0
Dodge Durango
The Dodge Durango was a full size SUV (sport utility vehicle) manufactured by Chrysler for the Dodge brand. Produced in the company’s assembly plant in Newark, Delaware, this 8-passenger vehicle was initially powered by a 5.9 liter Magnum V8 engine.
3,297 Questions
What is the firing order on a Dodge 5.9L?
1-8-4-3-6-5-7-2, clockwise rotation. Pass side 2-4-6-8 Driver side 1-3-5-7
How do you change the license plate bulbs in the Hyundai Atos?
From the outside of the car.. Just un-screw the two screws and change the bulb.
Your turn signals wont work on 2000 dodge durango but checked all the fuses?
Could be the flasher unit.
Where is the low side service port on AC line on a 2005 Pontiac G6?
Open your hood (Duh!) look to the left and you'll find 2 chrome tubes (chrome, silver, metal, w.e) the low pressure valve will accept the can of freeon's recharge valve, where as the high will not (thank God) and that's pretty much it. Look by your air filter for the 2 tubes going into the fire wall and follow them til you find the plug
What kind of transmission does the 2006 Dodge Durango have?
The 2006 Dodge Durango has a 4-speed automatic.
How many quarts of oil does a 2001 Celica GTS hold?
4.8 quarts for GT-S 2ZZ-GE with filter change exactally....
How do you change the heater core on a 1999 Dodge Durango?
I'm in the process of changing one on a 2001 Durango. I've been told the whole dash has to come out. I'm a little scared of setting off the airbag myself. I'm also not sure if the radio will lock up if i unplug it. Needless to say it will probally be an interesting job. Not much info but I hope it will help. you can go on autozone site and they tell u how to take the dash out and core housing
Where is the camshaft position sensor located on a 2001 dodge neon?
Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036 I think the question was where is it located on the car, not which book do I buy to find the location. It is located at the end of the cylinder head. Its the black plastic part with an electrical connector on it.
2001 durango service 4wd light on and 4wd doesn t engage?
could be a few things. there is a sensor that threads into thefront pumpkin with a plug and 2 wires coming out of it, this sensor could be bad. or the splines on the front drive shafts could be worn out. or a relay switch or fuse could be blown between the 4WD button/lever and the sensor i mentioned earlier. these would be the most common.
I checked all fuses. They are ok. When you switch from 2WD to 4WD you can not hear the any thing from the TK.
Get a heavy mall (Sledge Hammer with a long handle) and hit the rubber part of the tire with considerable force. The vibration should loosen the wheel off the drum. Be careful swinging the mall If you are trying to remove the wheel bearing/hub assembly, you have to loosen the three bolts from the back of the knuckle and hammer on them to loosen the hub assmebly.
Where is the oil plug in 2001 durango?
Are you joking or just really inexperienced in automotive maintenance? I'll give you the benefit of the doubt! It's on the rear side of the oil pan, located under the truck, attached to the bottom of the motor (that's the beg metal thing under the hood).
Where is the multifuction switch located in a Dodge Durango?
The turn signal switch is part of the multifunction switch.
The turn signal switch is part of the multifunction switch.
Why does your left blinker only work when your headlights are off?
Usually a sign of a bad ground connection or corroded contacts on the light socket. In other words a poor connection at that blinker.
Where to find evap canister on expedition?
on the fender rh if your truck is 97, and beside to the gas tank 98-05
Where is the speed sensor on a 1999 Dodge Durango?
The vehicle speed sensor is on the top of the rear axle.
The trans output speed sensor is on the driver side tail housing of the trans,
Answered it for myself. Solenoid pack leaking. Dealer charged about $300.00. If there's a next time I'll do it myself and save about 120.00. Can anybody tell me what good warranties are when they don't cover anything.
How do you replace the water pump on a 1999 grand voyager?
You must remove the serpentine belt first. A tensioner tool makes that easiest. Drain the coolant out, if it is not old it can be used again. Pull the pulley off the pump, use a screwdriver between the bolts to keep the pulley from moving. Loosen all of them first. then Take off the pulley. Remove the bolts, I think there are six not evenly divided out. Only the front part of the pump gets changed and the housing stays on the engine. Clean all surfaces. Use some gasket sealer (blue Form-a-Gasket) in the depression in the pump going around the outside of the pump. evenly tighten the bolts on the new pump. Re-assemble, add coolant, put back on serpentine belt. Done.
Where is the oxygen sensor located for a 2005 Dodge Durango Hemi 5.7?
The oxygen sensor is located in the exhaust system on a 2005 Dodge Durango Hemi 5.7. There is a sensor located before and after the catalytic converter.
