0
Chevy Camaro Z28
This category covers questions about the Z/28 custom option for the first generation (1966-1969) Chevrolet Camaro. The Z/28 option featured a 302 cubic inch small-block V-8 engine, a 3 inch crankshaft with 4 inch bore, an aluminum intake manifold, and a 4-barrel vacuum secondary Holley carburetor. The Z/28 also came with upgraded suspension, racing stripes, and "Z/28" emblems.
3,093 Questions
Where is the coolant drain plug on a 1999 Ford Contour 4-cylinder?
being a technician, i have never located one! we hook a machine up to the upper radiator hose or you can disconnect the heater hose located under the car on the passenger side, but that's quite a mess.
well u have to take the lower radiator shield off, the drain can be taken out with a flat head screw driver the plug is right below the lower radiator hose
What is the difference between SS and the SS Trust Fund?
Social Security is the whole of the system. The Social Security Trust Fund represents that money that has been paid into the system, but has not yet been paid out, and since you can't just leave a big pot of money sitting out around politicians, they've since stolen and used to fund other government programs.
Okay, "stolen" might be too harsh a word, but it's looking increasingly unlikely that they will ever be able to pay it back.
There can be several answers to this question depending on specs, upgrades, etc.
Talking stock, and assuming that compared to any other TPI engine that this is indeed a problem the most likely cause is a vacuum leak.
If the vehicle has a big cam, (not stock) that's just how some cams idle is a real lopey idle.
It could also be detonation. The corvette is equipped with a knock sensor, so if there is any sort of tapping in the engine, whether this be from a problem, a deserved tuneup, or even if you tapped the engine with a wrench, the knock sensor will try to compensate by changing the timing of the vehicle slightly. This with change the vehicle idle up and down.
probably your ECM malfunctioning i just fixed the same problem on an sl1...it was a new starter... the starter over heats and is non op... or try a coolant temp sensor with new connector is a common problem aswell
Where is the Radiator drain plug on a 2002 alero with a 2.2 engine?
There isn't one. To flush my radiator in my 2000 I had to take off the lower rad hose.
a bad sinkero inside the trans
i would suggest checking your fuel pressure. I just had a similier problem with my 98 tj and i replaced the cap, rotor, plugs, wires, up and downstream o2 sensors, and fuel pump. i still had a problem so i plugged in an odb2 sensor and i pulled codes for injector misfire. So what i ended up doing was replaced the o rings on all 6 injectors and bought a can of 50.00 fuel injector cleaner.... my jeep now runs fine... needless to say i spent about 500.00 dollars on parts i really didnt need.
The 1988 Honda Accord coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.
Ford likes to run a GEM ( I rememebr General Electrical Managment) module This is used to control things like windows, heater, I believe seats, maybe a bad GEM?
Why does security light come on and not let the car turn on 1994 Chevy Camaro?
My 1994 Camaro is in San Jose with this problem and they are hoping to figure this out.....they say that the most common problem with this is that there is a wiring problem that has either shorted out/disconnected or the ignition system is just not reading the "chip" in the key itself and it may be in need of repair......I'll find out more today as they, at this moment are "looking at it now"........We'll see! I'll hopefully find out the true answer today and I'll post it here..........also let you you know what it cost me for this answer!!!!!!!! ==Headline== The problem with the camaro was that the connector to the ignition switch literally came apart-broke off-whatever....anyway the fix was to solder the wire back to the switch and its now as good as new!
What exhaust is best for a 1997 V6 camaro?
V6 engines dont sound as good as a V8. If you start putting exhaust on V6 engines, it will sound bad and it is not recommended by most shops. I prefer a Flowmaster Cat back system, simply because it sounds awesome. Nice rich rumble without being too loud. I've read, however, that the performance increase isn't very much over stock. I think Flowmaster feels differently, though. I've also tried the much more expensive Borla Cat back system. Its much louder, and harsher sounding. Plus, there is an unpleasant reasonance inside the car between 40-50 mph. If performance is what you want, then you should consider the Borla. Also, its stainless steel and guaranteed for life. I've also tried a "dual" exhaust cobbled together at a local muffler shop. The system looked bad, compared to the factory made Borla or Flowmaster. It also rattled and simply wasn't engineered as well as the others.
How much is the insurance for a 2010 Chevy Camaro?
It all dependd on if you have a good driving record, your age, and the company so call the company and get a qoute
What kind of transmission does the 2012 Chevrolet Camaro have?
The 2012 Chevrolet Camaro has a 6-speed manual.
Where is the speed odometer cable at on a 19996 geo prizm?
it starts at the transmission near the firewall, runs through the firewall directly to the speedometer. you have to remove the combination meter(where the speedometer and guages are) in order to remove it.......this is not for amateurs!
Take the steering wheel cover and pull the switch up.... most likely your stuck.
What type of transmission is in your 92 camaro rs automatic?
should be a 700r4 dont quote me on that though
Can you put a late model 5 speed into a 67 camaro?
It can be done but you might have to modify your tranny tunnel to do it.
it depends on which line is it the shifter line, or is it the lines that go to the trans coller? if it is then they should all have factory quick disconects that usually slip right in to place the two person didnt need to disconect them if you have more prpoblems contact the tow company and complain that they fudged up your car.
