0
Ford Ranger XL
The Ranger XL is a pick-up truck manufactured by the American automaker Ford Motor Company. Some of the notable features found in the 2010 model are Electronic Stability Control, and torso and head airbags in the front seat.
4,911 Questions
When was the first year for ford f 150 harley Davidson?
I BELIEVE the first model year for the Ford F-150 Harley Davidson Edition was
the ( 2000 )
Why do i have no heat in my 1998 ford ranger pickup?
have you turned on the switch? If so here are somethings that you can check...
1. blend door actuator
2. thermostat
3. radiator fluid level and color (should be green)
4. heater core.
Check those things!
The blend door actuator works a flap that sends hot air from the heater core to the passenger compartment or to the defroster, it will be located under the dash on the passenger side. It works by vacuum or a small electric motor.
The thermostat is located at the engine end termination of the large hose running from the radiator to the engine block. The gooseneck the hose attaches to is usually held by two bolts and the thermostat is inside this housing. The thermostat can stick and cause overheating and loss of heat in the heater.
The heater core itself can leak, which in many cars will show up on the floor on the passenger side of your car. Another indication of leaks would be steam coming from the vents. It also has to be taken out from under the dash on the passenger side.
It is a good idea to have your system flushed if you notice that the water in the radiator is rusty or orange colored. The water should have coolant/antifreeze in it which normally would give it a green color.
Where do you bleed the clutch on a 1992 ford ranger?
On the transmission there is a bleeder valve it should be located twords the top near the front of the tranny. The easiest way is to use a vaccuum bleeder or run a hose from the bleeder in to a jug of brake fluid. open the bleeder to release fluid/air then close it and pump the clutch. repeat this process until you can feel the clutch coming in also you should be able to hear it. rangers are a pig to bleed as they have all sorts of lines running through that cause air pockets and sometimes it can take days
Why your 1997 Ford Ranger will not move after you put it in drive with a cold engine?
Check the transmission fluid level first. It could be down.
On the other hand, if the level is up and the engine is running but the vehicle won't move after putting it in drive you probably have a valve body problem in the transmission. You might get a little improvement with something that softens the seals and/or stops the leaking. Most likely it won't help much but it's worth a try.
If it only runs after it warms up, try changing the fluid and filter but don't try running it until you move a little fluid through the valve body. Put it in gear but don't try to go, just let it idle for a few minutes. If that won't work you'll have to get the transmission rebuilt.
Where is the horn and how do you access it on a 1997 Oldsmobile Silhouette?
There are 2 horns on the 1997 Oldsmobile Silhouette. You must remove the headlight/ turn signal assemblies (2 thumbsrews to remove each one). You will find each horn in the space below the headlight.
Are the valves in a 1989 B2200 adjustable?
Plainly put NO routine adjustment is necessary on the 1989 model.
Wipers is there a fuse in a 92 Crown Victoria?
No. There is not a "fuse" for the wipers. There is, however, a "circuit breaker" located in the fuse box under the the driver's side of the dash. Part # D9AZ 14526C.
Where is spark plugs for 2003 ford 5.4?
The spark plugs are under the 8 individual coils ( Coil On Plug ignition system )
firewall
4 - 8
3 - 7
2 - 6
1 - 5
front
How much will it cost to replace the oil pan on 1997 Nissan quest?
Buy it at a salvage yard and it will cost about $10.00. Another few dollars for the gasket/seal, it's cheap. Check the torque specs and don't over tighten. It there are no junk yards in your area, just go on line. You can search across the country and have the part shipped.
What is the sensor on a 97 Ford Ranger master cylinder resivior caller?
I believe Ford calls it the " brake fluid level sensor "
the delay on jetta wipers is different. the delay is adjustable. if someone set the delay very long, you will think the delay is not working. here's how to shorten the delay. turn the wipers to delay (one click DOWN on the stalk). immediately turn it back off and now turn it back on. the delay is the length of time you had the wipers off between the two on's. for a 3 second delay, turn the wipers to delay, immediately turn them off, wait three seconds and turn them back on. for a 6 second delay, turn them on, immediately turn them off, wait 6 seconds and turn them back on.
What would cause the engine not to reach normal operating temperature?
but only temporarily.
A thermostat functions to regulate the flow of water between the engine and radiator.
On an average outside temperature day (75 degrees), "no thermostat" would result in (1) the engine not reaching operating temperature in the normal engine warm up cycle time and (2) much later in the cycle the engine would overheat caused by the water not remaining in the radiator long enough to cool down. More extreme outside temperatures would impact the previous results.
No thermostat or a defective thermostat that is stuck open. Also could be a deffective coolant temprature sensor. Or air bubble aroune the sensor on some cars.
Where is the water pump located on a 2000 Pontiac Sunfire with a 2.2 liter engine?
Usually right above and in line with the crankshaft pulley
We blink so our eyes will be moist and not dry. Another reason is that when bacteria or viruses hit your eye, your eyeslids can brush off the germs.
How many gallons of gas does a 1997 for ranger single cab 4cyl 2.3 L hold?
According to the 1997 Ford Ranger Owner Guide :
For the regular cab :
( 17.0 or the optional 20.0 U.S. gallon tank )
i believe you take off the inner door panel and manually raise the window or remove to get to the motor and replace it with a new one
duct tape a garbage bag over the hole where the window was. nice and breezy.
What is the distance between the front and rear wheels on a 1992 STX Ranger Extended Cab?
extended cab wheel base, which is from center of wheel to center of wheel is 125 inches
How do you install the shifter linkage on a np model 205 transfer case?
To install a shifter linkage on a NP model 205 transfer case it takes a few steps. Start with a new gasket positioning the transfer case to the extension, install the bolts and nuts, connect the shift rod to the shift lever arm, secure with the spring and washer, connect the front wheel shaft to the case, connect the rear axle and then you are done.
How thick are new front brake rotors on a 2010 Ford Ranger?
What should the thickness be on the front brake lining for ford ranger 2010
What is the fuel capacity for 2005 Ford Ranger?
According to the 2005 Ford Ranger Owner Guide :
( the SuperCab body style holds 19.5 U.S. gallons / 73.8 liters )
Where is 2001 Ford Ranger fuse panel located?
On a 2001 Ford Ranger :
Open the drivers door , and IN the drivers end of the dash you will see a
removable plastic fuse panel cover . The fuse panel is behind the cover
Also , the Power Distribution Box ( which is " live " ) is located in the engine
compartment , on the drivers side of the engine compartment
