0
Dodge Ram
The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.
13,744 Questions
It's a matter of replacing the reverse position swith in the transmission. This switch tells the computer wheter it's in neutral, or reverse and when in reverse it triggers the reverse lights.
How do you remove the rear speakers in a 1997 extended cab dodge Dakota?
When is it recommended to replace the timing chain on a 1997 dodge 1500 5.2?
Whenever you rebuild the engine.
What is the case for a 2003 Dodge Ram ABS module to continously run?
its a common failure mode for dodge abs module. You can get it fixed by bba remanufacturing in Massachussetts, bbareman.com.
Your actual speed is 10% MORE than what your speedometer is reflecting. (When your speedometer reads 60, you are actually traveling 66)
10=11, 40=44, 100=110 etc.
Your actual mileage is 10% MORE than what your odometer is reflecting. (When your odometer reads 100 miles, you have actually traveled 110)
So when you see a cop doing a speed trap, remember to slow down accordingly.
When you sell your car, don't forget to disclose that you have larger tires and that the odometer should read more miles than it does.
What is the horsepower and torque rating of a 1997 F-250 Powerstroke turbo diesel truck?
around 250 horses. The 7.3L has 500 ft/lb torque stock.
How do you install governor pressure sensor for a 4.0L 2001 grand ckerokee?
Here's a link that will help. http://www.automotiveforums.com/vbulletin/showthread.php?t=350038&highlight=governor+pressure+transducer
2003 dodge ram 5.9 injection pump timing?
The high pressure fuel pump on a Bosch Common Rail system does not require timing.
What is the size of the engine in a 1986 dodge b2500 van?
i believe you had a choice there, but if it were a v-8 the likelihood of it being a 318 or a 360 is the guess, both relatively the same only the 360 is internally larger displacement, from the hood view they're the same and most parts interchange- starter,waterpump,alternators,so on.
Where is the egr valve located on a 1995 dodge ram 1500 v8?
Where is the EGR valve located on a 1995 dodge 1500 5.2 liter
What are the benefits of having a Dodge Ram 1500?
The single benifit of having a Dodge Ram 1500 is the amount of power it offers. They tend to be popular with people that do long hauling for various items and the ability to move about in areas that are not easily accessible.
95 Dodge Ram Cummings Diesel how do you change Thermostat?
Drain coolant (not a whole lot, just the top 6 inches or so)
Remove 4 bolts on housing, You will probably have to remove one alternator bracket or the whole alternator.
Pull out old, put in new, make sure to use new O ring.
Reassemble
How do you adjust the idle on the 1987 dodge ram?
If it has the standard 2bbl carb, there is a screw on the drivers side linkage. Just turn in to increase the rpm's, and back out to decrease. There is also a choke "kick-down" screw that can affect engine rpm when cold. This one will be screwed into a "stepped" cam on the linkage. You will need to adjust this for high idle speed when engine is cold. You may also have a high idle speed solenoid mounted on the front of the carb. This increases engine rpm when the ac unit is swithced on. This should be adjusted from the factory, but can be tuned by by a screw on the front of the solenoid.
What are the enhanced scan tool capabilities on a Modis scan tool?
The MODIS Scanner graphs up to eight parameters of live data and displays complete trouble code descriptions for GM, Ford, Chrysler, Jeep and Asian imports.
You can check to make sure the radiator fluid is up to the correct fill level. Also be sure that the coolant/water mix is within the suitable ratio parameters. There is an inexpensive tester at all reputable autopart stores for that. You can also check to see if your thermostat is functioning properly. If it is not then your heat may only get slightly warm and may not heat up at all. Sounds like a thermostat.
How to install an oil pressure sending unit?
Ok I'll bite. On our '92 Suburban (284k mi) it is located on top of the engine at the back of the intake manifold UNDER the distributor. Be prepared to remove the air cleaner and the distributor so number the wires. The original sender required a 1-3/16" wrench (how many folks have one of those) and of course the new one needed something different, slightly less than 1-1/6"(metric). Not terribly difficult other than finding it and I'll take it over to my auto shop guy to get the timing nailed down; I was able to get it close enough to get it started. This is the link I found a drawing that helped me located the unit on the engine: http://autorepair.about.com/library/illustrations/bl283a-lib.htm
How much freon does a 2003 dodge ram need?
Need to know what model you have and the engine size to be sure. Also if it has rear A/C system also. You can get the information you are looking for on the link below. Just click on the "Find Your Car's Low-Side port" it will take you to the the Refrigerant & Lube spec's also.
