Bumpers

Unscrew it.

No, they're 2 totally different grilles

Very carefully

Jimmy out!

While there is no right way to parallel park, there are several unwritten rules to parallel parking that everyone should know.

Rule#1

Never upset another parallel parker, especially if they park in front or behind you. Some things that upset other drivers are (a) not leaving them enough space to manuever out of a parking space (b) parking your vehicle with your front bumper mashed into their rear bumper.

Rule#2

To keep your bumpers safe when parking, never park in a tight space and always give other cars enough space to exit a parking spot. A driver that's locked into a parking spot is like a caged animal...they will bump your car as many times as needed.

yes it will

That depends on how well you want it done. If you know someone who can do it? 230-400 bucks. And if not, then repair companies can charge up too 600 dollars. Painting it is not cheap and neither is the bumper

yes. the chrome molding is a separate piece. held on with metal clips. it must be installed with the bumper off.

It is recommended that you should use new hardware because of the rust and wear and tear on the old hardware. If your looking to be as economically mindful as possible then you can use the old ones, but it also a lot easier to just get new ones and install them

Fender is on the side of the car, over the wheel. Bumper is on the front below the grill running from side to side.

Step 1:

Grab a screwdriver and a manual

Step 2:

Remove the bumper light according to manual

Step 3:

Replace the light

a fencing team member

it increases i think hoped i helped :)

18 feet, 8.7 inches

Unbolt it. Careful, it's heavy.

On the bumper there should be a wiper arm. If you then press it down, it should be come off quite easily. Also, it would help to bring the car in to a mechanic.

12" x 3"

Take the front grill out, The grille and headlights came off to get at screws at the front end, remove the three plastic plugs under the grill, and remove the splash guard under the bumper, jack up front of car and remove front wheels. Take the majority of inner wheel arch retaining bolts out and fold the front back out of the way (don't take it out completely) Remove the engine under-tray. Remove the two 10mm bolts fixing the bumper to the wing on each side (bit awkward to get to but not too bad). Remove the bumper, note you need to push the sides down first as there is a pin that locates them. Fit the new bumper.... bolts, plugs etc, line up and tighten. Refit everything else.

Remove headlights and grill. grill has a torx bolt each side, and undo retaining clips on the headlights where it clips onto them each headlight has a torx bolt behind at the back under where the wires go in, and 1 torx bolt on the top, and one behind the grill.

under where the grill was there is 2 or 3 black round push clips.

Remove the engine under-tray

You don't. A trademark is a brand -- it does not protect the expressive content of a bumper sticker.

it wont make it any faster but it will make it shift harder. if its an automatic it you will really be able to feel the shift. all it does is make it shift faster. this actually causes less wear to the transmission.

you can, but it is always better to clear the complete bumper, If you don't want to then you should end the clear under the license plate

yes he is

Easy to find out. Drive down to you local Jeep & Ford dealer with a tape measure in hand and measure them.