0
Dodge Ram
The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.
13,744 Questions
How do you replace the air filter on a 2005 dodge ram 1500?
First wiggle off the air intake snorkel off of the filter housing, then pull off the vent tube from the filter housing, then loosen the clamp holding the housing to the throttle body, then gently wiggle the housing up and off the throttle body, then unsnap the clips and separate the housing halves exposing the air filter element. If you attempt to remove the filter element without removing the housing off of the throttle body first you will break something, been there, done that.
What is the difference between 1500 hd Chevy and a regular 1500 Chevy?
It may have an extra leaf spring on the rear, and over loads on it and that is about it.
How do you install starter 1996 Dodge one ton diesel cummins?
1 Un hook the batteries.
The starter is located behind the front axle on the drivers side of the engine just follow the positive battery cable.
2 Unhook the wires
3 Remove the three bolts that attach the starter. 10mm end wrench with 12 points will work.
4 Put on the new one and reverse the above steps.
How do you remove a 1998 Eldorado water pump - special tool not working?
special tool engauged properly, long 1/2 drive pull bar, rotate bar clockwise, its very tight.
Why would the turn signal flasher unit stay hot?
Please verify that the CORRECT flasher/relay for the vehicle in question is in fact fitted. The wrong one could cause what you are describing with nothing else actually wrong. Substitute a known good flasher/relay of the correct type for the overheating one and see if the problem goes away. If the flasher/relay is at fault there will be no further sign of the problem, but if it does not then vehicle electrical system is causing the problem.
Unplug and/or substitute a known good hazard switch for the one in the vehicle (the turnsignal power lines usually go thru the hazzard switch) and see if the overheat stops.
Does the vehicle have a tow package electrical adapter (like U-haul) installed? These contain diodes inside that can short and cause low level load related problems.
Check the ground connections between the battery and vehicle body. Do this with a voltmeter, there should be less than 0.10v voltage drop across any ground (one probe on the battery post and the other on the body where the cable attaches) with a load on the cable (meaning with power flowing thru it). I have seen a bad ground cause a power feedback thru unexpected pathways as the electicity tries to get back to the (badly grounded) battery post using the engine block ground cable.
With the preceeding in mind...
Do the turnsignals have to be used befor it heats up or will it heat up just from turning on the key? Do the turn signals/parking lights ALL work properly? By that I mean do they come on only when they should, and go off only when they should? If some lights are coming on when they should not, and any bulbs were recently replaced, check to make sure the correct replacement bulb was fitted. I have seen unusual operation when a single filament bulb was fitted to a dual filament socket (yes, it will fit, and the single filament bulb-contact bridges the dual filament contacts in the socket creating a "short" between turnsignal and tail light circuits).
Finally, with the electrical system in the problem mode (IE turned on, etc as needed to create the overheat condition) but the turnsignals (and hazard switch) turned off, disconnect or pull the flasher/relay out of it's socket and watch for the flash of a spark. You may need to use a darkened environment such as a garage with the door down or outside at night to see the flash. If you DO see a flash from a spark then there is a definite load on the flasher/relay when there should not be. Try to see if any lights or other loads go out when the relay/flasher is unplugged and if you do see something change that may be the issue or related to the issue at cause.
Good luck.
Is there a Dodge Rumble bee Quad cab?
Only if you create your own,as I have. A dealer in Tennessee was making them,and that's where I got my inspiration. All you need is a quad cab painted solar yellow or black with the sport package,and go from there.
Another view:
Actually my son has a 2005 Yellow Rumble Bee Quad cab. It is based on the SLT model but has a special black suede leather seat with yellow leather inserts and Hemi script. It is a factory Rumble Bee and was originally ordered in the WI/IL area. It has power seats w/heaters and 20 inch chrome Alloy wheels. It has two black racing stripes that start at the bottom of the front bumper and end at the windshield then reappear on the tailgate. The instrument panel has gloss yellow panels surrounding the radio and HVAC controls. It has a bed liner with the script "Hemi" at the front panel. It does not have the aero skirt package as seen on regular cab models. Before we found this one we found a black 2004 Quad cab Rumble Bee.
The Rumble Bee was an option package available on Regular cab model 1500 rams only!!!!!! Everything else is a wannabee!
What happens if the 2 rubber fuel lines get crossed from tank to engine on 92 Toyota?
One is a return line from the charcoal filter, the other is the feed through the gas line filter. You don't want to swap them around. If you did go back and redo it. The troubles will be more timely than the fix now.
Can you put a 460 in a f 350 with a 6.9L diesel in it?
I have seen it done. I do know that the transmission has a different gear ratio for gas and diesel but it works. you would just have to look at everything and see what you would have to change.
How do you tell if your dodge diesel is a high output?
If it is not an automatic and not bought new in California it is most likely the HO. There is a information plate on the gear cover on front of the engine that tells the stock HP and Model numbers ect.
Where is the egr valve on a 2000 dodge ram van?
Dodge didn't use EGR on the Magnum engines, it wasn't necessary.
Can a Catalytic Converter cause lost of power on a 98 dodge ram?
Definately!
A catalytic converter is typicaly a series of "honey comb" vessles. In the proccess of its job, it can, and usually does, clog up thus reducing the engines ability to asperate(breath) correctly. Kind of like a potato in the tail pipe trick.
Where is the antifreeze drain plug on a Dodge 360 engine?
You Should Find It Depending On Year Of Vehicle, Im The Bottom Of Radiator On The Passenger Side.
Is it 2 fans on dodge ram 1500 to cool enginge and ac evaporator?
On a 2002 and later 1500, there is one fan for the radiator and one for the ac condenser.
On a 2002 and later 1500, there is one fan for the radiator and one for the ac condenser.
Yes, it will cycle off and on to keep the evaporator from freezing up.
Replacing a water pump on a 2003 olds alero 2.2 liter?
replace a water pump on a 2004 olds alero 2.2 litler
Which is the better truck 2006 cummins or 2002 duramax?
the cummins. Hands down.
if you said any dodge older than a 2005, I'd go with the duramax, but the trannies in the 05 and up dodges are much better, and you cant beat a cummins for power and reliability.
Will a 2002 Dodge Ram transmission fit a 2000 Dodge Ram 1500?
Yes, if it is a 5.9L V8. The safety neutral switch should be the only thing that is different. If the 2002 is a 4.7L it will not work.
How many horsepower does the engine in the 2011 RAM 3500 have?
The 2011 RAM 3500's engine produces 350 hp @ 3000 rpm.
Why does your 2000 Dodge RAM 1500 shut off while driving Should you replace the computer?
check your fuse box. In my '97 the fuse retainers were loose and no longer kept a tight fit with the fuse causing my truck engine to turn off sometimes while driving or not start at all (not fun in mid turns). Wiggle the fuse around while its running or you're trying to start it and see if this helps. If it does either have the fuse box/part replaced or for a temporary fix shove the next bigger fuse in it.
What would cause a 2000 Chevrolet blazer's transfer case module to go bad?
Corrosion. Check connection at the module for corrosion.
