answersLogoWhite

0

Buick Skylark

This category covers questions about the Buick Skylark, a passenger car manufactured by General Motors and sold through its Buick division. The Skylark was in production from 1953-1998. The Skylark was never succeeded by another model.

856 Questions

Why is vent not switching from heater to defroster to bi level on Buick skylark?

It depends on the year of the Buick. Most of the newer Buicks use an electric actuator to change the vent door positions. If that's the case with yours you have a problem with wiring or a faulty actuator or switch.

If yours is one of the vacuum controled heater boxes you probably have a leaky vacuum line or diaphragm.

How do you remove the front door panel on a 1996 Buick Skylark in order to change the speakers?

Not entirely sure. I think you have to buy a special tool that is designed for separating body panels. They are usually held on with plastic rivets that will release if pressure is applied outward near the rivets. That said, you can just remove the speaker grill in most cases. Push a side of the grill toward the center, and pull outward. They are held in place by retaining clips in an X pattern, so work from an area that's within the X

How do you change the horn on a 1996 Buick Skylark?

Remove the plastic cover over the drivers side headlights, then remove the headlight assembly(driver side only). The horn is directly underneath it - fairly easy to access, remove, replace, whatever you need to do. I replaced mine in no time.

How do you remove the rear speakers on a 1991 Buick Skylark?

You need to do a lot if it is like my 1995.

You need to remove the back seat

remove the back of the back seat

remove the screws holding the rear deck.. where the speakers are.

then remove the screwss...

what a pain.

How do you replace the alternator on a 1995 Toyota Celica ST?

Answer

There are three bolts involved. The top bolt located closest to the engine is your Pivot bolt. Loosen that bolt so the alternator will pivot downward when you unlock it. Speaking of unlocking, there is another bolt located on the bottom of the alternator, loosen and remove this bolt. Finally, on the front of the alternator there is a tension adjustment bolt. Loosen that until the belt clears the pulley so that you can remove it. You don't have to remove the tension bolt, just loosen it. Once the belt is removed make sure to disconnect any wire/plugs, etc from the alternator, remove the pivot bolt and viola! Installation is the reversal.

How do you change the old metal wiper blade on a 1991 buick skylark?

Brute force. You may have to get some pliers and tear them off, but be careful to only damage the blade or you may not be able to get replacement blades attached properly.

Where is the electronic control module located on a 1993 buick skylark custom with a 3.3 engine?

I am no expert but I believe you will find the ECM on the front left side of the engine, in front of the alternator. The ignition coil sits on top of it. Can't miss it all the spark plug wires run to it and its labeled 1-4,2-5,3-6. It shoule be like 6 bolts to get the coils off and it is right under there.

Where is the relay for power windows in 1997 skylark?

I don't have an answer to this question but want to add to it so hope this is okay, this is a problem with Buicks in General and should have been recalled. The window motors on my 1997 Buick Skylark (purchased in Jan of 2000) started going out in March of 2000

Where is the oil pan located on a 1996 Buick Skylark?

If you have a V-6, it's right in front of the transmission pan. You'll see the drain plug right there. It's a 15mm plug.

What is stumble at idle on 1998 Q45?

Many possible causes with similar symptoms (knock sensors, mass airflow sensor, coils, plugs, etc.). Read all about it on the NICO (Nisson Infiniti Car Owners) forum. Good luck.

How can you bypass the theft system in your 1996 Buick Skylark?

This is my issue.I cannot start my 96 skylark because the the theft system light keeps blinking.This is caused by a problem/defect with somthing called passlock.In a 96 skylark there is no fuse for this.There is a resistor in the ignition/steering column not in the key.I am going to try and suggest you try the folloeing.1.)Attempt to sart,let it stall but don't turn the key off.Leave it in the run position.2.)Wait ten minutes or until the theft system light glows steady instead of blinking.3.)Don't turn the key off but start it immediately.4.) This should reset your passlock system.

Why is my 97 Buick Skylark leaking water on the driving side floor when it rains?

i seen some come in at electric harness and rubber plug in but not onopposite side of rubber under rug.. water there is worse right under vent hole behind wiper moter h2o outlet ....i used liquid construction glue over gms around harness in seams and iii ithelped some.. next ill try in leaf tray under wiper screen plastic over gms seal .i hope it works around drain drain is on engine side .old seem glue

How do you replace the ignition 1990 buick custom?

You have an open question as to what you are asking. Are you referring to the key and tumbler assembly or the actual ignition switch meaning the electrical part? If you mean the key and tumbler then you need to have a locksmith do it or a repair shop as the key is coded for your car. If you are referring to the switch then in that case you will need special tools to remove it.

What was the price of a car in 1968?

depends on what you bought but the average price was $2,500 without any options.

Where is the pressure release valve for the fuel line of a 1990 Buick Skylark?

fuel pressure release valve ? Just disconnect wire harness from tank or remove fuse to fuel pump then start and run engine until it runs out of fuel in line then continue to try to start for 20 seconds then disconect battery and service pump or injectors as the fuel system is now empty of fuel and pressure.

How much does a Buick skylark cost?

Try http://www.cars.com/ You'll get a good idea of the cost.

What is a 1994 Buick skylark compatible with?

The Pontiac Grand AM and the Olds Achieva. Look-up N-body cars from GM.

Where is the fan relay located on a 1994 Buick Skylark?

Follow the wires from the fan. I believe its on the drivers side top of fender well.

Why is your oil pressure light coming on in your 1977 buick skylark with v6 engine i replaced oil sending unit and it still comes on. no knocking 2 b heard.?

maybe you need to check into resetting you oil light. i have worked for jiffy lube and just about every car has to have the oil light reset. so see what that does for you. if that dont work you may have problems with low oil preasure .