Brake Fluid and Lubrication

this is a guess but most Proteges use DOT3

If the can says DOT 3 , Dot 4 or DOT 5, it is suitable.- Brand name does not matter.

if a brake caliper locks up, you can buy a kit to rebuild from any auto store. but the best way is to replace it. they do not cost that much, depending on vehicle,

If you are asking where the brake fluid reservoir is located then, it is located right above or beside the brake Master Cylinder. The Master Cylinder is located on the driver's side near the firewall. It is mounted just in front of the brake booster.

brake fluid leaking from a brake drum indicates the brake slave cylander on that wheel is leaking and needs to be replaced you will not see the actual leak with out removing the brake drum

where is the brake fluid on a Honda odyssey van

DOT 5 is best, do not mix or use dot 4 or dot 3/

pass rear,driver rear,pass front,driver front

Rear right, rear left, front right, front left.

Dot 3 or Dot 4

If you look at the cover on the brake fluid reservoir, it should read DOT 3

DOT ( 3 ) brake fluid

1) As an emergency measure, you refill your master cylinder with brake fluid to drive the vehicle to the nearest repair shop. 2) You let the pros fix it. Period. I'm not kidding - your brakes are too important to your safety - and others! Get it fixed!

Change in steps Get a Turkey baster and syphon brake fluid from master cylinder and refill with new Every time oil is changed Take out the moder cap, and then pour in the fluid.

The brake fluid on a Renault Megane Coupe goes in the brake fluid reservoir. This can be located under the hood in the engine compartment.

No.

DOT 3 - I doubt you can find anything less than this.

The Owner Guide shows Motorcraft high performance DOT 3 brake fluid

According to the 2003 Ford Explorer owners manual :

( DOT 3 brake fluid , meeting Ford specification ESA-M6C25-A )

over time it will ..

Buy a bottle of DOT 3 brake fluid. Find the reservoir, which is in the engine compartment right in front of the brake pedal. Clean the reservoir, open it and add fluid until it reaches the bottom of the filler neck.

the brake fluid reservoir is in the back of the engine on the driver side, you will need

a thin and long funnel that it will reach the neck of the reservoir, carefully add fluid,

allways checking the level.

With a helper, pump the brake pedal several times then hold it down. With the pedal down, loosen the bleeder valve on one caliper until the fluid runs. When the pedal gets to the floor, close the valve and repeat the process. When no air comes out with the fluid, repeat for the remaining three wheels.

Usually every year or two you need to change it check your owners manual for their specifications

Make sure that you have a proper kind (check the manual). Locate the master cylinder, it's attached to the firewall on the driver's side (under the hood). It has a removable top on it. Remove the top add required amount of the fluid (the container where you are going to add the fluid in has marks on it). Put the top back and tighten it properly.

Well, the engine in a 1974 vw Beetle is in the back of the car. So the brake fluid in front or the back to the left of the right.