0
Chevy Vans
The Chevrolet van is a term that refers to the entire range of vans manufactured by Chevrolet. The first Chevy van was launched in 1961 on the Corvair platform. The latest model of the Chevy van is the Chevrolet Express.
641 Questions
What engines were available for a 1984 Chevrolet van?
305 and 350 V-8 engines. I think some had the V-6 too.
Where is the fuse block on a 1996 Chevy S-10?
Drivers door must be open to gain access to the fuse center. It is at the far left side of the dash behind the small removable access door.
Step by step instructions on how to remove an alternator from a 1991 Chevy step van?
1. find it
2. remove it...? sorry, no idea :/
1988 Chevy van idling high at all times?
It could be a vacuum leak. The gasket under the throttle body was known to let go and create a large vacuum leak causing engine to idle high.
You are looking for a vacuum line drawing for a 1995 Chevrolet Astro van?
1995 cherolet astro van 4.3 get gas psi 35.has spark,fuel pump working find.no, gas going throught the spider injector.injector wires get power.what could cost that wouldn't start the engine.
How do you remove fender from 1990 Chevy van?
The fenders on these old style vans were welded on. You'll have to drill the welds out to get it off.
Your battery reads good but sometimes the van won't start?
I have a 1998 Chevy 1500 conversion van. sometimes the van wont start when its cold and i just have lights. I had the battery checked and it is good. what do you suggest?
How many quarts of oil to change in a International 8100 truck made in 1990?
Check owner's manual. If you don't have one copy and paste link below; www.fleet.ford.com/maintenance/owners_manuals
89 Vans/trucks had a fuel pump relay,the contacts may be corroded. It may be located in the fuse compartment, as in the pickup. A trip to, or phone call to your Chevy dealer's repair department, and they'll let you know for sure. Clean the contacts, and reinstall it. If you still have the same problem, you may need to replace it. (About $20.00). If that doesn't solve the problem, you may have a faulty fuel pump. They, are not cheap!
How do you change the fan belts on a Chevy G30 van?
The ac, power steering and alternator will have separate tensioners (the units slide on a bracket to tighten) if they have separate belts. Loosen the units and the belts will come off. If a serpentine belt is used there only one tensioner.
How can I find where the hi top on my Chevy van is leaking and How do I repair it?
I had the same problem on my 1984 chevy van, in the right rear corner there was water leaking in. I understood right away that there was a lot of work included in fixing it and quite sadly the build quality of the work mounting the roof was very poor..
The first thing to do is considering how to strip down the light ramps and any other accessories in the roof. Both electrical stuff such as lights, antennas and speakers in order to avoid cables following the top when lifting it, you may have to lift it all the way off the van or maybe just put some wooden planks across the top edge of the van between the glassfibre top and metal body.
So start with stripping down the interior around the overlap between the top and metal body. Disconnect (cut) any wiring (repair them later with soldering + heat shrink or other prefered method) then start removing the rubber/plastic lining around the outside aluminum strip holding the top in place. Remove all the screws and the aluminum strip. Then try prying the top upwards until it comes loose from the old sealant.
Inspect for rust, you may need to weld in some new sheet metal, I had to replace a lot of it on my van.. Remove all the old sealant (get some new one first) make sure the surfaces are nice and clean. Then smear on lots of new sealant on both the van and the roof surfaces, better off using too much than having new leaks later needing to make all that work again.. Use heavy duty rubber based or some sillicone sealant, make sure it will handle the enviroment such as high temperatures in the sun and cold winter climate. I used sealant for box truck wall edges. I think windscreen sealant may work too, but wouldn't recommend it.
Then lower the roof back on to the van, make sure that it fits nicely and that some excess sealant pushes out both on the inside and the outside. Then reapply the aluminum strip for the screws (use stainless screws that wont rust) you may want to put some sealant in between the strip and the van in order to make it stay tight. Drill new holes in between the old screwholes with a drill slightly smaller than the screws you intend to use, this way you will eliminate the problem with bad sync between old screwholes trough all the layers. This saves you a lot of trouble.
Inspect it all and if it looks good, then put the rubber or plastic lining back in the aluminum strip to cover the screws.
When it's confirmed that there are no leaks after the repair work (and if there are, just inject some sealant where needed) you may start to reassemble the interior in the reverse order.
When it's all done and put back together you'll be happy and proud with the accomplishment :)
You may want to check all windows for leaks too, windshield, rooftop and the doors, the rubber seals dry with age and may have shrunk a bit letting water in.
The metal around the windows may need inspection for any rust including the windscreen that is known to both suffer from leaks and rust. You can use the sealant that you used on the roof to put in all critical areas where water may pass trough in order to make a complete sealing and keeping the water outside.
I hope that this answer is good and wish you good luck with the work, it's easy if you're 2-4 persons extra to do the work and remember, it's not impossible to do!
Cheers from Sweden!
How do you remove the carrier bearing from your 1989 Chevy three quarter ton van?
Remove rear cover and drain oil. Remove rear wheels and break drums. Remove center pin between axles by unscrew pin in carrier. Push axles in slightly and remove 2 C clips. Pull axles out. Remove 4 bearing cap bolts. Use large pipe or jack handle to force carrier out. Do not let it fall. Use puller to pull bearings off
What is the miles per gallon for a 1999 Chevy astro van?
My 95 Chevy Astro van averages 15 mpg in the city. I do not know what it gets on the highway. It has a 4.3 L V6.
Where is the power steering reservoir for 1984 Chevy van 30?
The washer fluid reservoir in the middle under the hood slides forward and out. Once you've pulled it off its tray, move it to the side and you'll be able to see the power steering reservoir below where the washer fluid was.
How much does it cost to balance tires?
walmart $5 a tire
Another Answer That depends on where you purchased the tires. Many places include free lifetime tire balance when you purchase tires from them. Other places will soak you for quite a large fee for mount and balance when you either purchase the tires or have them changed. Caveat Emptor
What is the difference between a 1986 Chevy van c20 and the 2500?
C20 was Chevy's designation for a 3/4 ton. 2500 was GMC's designation for a 3/4 ton. Basically they are the same.
How do you replace the blower fan in a 1994 Chevrolet astro van?
It is on the right hand side of the vehicle near the right fender. You lift up the hood, locate the blower motor, remove screws and replace it. Should be able to find it visually. The fan is attached to the blower motor shaft. It can be removed off the motor after the assembly is removed from the vehicle.
Where is the o2 sensor bank 1 sensor 2 located on the 2006 Chevy uplander 3.5 liter?
The one after the catalytic converter.
How do you change 1994 Chevrolet astro van steering wheel?
You should be able to pull off the horn button in the middle. There might be a wire going from the button to a hole in the steering wheel, just push in and rotate to remove it. There should be a clip that you pry off. You can the use a steering wheel remover to pull off the wheel.
The 1994 Chevy Astro EXT van has 4 bolts behind the steering wheel/airbag/horn assembly to remove the horn/airbag assembly.
Where can you get a wiring diagram for the stereo in a Chevrolet Astro van year 1999?
Go to your local parts store and ask them for a Haynes repair manual for the year and type of your vehicle. It costs around $17.00, and although it is not the best, there is enough info in there to get your stereo wiring figured out. Chiltons also makes manuals, plus there is always the dealer. Sometimes even the dealer will print out a page of schematics for you. It just depends on their generosity.
