0
Dodge Ram
The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.
13,744 Questions
How do you install a power steering pump in a 1999 Dodge Durango?
Replacing your power steering pump is a relatively easy task with the correct tools. Those being the pulley removal and installation tools, often sold in a kit. You will also need a pair of pliers, and open end wrenches. First remove the drive belt. Place a drain pan under the pump to catch the power steering fluid. Detach the two hoses on the back of the unit, which are the pressure and return lines. Remove top bracket nut which secures the battery ground cable. Then proceed to remove the bracket mounting bolts. Typically a replacement pump will be sold without the pulley. Hence the necessity of the pulley installation and removal tools. You can also save a little by re-using the old reservoir. The installation is just the reverse of the removal. Be sure to replace any o-rings. After mounting the new pump and re-installing the drive belt, fill the reservoir with power steering fluid and bleed the system to remove any air by jacking up the front of the vehicle, start the engine and allow it to run at fast idle, if necessary add more fluid to bring the level of fluid to the cold mark on the dipstick. Begin bleeding the system by turning the wheels side to side without hitting the stops. Keep the reservoir full of fluid as this is done. when all of the air is worked out of the system return wheels to the straight ahead position and allow to run for several minutes more. Road test to insure proper operation of your steering components. Recheck fluid level to be sure it reaches the hot mark when the engine is at normal operating temperature.
How would you replace a belt tensioner on a 91 Corsica 2.2 l with aftermarket AC?
The belt tensioner on a 91 Corsica 2.2L with an aftermarket AC is replaced by loosening the retaining bolt and pushing the tensioner to the side. The belt can then be taken off, the tensioner removed, and a new one bolted into position.
How do you get ABS trouble codes and where is the ABS computer located in the Van?
Check out www.autozone.com. They have some repair information for some of the model years of the Windstar. This may help you to find the location of the ABS parts you are looking for. I do not know how to get the codes but I'm sure it must be a special code reader.
I can't help with the codes, but the actual ABS controller is under the driver's seat. It "talks" to the rest of the computer controls via the data lines that run all through the vehicle. My schematics show it connected by way of a 25-pin connector.
See "Related Questions" below for more
How do you change the temperature sensor on a 2002 2.3 Ranger?
According to Haynes Manual, 2001 and later 2.3L Ford Ranger, the Cylinder Head Temperature (CHT) sensor replaces the Engine Coolant Temperature (ECT) sensor on earlier models. The CHT sensor is located between the #2 and #3 spark plugs in the cylinder head and can be accessed through the valve cover. Carefully pull back the CHT cover to expose the electrical connector then disconnect it from the CHT sensor. Unscrew the CHT sensor and remove it. Installation is the reverse of removal, being careful not to overtighten the CHT sensor when installing it.
first get rid of that quadrojunk carb and spend a few more dollars on something worth installing and then reask this question
Answers such as above are not helpful. Quadrajet carbs work excellently delivering fuel economy and performance. This person wanted help with the vacuum lines, not a flippant reply that showed your bias and lack of knowledge. If the original poster still needs help, he or she should find a good manual or pay Alldata for a schematic.
Instructions on how to remove ignition switch on a 1990 Lexus LS400?
Remove the retaining ring from the top of your 1990 Lexus ignition switch. The ignition switch will slide out. Remove the wiring harness.
What size wipers fit 2009-2010 dodge ram 1500 crew cab?
The 2009-2010 Dodge Ram Series 1500 Pickups take 22" replacement windshield wiper blades on both sides front. Note however, when buying wipers be sure to always lookup your vehicle make, model and year in the application guide book at the store, or now-a-days you can Google 'lookup wiper size'.
it just means that the head on the motor is hemispherical. That means it has a curve to it.
Which wire is a remote amp turn on wire on a 2012 dodge ram 1500?
The remote amp turn on a 2012 Dodge Ram 1500 is the wire that taps on the harness to supply the 12v.
The EGR is not the problem The tone ring on the crank for the crank position sensor is different and the engine will not start.
How do you replace third brake light bulb in 2011 Dodge Ram 1500?
2011 Dodge Ram 1500 brake light bulb replacement: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Diesel engines detonate. Diesel has more potential energy than gasoline, instead of burning evenly, diesel explodes creating a knock or rattle noise.
The Disney Cruise is one of the best family cruises available. The cruise is an all inclusive vacation that is filled with family fun. Although there are many different destinations on the Disney Cruise, you will need to pack basically the same items for all of their cruises.
You should think about what type of clothing you will need on the cruise. Casual t-shirts, shorts and jeans are fine for during the day, but you will need nicer clothing for dinner. Dinners are a little bit more formal, so ladies should bring a dress or long pants and men should bring a pair of dress pants and a nice shirt. There is only one dining room in which formal wear is required. If you plan to eat there, men will need a jacket and tie and women will need a more formal dress. You should also bring a swimsuit and comfortable shoes for walking around the ship. The Disney Cruise has a pirate themed party one night during the cruise, so you can bring some pirate themed clothing or a costume for the kids if you choose.
Some toiletries are provided on the ship, such as shampoo, soaps and body wash. You will need to bring everything else that you normally use on a daily basis. Be sure to pack sunscreen, as it is very expensive to purchase on the ship. You may want to pack a seasickness remedy, especially if it is your first cruise. The Disney Cruise does have a doctor and carries over-the-counter remedies, but you should bring your own to save on cost. Also, don't forget to pack any medications that you may need, as you will not be able to get a refill on the ship.
You will not need to bring toys or activities for the kids because the Disney Cruise will keep them occupied all day long. You will not need to bring beach towels, as they are provided for you. Surprisingly, you will not need any cash on the ship, as none of the stores accept it. Everything that you purchase that is not included in the cost of your cruise, such as alcoholic drinks or souvenirs, is paid for by using your room key and is charged to the credit card that you leave against the room.
You will have a great time on your Disney Cruise. Try not to over pack and just bring the items that you really need.
Where is the mass airflow sensor in a 2005 dodge ram 1500 5.7L?
A 2005 Ram 1500 does not have a mass airflow sensor.
Where is the coolant temperature sensor located on Dodge Dakota 1994?
behind the thermostat housing,two wires
How do you remove rust from a truck frame?
Surface rust on a truck frame can be removed with abrasives like sand blasting or a scale removal tool. If the rust is deep then it may have compromised the frames integrity and will need to be professionally cut out and replaced.
How do you remove a tailgate from a 1995 F-350?
open tailgate. unclip the cables that hold tailgate level
they will unclip from the top anchor post without using any tools.then lift tailgate from left side so as tailgate hinge comes up from pivot point. then slide tailgate little to the left and you should have tailgate in your hands
Where do you recharge the AC on a 2002 Dodge Durango?
on the 2002 Durango, the low side fill valve is beside the air filter cover and the high side valve is about three inches to the left of the radiator.The low side line runs from the firewall to the compressor & the high side line runs from compressor to the coil in front of the radiator.
Where is the bell crank assembly located on a 2003 dodge ram 2500 5.7 hemi?
Under the battery on the driver side.
Under the battery on the driver side.
How do you adjust the clutch 1998 dodge 3500 diesel 5 speed?
The clutch is not adjustable. The hydraulic master/slave cylinder assembly self compensates for wear. You have a problem with the clutch of master/slave.
How many quarts of transmission fluid do you use in a 96 dodge ram 2500 4x4?
It is important to know the amount of fluid to add to a car. On a dry fill a 1996 Dodge ram takes between 9 and 14 quarts of transmission fluid.
How long do it take to put on the crankshaft sensors?
it takes a fair length of time on most motors you have to pull the crank pulley and possibly the fan and rad.
