0
Chrysler 300 Series
The 300 “letter series” are high-performance cars manufactured in the US by Chrysler Corporation from 1955 to 1965. The cars are available as a two-door coupe and a two-door convertible.
1,224 Questions
Is there a left and right turn signal switch on a 1994 Mazda B4000?
Yes look in your manual it will show you were it is but if your having a problem its more likely a wire than the switch.
What type of oil does a 2007 Mitsubishi Lancer use?
Pennzoil's Lube Match says 5W30.
Always check your owner's manual or the sticker on the inside of your hood to be sure of the recommended oil type for your particular engine. Using the wrong oil could cause engine damage.
Lost keys to 2005 Hyundai elantra have spare key but alarm goes off when door opens HELP?
Unfortunately, most new cars have to have a factory level tool that can "talk" to the car's computer to correct this condition. Many good locksmiths can also reprogram the keys.
How to Replace door speakers 300m?
The front door speakers are very easy to replace... The Grill covering the speakers just pops out: Open the door. pull out on the grill from the hinge side of door toward the latch side of the door. Then remove three torque screws. and disconnect the wiring harness. The front door speakers are 2-ohm, bass-channel. Most off-the-shelf speakers are either 4-ohm or 8-ohm multi-way speakers.
Where is the oil sending unit on a 2001 Chrysler 300m?
Next to the oil filter - closer to the front of the car
How can you turn off the airbag light on a Chrysler 300?
The airbag light stays on when the computer has detected a malfunction and set a code. The failure will need to be repaired before the light can be reset.
How do you replace the ignition lock on 1966 Chrysler 300?
First, remove the retaining nut, which is around the lock cylinder. It requires a special tool that is probably impossible to find now. I would recommend inserting a small flat blade screwdriver in the slots and carefully turning it. After that, push the switch towards the rear of the dash and remove the electrical connector. The connector is held on by two plastic tabs on the back of the switch. If you want to remove the lock cylinder itself, reinsert the key and turn it to the run position. Press down on the small pin in the top of the switch. With a little persuasion, the lock cylinder should come out. Replacement of the switch should be in the reverse order. I know this because I recently had to replace my ignition switch also.
How do you replace the serpentine belt on a Chrysler 300M?
On a 2001 300M you use and 18" ratchet extension, or combination of extensions, to loosen the tensioner. You can loosen it by loosening the center pulley bolt from the top. Then from under the car, use your ratchet and extension and turn counterclockwise in the tensioner bolt. This will allow you to remove the old belt. Do the reverse to replace the belt. I also remove the bolts from the crossmember body piece, like you do to replace your headlights.
Timing belt broken 2000 chRysler 300m 3.5 liter?
Well if you haven't already found out by this time I can answer this.. First off the 3.5 is a throw away engine. once the timing belt snaps it bends the valves. So here are your options; replace cam assembly, make sure pistons arent damaged or replace engine like I had to do.. Was cheaper for me to get used engine and put it in myself. Or toss car and get a different one... Hope that helped..
Where is the fuel filter located at in a chrysler 300c 2006?
It is part of the left side pump module in the tank.
How does multiple displacement system on 5.7L V8 SFI Hemi Engine work?
If the Mopar system works the way others I am aware of work, it's actually quite simple. The engine computer senses when the vehicle is under a light load situation, such as steady speed highway driving, and it shuts off fuel and spark to as many as 4 cylinders. Then engine only uses the remaining cylinders to make power, using less fuel to do so. When it senses a need for more power, it will turn these cylinders 'on' again to tap the available power that the engine is capable of making. This process effectively cuts the displacement of the engine from it's full 5.7L to as little as 2.85L depending on how many cylinders it cuts out.
Through the use of solenoids and oil pressurte it also "shuts off" the lifter to those 4 cylinders
Air bag light stays on for my Chrysler 300?
So does mine, the dealer told me I needed a new air bag, so I had one installed. The light went out for about 2 weeks then came back on again. The light has played on again off again, for a couple of years and thousands of miles. next it was the check engine light that played the on off game. then it was the cruise control indicator light that started playing on-off. I am now taking the car to the dealer because the, gas fill indicator light, engine rpm indicator light , the clock, and the vehicle speed indicator light have went out. Mine is a 2003 300M with 219,546 miles.....looks really good.....runs good.....drives nice, just has a wiring problem. I bought it in 2005 with 37,000 on it.
What does code P0700 mean on a Chrysler 300?
The PCM stores P0700 when it detects a code stored in the tcm. You need to check the transmission computer with a scan tool to know possible causes.
