?
Your highbeam is dead, which means your DRL's cannot funtion. Your DRL's run off of your highbeams at about 1/2 the voltage...
The old "hot wire" routine only works on ignition systems that use points. I suggest that your efforts may have caused more serious problems with a solid-state ignition system.
What are the stock speaker sizes for a 98 accord?
If it is the rear speaker it is 9 x 6 Ovals for the Honda accord coupe 98. should be similar for the sedan.
Where is the low pressure AC port located on a 2000 VW Beetle?
Low pressure side is on the front passenger side towards the right (driver's side)of the engine bay. you will find it on the front towrds the radiator. VW A/C systems are delicate so be sure not to over fill with too much freon.
Oil capacity 2003 Chevrolet Cavalier?
The 2.2L Ecotec, which takes 5 quarts. It may depend on your engine type so the best way to check for your car is to look in the index of your owner's manual under 'capacities" and the corresponding page will tell you.
2001 cvhevy impala ac fan motor not working?
You could have a bad blower motor or there is a resistor inside the blower motor housing which is located under the glove box on passenger side of car (where your feet would go) That could be your problem.
Does a 1992 Chevy Cavalier have a camshaft?
yes it does and depending on the engine some have more then one
Where is the low pressure port on a 98 Chevy Malibu?
Follow lines from compressor-Larger line is low pressure--port may be at or around the accumulator/drier by passenger firewall
Why does your front wheels shake while driving?
Tires out of balance, belt in tire has slipped, ie defective tire, bent wheel, loose lug nuts, loose or worn bearings. Check lug nuts and tighten to the proper torque. Have the tires rotated and balanced. Inspect the suspension and all stering parts. Have you used "fix a flat" ? if yes, You have 2-lbs of water inside your tire now. it cost me 70 bucks to find out and this stuff easts chrom weels. Go to alignment shop and tell them to jack up ur car and they use a special machine to turn the back wheels one by one to find out which one is out of ballance ( dont let them take the wheels off and ballance them since they balance tires and speed lower than 50mph and usually stuff happens around 55 to 60mph. for front tires u can just jack up one wheel at a time and put the car in drive and accelerate one wheel is on the ground and the one you jacked up turns and u ask some one to look at the wheel see if it shakes ( it shakes really bad if water inside the tire) do the same of other front wheel. But for back wheels u need that special machine which alignment shops have and all these machines do they turn the wheel up to 130 mph to see if it shakes or not.
How do you replace the head gasket located on a 1996 Cadillac Eldorado?
HeyMar==This is a pretty good job. Get a manual from the parts store and it will tell you how. GoodluckJoe
Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
It's located under the steering column. Remove the trim panel beneath the steering column (3 screws) and gently lower trim piece (it's not necessary to remove). Look for the canister-looking silver flasher to the left of the steering column. It's easy to find. Good luck!
Is a 1997 dodge avenger 2.5L v6 an interference motor?
Unfortunately is sounds like its an interference motor. I found one cheap but the belt broke so Im not going to get it now.
http://www.dodgetalk.com/forums/showthread.php?t=9533
overdrive clutch in trans not unlocking on decelleration Bad Torque Converter Clutch solenoid. About $50 to replace at the local auto tranny shop.
You need instructions on how to replace the headlight bulb on a 1994 F150 pickup year 1994?
Check out the enclosed instruction book.
Why would your 1989 Chevy cavalier rs stall while driving?
its probably a computer issue or an electrical issue some where in the car
i had the same problem with my car and it was computer
What is the stock speaker size for a 2004 Chevy Malibu?
The 2004 Chevy Malibu dashboard speakers measure 3.5 inches in diameter. The door speakers measure four inches by five inches. The rear speakers measure four inches by five inches.
Where is the horn located on a 96 Chevrolet Cavalier?
On the front right hand side below the bumper. More precisely, it is behind the right front wheel well covering. The wheel well covering is in sections, only the very front section needs to be removed. About a dozen 3/8" screws secure it around the leading edge and under the bumper. A 10 mm nut holds the horn to its mounting bracket/ground.