0
Chrysler Concorde
Chrysler Concorde was a four-door, front wheel drive vehicle manufactured from 1993-2004 by Chrysler. The vehicle was designed with short overhangs and low slung windshield. Its wheels were effectively placed to the side of the vehicle to create a bigger passenger cabin than its competitors.
815 Questions
Where is the catalytic converter on the Chrysler Concorde 2000?
In the exhaust, along side of the trans.
My 2001 Chrysler Concorde lhs will not start can you help me solve the problem?
I'd start with the plugs and wires but it may well be the timing belt. It could also be the lower air intake or the air flow sensor. You really need to take it to a dealership and have them diagnose the problem.
How to get the key to turn in a 2000 chrysler concord?
spray some WD 40 on the key. Try and turn. If it still won't turn, spray a little of the WD 40 in the key slot. It should turn with ease. Spray key every other month and insert to keep cylinder lubricated.
Where is the crankshaft position sensor on a 1994 Chrysler Concorde?
It is bolted to the bell housing on the passenger side.
One of the wires you aren't using goes to the vehicles amp if it has premium audio. I had this problem too and I believe the color of the wire I hadn't used was blue w orange stripe. It will connect to the "remote" wire on the head unit. Hope this helps.
Where is the Battery location on a 2002 Chrysler Concorde lx?
It is in front of the right front tire. You have to remove the fender liner to access.
Find fuel reset button for a 1999 Chrysler concord?
Chrysler doesn't have reset buttons. The fuel system is computer controlled with relays.
How do you change timing belt 2001 Chrysler Concorde lxi 3.2L?
If you don't know what you are doing take it to a mechanic !!! the bar that runs across the front of the motor holding the headlights in position and the bumper attaches to it needs to be removed. the electric fans have to be taken out and possibly the radiator ( makes it easier to move around ). then you need to remove the harmonic balancer ( special tool ). then remove the plate around the front of the engine to expose the timing belt. there is a spring loaded tensior that needs to be removed ( slowly compress it in a vice and insert an Allen wrench through the hole to keep it compressed ). after removing the time belt ensure all timing marks line up. you should also replace the water pump at this time due to it being run by the timing belt and you already have it apart. installation is reverse of removal.
Where is the water pump on 2002 Chrysler Concorde?
it is drivin by the timing belt so its behind the timing belt cover. Not an easy job to replace. took me about 6 hours.
it is an oxygen sensor. located at before the catalytic converter to measure the amount of air fuel mixture. the term "lambda" is used since it uses a mathematical equation to determine this measure.
no. they are of a different bolt pattern size.
2001 Chrysler Concorde how to take off intake?
Remove the air intake hose from the Concorde. Take off the throttle cables and any fuel lines or vacuum hoses in the way. remove the bolts for the intake, then lift it straight up to remove it.
Where do i put the freon in a 2002 Chrysler Concorde?
It is added through the low pressure service port.
I would have to believe the shop put in a new belt. But ask them. If it was a new belt, change it when it has 90K on the BELT.
Why did they call a supersonic transport system the Concorde?
The English and the french built it together as a form of a treaty.
Should the engine be running when checking transmission fluid in my 1988 Mercedes 190e?
yes, in park, at operating temperature (let it warm up for about for about 5 minutes)
Where is the fuel pump access on a 1997 Chrysler Concorde?
1993-1997 Chrysler Concorde does have a fuel pump access plate under the carpet in the trunk.
How do you install a water pump in a 3.5 liter engine on a 1994 Concorde?
you need to take the front of the engine apart it runs off your timing belt. Don't remove the fans just the alt/power steering belt. Then take all the front cover bolts out except the lower two on each side of the crank pulley just loosen those. Remove the cover.
Don't remove the timing belt just line up your timing marks on both cams by turning the crank pulley and use two vice grips to hold them in place. Put the grips on top of the front cover to the inside of the cam sprocket's, not to tight just enough to hold them in place. Now you can remove your water pump bolts and flip the pump out leaving the belt in place. To install just reverse what you just did.
Where is the thermostat on a 1998 Chrysler Concorde?
under the housing where the lower radiator hose hooks to the engine
How do you replace the starter on a 2000 Concorde?
== ==
2.7 Liter V6 Engine..
On The Drivers Side Look Under The Engine.. Its Easily Accessed By Removing The Drivers Side Front Tire.. There Are 3 10mm Bolts On It And 2 Connection Wires To The Engine..
Where is the flasher relay 1995 Chrysler concord?
The original answer given by someone else wasn't accurate. It's probably under the dash, but it would be ABOVE the noise guard (knee protector). Not below it. It would likely be between the fuse box and brake, up high above the knee, behind the panel. But to be honest, it's not even there on my 1995 Chrysler concord. So the original answer is definitely wrong.
I have a 2002 and it IS behind the "knee" dash cover, this is removed by opening your fuse access panel on the left end of the dash, then there are 2 screws to be removed, once removed it pops out as it is just snapped into place using clips, it is close to the steering column. On my 2002 i have several relays, only one of which is black and that is the flasher/hazard relay. If you plan on keeping the car and doing alot of work on your own, invest in a chilton manual at your local auto store, it has ALL the steps needed for performing any maintenance on your car. The books run around $25. ( I just replaced that exact relay today)
