0
Nissan Maxima
The Nissan Maxima is a large four-door sports sedan manufactured by Nissan. It was launched in July 1976 as an upgrade version of the Nissan Bluebird. The car’s model is also called Nissan Laurel or Nissan Cefiro in other markets.
2,931 Questions
What does the inhibitor switch do on a 1984 Nissan 300zx?
THE INHIBITOR SWITCH TELLS THE ECM THAT THE TRANSMISSION IS IN PARK OR NEUTRAL AND SAFE TO START THE MOTOR SOIT ISNT IN GEAR IT IS ALSO CALLED THE NEUTRAL SAFTEY SWITCH AND IT IS LOCATED ON THE TRANSMISSION
How do you remove automotive windshield?
Every car has its own way to remove the windshield. The basic is to remove the cowl (the bottow part of the windshield where the wipers sit on top of, it a long plastic piece) after that you remove the trim (moulding). Then your insert a special tool called a cold knife, looks like a L shape knife. You slide that knife between the pinchweld and the glass, and pull it all around the edge of the glass, this is separating the glass from the poly-uranthane which holds the glass. That all
What kind of transmission does the 2005 Nissan Maxima have?
The 2005 Nissan Maxima has a 6-speed manual.
How do you reset the security on a 1997 Nissan maxima v-6 3.0L?
Try the following....
1. Get in and lock the doors
2. Put the key in and out 6 times within 15 seconds.
3. Pull the key out
4. Put key in ACC
5. Press lock on door control panel and then press lock on the keyfob
6. Start the car .... and it works!
How can you rewire the entire sound system a '92 Nissan Maxima?
Hey Jon==Get a wiring diagram and a wiring harness from PAINLESSWIREING.COM. GoodluckJoe
thanx for the pop-farm don't go to PAINLESSWIREING.COM
To re-wire the audio system in a 3rd gen maxima with Bose, you must bypass the amps that are at each speaker in the car. Find out which two wires are the inputs coming from the dexk (usually the twisted pair out of the 4-5 input wires u see), the outputs going to the speaker will be connected to the speakers themselves. Use speaker wire to jumper those wires together, therefore bypassing the amp. The front speaker size is 4" round, and the rears are 6x9" speakers. Hope that helps a little.
the easy way is to buy a convertor for the Bose system so you can still use the original speakers, when installing another stereo/CD...i brought mine from crutchfild for about 35.00....the sound was still awesome
What is a 1992 Nissan Maxima worth?
i just payed $450 for mine and it has idling issues..searching for knock sensor location now...
Where do you hook up an OBD code reader on a 1997 Nissan Maxima?
There should be a plug adapter spot right under the steering wheel and dash assembly, should just plug right in... i have a 96 and i work at O'Reillys auto parts, we have a code reader that reads all nissans from 88 to current....so if is the right code reader it should just install as i said above hope that helps a little
How do you install a starter in a 1987 Nissan Maxima?
Remove the negative battery cable then follow the posative cable and find the starter. remove the wires and mounting bolts and work the starter out. Sometimes the bolts are hard to get to.
How do you install a fuel injector in a 1991 eagle talon?
Unhook your wiring harness from injectors and other sensors. Unbolt two bolts on intake holding the cables. Then unbolt fuel rail and unplug spark plug wires from coil and you should be able to wiggle fuel rail out as long as you take bolts out of rail before trying to pull it out. then just pull injectors from rail..
How do I refill freon in a Nissan Maxima 2006?
You take it to a professional, the freon you buy in the store is not what your car needs !
Why would a car sputter when you accelerate and idle rough?
Nobody ever mentions an egr valve replacement..this is common in gmc vehicles...Rough idle,stalling, ignition starting trouble all relate to the egr valve sticking...
Your problem is a misfire. You need to do a misfire diagnosis and then correct the cause of the misfire. If you have allowed the misfire to continue for too long, engine damage may have occurred, but otherwise correcting the cause of the misfire should set everything right.
AnswerUnfortunately it could be a number of things causing rough idle and hesitation. It sounds like the engine might be confused about how much gas and air it is getting which might mean it needs a new oxygen sensor (EMISSION) or throttle position sensor. Start with the easy maintenance items like spark plug wires, air filter, and fuel filter if they have not been replaced recently. A bad spark plug wire may only occasionally short out and cause these problems. Try looking under the hood in the dark with the engine running and see if you see any electrical arcing around the spark plug wires or just go ahead and replace them if they are old. www.RockAuto.com AnswerIt might just be a clogged fuel line/injector/ or pump, try to put some fuel cleaner in tank the next time you fill it up and see if that helps. AnswerThere are about a million and a half things that can cause this some minor, and some quite serious. First off I would have to agree with both of the previous answers but I would also have to check out a couple more things such as the MAP censor,and the o2 censor. Also adding a can of "Sea-foam" to your gas really couldn't hurt either. Good luck AnswerCan low idle speed cause this too? AnswerMy car idled rough onced and shook horribly through the whole car when I accelerated or was just pressing the gas. When I let go it would go away for a sec then come back. I put fuel system cleaners in a few times and that didn't help. After I had replaced my spark plugs it still was rough.I found later that there was a mis-alignment(TWO PIPES WERE NOT CONNECTED) in my exhaust pipes and the flow of exhaust was interrupted. Which was the cause of the shaking.
So check you exhaust for a funny noise that could be an interruption in the exhaust system. In my case some of the exhaust was leaving toward the engine with a powerful force and shook the car where the engine roughly is, which lead me to think it was the engine.
Answerspark plug fouled or coil pack bad Answeracura integra ls 1994. my problem was the spark plug wires they looked ok, but were wore out.Answer
could be coil pack, head gasket, fuel pump, or bad injector
RockAuto gave the most extensive answer, sorry, but you have to start with the basic's. A good way to check your EGR : start the enging, stick your finger under the EGR; you should be able to feel the diaphragm. Tap the throttle a few times. If the diaphragm moves, it's probably good. Secondly, nobody mentioned vaccum. Fill a spray bottle with water and spray all around the intake. If the engine idle changes, the problem is an intake gasket. Your idle will be rough, then smooth out. Check all your vaccum lines too! These are all things you can check without doing anything to the motor.
You may consider buying a scanner and pulling your codes. This will tell you the circuit your problems are in.
If you pull the o2 sensor, sometimes they are clogged and you can clean it and put it back in. But for the trouble of raising the hood, replace it while you are there!
AnswerI have a '99 Hond a Civic LX and my car was also idling rough and 'sputtering'. The mechanic used some 'Seafoam' on it and that helped a tiny bit. Then he said it might be the a/c compressor clutch. But compressors usually last a long time. I also noticed it only sputtered when my A/C was on. So the problem was with the A/C. I tried adding a little freon thinking it was low since it had never been recharged in 115k miles. This did little to nothing. I added some PAG oil and this helped more. The A/C would get cold for a few minutes and then heat up and go back to sputtering. So I had a free A/C check done on it and it was the condenser fan assembly. Apparently the motors go bad after awhile. It was getting stuck and not kicking on and that was what the sputtering was from. So they hit it with a hammer and it kicked right on and now it is super cold. So whenever the motor on the condenser fan is completely shot I will buy a new one but for now it is fine and working. By the way, you should never try to add freon or PAG oil yourself because then the levels are off and might put too much pressure on the A/C system. My next step is to have it evacuated and recharged and I'm good to go!
How do you verify the plug wires are hooked to correct spark plugs on 1991 nissan maxima?
your distrubator is numbered and your plugs if you start at the front of your engine toward the radiator the plugs are 2,4,6 and on the fire wall side the plugs are 1,3,5
Why does the alarm keep going off on a 1994' Nissan maxima?
Replace the battery, yours is likely old and weak, wont hold a charge. I havent had the problem re-occur on my 93 Maxima since i replaced mine. Many electrical weirdness problems can be due to a weak battery.
How do you change the fog light bulb on a 2000 Maxima?
how do you replace a bulb in a fog light on a 2000 maxima?
Where is the PCV valve for the 1999 Nissan Maxima?
The PVC valve on a 1999 Maxima is located in the rear valve cover just behind the throttle body.
How do you tell what ignition coil is bad on 1999 maxima?
Unplug ignition coils one at a time until you find the one that doesn't effect the rpm's.That's the one that's bad.
Is there valve clearance on a 1987 Nissan Maxima?
The 1987 Nissan Maxima VG30E engine uses hydraulic valve adjusters (also known as "cam followers") which cannot be adjusted. Therefore, there is no specific valve clearance. If you hear valve noise, it could indicate that there's either excessive wear of valve train parts or clogged hydraulic adjusters.
How many gallons does the gas tank in the 2002 Nissan Maxima hold?
The gas tank on the 2002 Nissan Maxima holds 18.5 gal..
They are not screws they are bolts either 1omm or 13mm
How do you know the wheel barring are bad?
A grinding or abnormal noise at the wheel is a good sign the bearing is bad. Unload the bearing by moving the vehicle left or right while moving. If the noise comes and goes when doing this, the bearing is bad. The only positive way to verify this is to remove the bearing and look at it. Pitting, scouring, and any other signs of wear indicate the bearing needs replacing. Be sure and replace the race if it is not perfect.
How do you adjust the neutral park switch so the starter will work?
loosen the hold down screws and adjust it
How do you change the rear brakes on a 1999 Oldsmobile Aurora?
Disk brakes on rear? My 96 aurora was simple The disk brake slave cylinder has to be screwed in after you get the caliper off. After that its just like any other disk brake pad replacement
Can you put a 1997 Nissan Maxima rims into a 1995 Nissan Maxima?
yes All 95-99 Nissan Maxima's have the same body (A32B) and same lug pattern and offset.
