Chevy Blazer

Bulb may be blown or has been removed.

2.5

Whenever they are warped, damaged or worn down to the minimum limit. Your local auto parts store can measure your rotors if you bring them in off the car.

Need to go to a GM Dealer . With all you paper work they can get it for you.

Yes I do it for demo derby cars when I use a fuel cell

No it does not if it is a s10 blazer

check the starter its located on the passenger side just beneath the floorboard. two bolts, two wires tricky to get out, but when you do take it to any auto parts store and have them run a test on it, that should remove any doubt as to rather or not you need a starter. i would say you do, but hey it could be alot worse but i doubt it.

Not quite sure what you mean, sometimes the lock tumbler that you put the key in and turn is called an ignition lock cylinder, if not that, I've no clue what you're talking about? Perhaps you could use it in a sentence or be a little more descriptive. If you reverse the words to Cylinder ignition, that would be when the fuel mixture is ignited by the spark plug.

Could be your tires need balancing, or you need an alignment. The faster you go, the more it's going to wobble.

There are several sending units, engine temp, oil pressure, fuel level to name a few. We need to know which one and also the year, make and model vehicle.

A bad brake booster will cause a vacuum leak, result in poor braking, and even poor engine performance. The brake booster has a large diaphragm which can fail and leak.

2057 bulb you can find it cheap at walmart.

you need to remove the inner door panel because there is most likely a rod that has come out of place. look for it too be hanging loose some where close to the latch or the outter handle the rod should reatach to the door handle assembly some what easilly

Two bucket fronts seats, and a bench style back seat that can fit three people.

They're just a simple rubber bushing around the stabilizer bar and clamped into place. They allow the stabilizer bar (or swaybar or anti-sway bar as you might also call it) to pivot and bend slightly as you drive over uneven road surfaces and as you corner.

If you choose to replace them (usually because they make a clunking noise over bumps) it is easiest to do so with the endlinks disconnected. Otherwise, be exceptionally careful not to bend the clamps when installing the new bushings.

It is on the fuel rail on the return side. The rail meaning where the fuel injectors attach.

look on the driver side door the tire size should be 235x75x15 or 235x70x15

Inside the fuel tank.

If you purchase a hitch for the blazer and I'm assuming the 95 thru 2000+ probably use the same hitch(?)there are holes already predrilled in the blazer frame and the mounting bracket on the hitch will bolt up without any problems....i have a 95 and purchased mine from UHaul, it was the newer round style.....only took about 25-30 minutes to install it.Also look up in the wiring(drivers side)and you might find the trailer wires(5 wire or 7 wire)already there....all this makes it a breeze to install your own hitch!

It's a good idea.

it should come out easily.

push the offending axle inward so you can see the retaining clip and remove it. then pull the axle out of the housing. repeat on other side.

you have to remove the "spider" shaft first or the axles cannot be pushed inward (it is in the way)

Often, the spider shaft is held in with a little screw that has an elongated point or shaft. remove it completely and the spider shaft should slide out. the do the axles.

They are the same.

If it's carburated then 4 - 6.5psi fuel injected 9 -13psi when you turn key on with engine off

18.5 gallons

should be on the exhaust manifold