0
Honda Accord LX
The Accord LX was launched in 1978 as a 3-door coupe and was later re-designed as a 4-door hatchback and 4-door sedan. The latest model is available as a 4-door sedan powered by a 2.4 liter engine.
4,658 Questions
How do you install front door speakers on a 93 accord?
My first car was a 1994 Honda Accord LX Coupe, and I'm assuming that the process of changing out the speakers is still the same. To replace the speakers I removed the screws that secured the door panel(the upholstery) to the frame of the door. I believe that there are screws located in the door handle(if there is one) with some screws concealed by square inserts that matches the texture of the handle. You also want to remove the screws that secure the power-lock assembly. Get a flat-tip screw driver and insert it between the door panel and the metal portion of the door, and with a prying motion, pop the door panel out along the left, bottom, and right side(there are protrutions on the backside of the panel that snap into holes in order to secure the door panel to the door). When finished, lower the window all the way. Once lowered, lift the panel and pull out slightly. There are wires connected to the panel(door light, power locks, power windows, etc). Disconnect the wires and set the panel aside. The rest is basic speaker installation:
1)Remove the screws securing the speakers and pull the speaker out.
2)Cut the male and female speaker connectors(assuming you're installing aftermarket speakers) preferably close to the connectors(you need to solder so you want as much slack as possible).
3)Trim the speaker wires that came with the speakers to a desired length.
4)Remove 1/4" of insulation from the speaker wires that came with the speakers and the speaker wires connected to the car.
5)Twist the wires together and solder the wires together(doesn't really matter which wires you solder together. Reversing the polarity doesn't change the sound or quality).
6)Wrap the soldered wires in electrical tape remembering to keep the positive and negative wires separate.
7)Attach the wires to the speaker and mount the speakers onto the door.
Installing the door panel back onto the door is opposite of disassembly.
How wide is the 2014 Honda Accord?
The 2014 Honda Accord is 6 ft. 0.8 in. (72.8 in.)1 one-touch power windows wide.
How do you add R12 freon to a 93 Honda Accord?
It won't tell you in your manual.
Adding freon is something that should be left to someone that knows what to do and has the gauges to measure how much is being put in. If you put too much in, you can damage your air conditioning system.
Now for the other side of this. Nowdays, a shop can't just add freon to a system. They have to pull the old freon out, check the system for leaks, and repair the leak if found before adding freon. Something that gets to be expensive very quickly so I can see where you would want to do it yourself and save a lot of money.
See if you can find someone that will do it for you, use your freon, and not go through all the crap. maybe a mechanic that will do it on the side or something...
How do you turn off the Maintenance required light ford f150?
turn ignition switch on but dont start. disconnect the negetive battery terminal then reconnect it
Where do you add transmission fluid to a 1988 Honda accord?
if you are looking at engine at your right hand should be a dipstick colored orange and look past the dipstick and you will see a nut 3/4 or bigger above the transmission remove and pour the fluid.
for small amounts, service through the dipstick opening.
How do i change the fuse of a Honda cm 125?
Take off the right side panel, on the left side of the battery you will see a red wire. This is connnected to the starter solenoid, trace along the red wire till you find a plastic fuse holder open it and you will be able to see if the fuse has blown.
What does the thermostat do in a 1994 Honda Accord?
Its job is to block the flow of coolant to the radiator until the engine has warmed up. When the engine is cold, no coolant flows through the engine. Once the engine reaches its operating temperature (generally about 200 degrees F, 95 degrees C), the thermostat opens. By letting the engine warm up as quickly as possible, the thermostat reduces engine wear, deposits and emissions.
Why is the SRS light on on your 1993 Honda accord?
It is on because there is a problem with the air bags, Supplemental Restraint System (SRS). Take it to a professional for repair, as this repair is not a DIY one.
Any special tools needed to change brake pads 2003 Saab 93?
I just did this today and the "special" tools I found I needed were: a 7mm hexagonal (six-sided) bit socket (one that will fit onto a ratchet...there isn't enough room to use a hexagonal head screw driver) and that's really it. I assume that you have a ratchet set with metric sockets, brake lube, pads etc. This is an easy job don't worry.
Your computer may need to reset, try disconnecting your battery for at least 30min.
How do you know if you have a bad fuel injector on a 1995 Honda Accord?
If I'm not mistaken, it's just like checking fuel injectors on any other vehicle. You have to know what the resistance is (Honda should be able to give you the specs) remove the connector to the injector, take a multi-meter and set it for "ohms" and put the two probes on the contacts of the injector and you should get a resistance reading, if the reading is not within the manufacturers specs then it's a bad or weak injector.
Hope this helps, its the best i can do.
What would cause 2000 Honda Accord SRS light to stay on?
There is a problem with the SRS (Supplemental Restraint System)( Air Bags). It is dangerous to work on this system so have it repaired by a professional.
What would cause water leaking into rear passenger seat floor after a rain on a Mercedes 240D?
hello, i can not answer this question but ask your mechanic for the answer all the best Sir Digby Ceaser xxxxx
How do you remove ignition switch on a Honda Accord?
I had a hard time before i figured out how to remove my old ignition cylinder to put in a new one... I did this because my old one ond day just stopped working... It just wouldn't turn... so I boutght a new cylinder (it comes with new keys) from auto zone... cost about $26.99.... n e way hope this post helps n e 1...
HONDA ACCORD 92 DX
First remove the 5 screws that hold the stering column with a star point screw driver (you might need a ling screwdriver)...
Remove the casing to expose the ignition assembly
Use a flat head screwdriver to remove the outer shell of the ignition cylinder (black round thing around the turnig part)
Remove the locking screw (I just used a bird beak pliers to back it out because of the odd location " it right by the middle arrow")
Put in the key and turn it to position I.. (Turn on the ignition... don't start it...)
Use a firm tool to depress the locking pin located behind the lock screw towards the stering whele shaft...
Thought U don't see my key in the ignition U MUST HAVE THE IGNITION ON!!!
while depressing the pin hold the key firmly and pull the cylinder out (rock it a but it should come right out)
I couldn't get the new one in cause the new pin on the new cylinder wouldn't depress... (when installing the new one leave the key in the on position)...
I just used a set of pliers to pluck it out... then just used the locking screw to hold it on.... dosent really matter tho...
What causes Honda Accord fan noise after the engine is off?
I have the same problem and got scared because i took the key out and thought the engine was still on, it means you left your air conditioning fan on, go inside and turn the ac fan off
How much does a cam belt cost on a 2004 Honda CR-V?
I think you are actually asking what it costs to REPLACE the timing belt. The cost of the belt itself is not the big expense. The labor to partially disassemble the front of the engine and get to it is where the expense comes in. The cost of labor and materials vary too much around the country to make any estimate other than to say it's going to cost you several hundreds of dollars. The best thing to do would be to contact your local Honda dealer and ask.
How do you turn off the required maintenance warning on a 2007 4 runner?
You may have to repeat this several times until you accomplish the task. Select the odometer total miles with the trip reset switch. Turn off ignition and then turn on again depressing the reset switch and holding it until the maint light begins blinking. Continue pressing on the switch until the maint light goes out.
you should check the belts. Sounds like one is a little loose and slipping. or the system may be over-charged
"Aclaimed" is a term that refers to something or someone that has received praise or recognition, often for excellence or notable achievement. It is commonly used to describe works of art, literature, or performances that are celebrated by critics and audiences alike. The term signifies a positive reputation and respect within a particular field or among the general public.
