0
Dodge Durango
The Dodge Durango was a full size SUV (sport utility vehicle) manufactured by Chrysler for the Dodge brand. Produced in the company’s assembly plant in Newark, Delaware, this 8-passenger vehicle was initially powered by a 5.9 liter Magnum V8 engine.
3,297 Questions
Where is the voltage regulator in a 2000 dodge durango 5.9 v8?
it is part of the pcm power control module. it is located next to the air filter box and has three plugs going into them
How do you change brake bulb on 2011 durango?
2011 Dodge Durango brake light bulb lamp replacement procedure: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb lamp replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Why would your headlights on your 2000 dodge durango not work if the fuses and the bulbs are fine?
Your wire connection to your headlights from your fuse box might be loose or broken somewhere. Try running a jumper wire from your headlights to the fuse box. If the headlight work when you try this, then your wiring has an open circuit and needs to be replaced, or fixed.
What year did dodge come out with cylinder deactivation on hemi engines used in truck SUVs?
Started with the 2005 models, 300, Magnum and pickups.
Have 2000 Durango am getting code PO207 Switched injector 7 and 1 still get code PO207 What next?
Are you sure you are changing injector #7? Should be the injector closest to the firewall on the drivers side. If you are changing the correct injector, and the code remains, the problem is with the wiring from the injector to the pcm (computer) or the computer itself. You can check for correct battery voltage at the injector with a volt/ohm meter (how does the connector look at the injector?). This year of Durango/Dakota had trouble with computers too, although I have not heard of specific injector trouble being caused by the computer. Most likely a wiring problem.
It may even be the TPS
How do you reset keyless entry on a 2005 Dodge Durango?
Thanks to no help from Chrysler or Dodge....I ended up figuring this one out for myself. I hope this will help you out. Start your Durango and leave it running for about two minutes. Once you do this, press both the lock and unlock button on your keyless entry (key fob) and do this three times, each time holding it pressed down for about two seconds each time. After this, your keyless entry should be reset and working. This had to be done on my Durango after I changed my battery.
How many oxygen sensors on a 2003 4.7 liter engine dodge durango?
any car after 1995 has two, or four oxygen sensors,as they use OBDII system
On your 1997 f-150 will faulty speed abs sensor cause check engine light to stay on?
Possibly. _________________________________________ Auto Zone will check your engine light FREE... In addition, tell you exactly what is causing you problem. No more guessing.
Changing a fuel filter in a 99 Dodge Durango?
The fuel filter is part of the fuel pump assembly located in the gas tank and cannot be changed independently. Your fuel pump will fail at about 100K miles, so you will change it then
Where is the fog light relay on a 1997 Pontiac Grand Am?
The relay is under the hood there is one for each headlamp and one for each fog light
How do you replace the water pump on a 1999 Chevy Malibu V6?
on a v 6 motor the water pump is located just above the air comperssor with a diagram of the belt route take the 4 outside pulley bolts loose first then take off serpentine belt it makes it easier to hold the pulley then 5 bolts holding the water pump
1. Take timing cover off. 2. Take motor mount off. 3. Take harmonic balancer off. 4. Take water pump hosing off.(7 bolts) 5. Take timing chain techner off. 6.take three nuts off water pump, pull water pump out and replace.
sounds like the above answer was confused with a chrystler product...you shouldn't listen to people like this.........they do not know about the simplicity of gm products...and who puts 7 bolts on a coolant hose..PLEASE!!! there are only a few bolts, no need to undo hoses, just pop belt off (let dangle) and unbolt the water pump,after draining coolant to a suitable level, replace pump and gasket (with sealant) and reverse dissassembly (new pump does not come with pulley, so be shure to swap it out to the new pump)
Actually, sounds like the above answer was confused with a 1999 Malibu w/ the 2.4, where the water pump is a (roughly) 7 hour job.
I just changed one of these pumps on a 3.1 v6 last week. It's realy quite simple. After you loosen the belt and remove the water pump pulley ( it's the top front pulley ) You will see the water pump mounting screws behind the pulley, remove these 5 screws and the pump comes right off. One important thing to know is to remove small brass bleed screw where top radiator hose hooks to motor while your refilling system with coolant, then put the bleed screw back in after coolant squirts out the bleed hole.
The above answer is 100% correct... it will be a 30 minute job tops if ya aren't a screw up. 45 minutes if ya are
How do you replace the air filter on a 2001 Mercury Cougar?
Pull the snaps undone, on the air filter cover, underneath lies your airfilter, then remove and replace.Then put everything back the way you found it.
How do you adjust the doors to close tighter on a 2004 Dodge pickup?
If it is loosing the seal around the top of the window, use a strip of paper or a dollar bill and shut it in the door where you think it is not sealing tight from the outside of the truck, pull the bill out. If it comes out easily, then roll down the window with the door open, put your knee into the door and use both arms to pull on the door frame where it isn't sealing tight. This was the suggested fix from my local ford dealer when I had fords. It did work. They said it is caused from slamming the door. They had seen chevys that had popped the paint off the door panel from the flex in the door when pulling it shut and slamming it.
How do you replace the air filter on a 1995 Villager?
There is no cabin air filter on a 1995 Villager.
Is a central AC supposed to leak water inside of a house?
Condensate always forms on the evaporation coil and the amount of water depends on the dew point and the temperature of the coil. All air conditioner installations are supposed to include a drain line for taking the condensate away, possibly to a floor drain.
last one to touch it is at fault!! take it back & make them fix it.
Why might turn signals not be working?
Check bulbs and flasher if all are out most likely flasher is bad Check bulbs and flasher if all are out most likely fuse or flasher is bad
How do you replace the blower motor solid state resistor module on 99 dodge durango?
You have to remove the wipers and the cover that's underneath them. There is a hole on the passenger side that allows access to the resistor from under the hood.
How can you replace upper radiator hose on 2000 dodge caravan?
1. Get a new radiator hose
2. Turn off your car and let it cool down
3. drain your radiator below the level of te hose you are replacing
4. remove hose clamps and take off old radiator hose
5. install new radiator hose and tighten hose clamps
6. Fill radiator with antifreeze / water mixture (you can buy the premixed kind if you dont want to mix it yourself)
7. replace radiator cap
8. turn on car and check for leaks
