0
Dodge Durango
The Dodge Durango was a full size SUV (sport utility vehicle) manufactured by Chrysler for the Dodge brand. Produced in the company’s assembly plant in Newark, Delaware, this 8-passenger vehicle was initially powered by a 5.9 liter Magnum V8 engine.
3,297 Questions
What are Code p0300 p0306 p0308 for 2003 Dodge Durango?
P0300 Diagnostic Code - Random Misfire
Symptoms.
Engine may stumble or miss
Engine may be hard to start
you may notice no issues
Cause
Failing spark plugs or spark plug wires
Bad coil or coil pack
Failing oxygen sensor(s)
Bad fuel injector or more than one
Stuck exhaust valve
Bad catalytic converter
EGR valve or valve passage clogging
Bad camshaft position sensor
Bad PCM or ECM
The Fix
Best first action is a tune up, new plugs, wires, inspect all hoses and wire connections then reset the code. If it returns you will need to narrow it down to a system, coils and coil packs should be tested, catalytic converters for function ( do you smell rotten eggs?). A misfire that jumps cylinders could indicate a lean condition, do you have any other codes along with the 300? this will help clue you in to the source, check valve function to make sure they are opening and closing fully.
This is probably pone of the most difficult codes to troubleshoot, so start with the basics and work your way into the more expensive options, in many cases a good old tune up solves the problem, back it up with a fuel system cleaning and see where you stand.
Will a camper shell form a 2000 dodge fit a 2007 dodge?
No it wont fit , I just tried myself 00 shell on my 07 the back of the cab has a bow to it on the 07 so even if you butt the shell rite next to the cab there is a large gap between the cab and the shell and it hangs off the back of the bed a fue inches. and also the glass door wont close becouse the tail gate is diff...hope this helps....Sonny
Is there any emergency trunk release for a Dodge Intrepid?
Yes there is! If it's a later 99 model! Just spent several hours crawling around in my trunk looking for it. There should be a small white plastic cord in between the top latch and bottom latch. Use a small metal tool or something you can slip behind it, and pull, HARD
2000 park avenue headlight replacement?
Its simple i just did it,get a screw driver thing and undo the 2 screws.
Some like a 97 or so might need a allen wrench but still its only 2 screws and wiggel it off an your good to go just remove the old lights and put the new ones in...simple quick and easy..have a nice day.
Where is the oil pressure gauge on 2003 a Durango?
Are you sure it actually has one? Most cars don't. Perhaps this is why you can't locate it.
How much does a pcm cost on a 1999 Dodge Durango?
From the dealer here in Utah it costs $602. It costs $194 to have the dealer program it and install it. From reading on the issue, you can take your old PCM to NAPA and have it sent off and refurbished for $298. It sounds like it's very easy to replace it once you get it back. The downside is that it takes a couple of weeks to do it this way, but it's very inexpensive and it's already programmed when you get it back. Also, I have run into alot people on the internet that were able to purchase a refurbished PCM for their 1999 Dodge Durango's from third party websites for between $200 and $300. It took a week to get it, but saved them $500 in the end. It takes about 5 minutes to replace your PCM yourself and is very accessible. -JB
Where is the vapor canister on a 2002 Dodge Durango?
I read that it is on the outside under the drivers seat.
What wouuld cause a Whistle noise from under dash of dodge durango?
The air conditioners intake it under the passenger side dash all the way in the front. Some times receipts or plastic bags can get sucked up there and cause the noise.
-Gary
Why does car act like it wants to cut off when taking off?
spark plugs of spark plug wires. i had the same problem and i changed my spark plugs to the e3 ones and my spark plug wires to the msd 8.5mm wires and i haven't had the problem any more.
How do you replace the thermostat located on a 1998 Dodge Durango?
located at the end of the upper radiator hose. remove two bolts, replace with new parts remember to replace the gasket.
I would check to see if there is a switch down by the brake peddle. If the switch is bad it won't let current get to the lights. I would try bypassing the switch (if there is one) and see if the lights come on.
How do you replace the water pump on a 2000 Chevy Cavalier 2.2L 4 cylinder?
It's actually not a hard job to do on these motors (2200 4 cylinder)
1. with the serpentine belt still in place take a wrench and break loose the 3 bolts holding the pulley on the water pump.
2. remove the serpentine belt by relieving the tensioner pulley. ( just takes a standard ratchet)
3. remove the alternator, there are three bolts holding the alternator in place,
two on the side that the belt is on (one on top of the alternator and one under it) and one on the lower back side of it under a bracket, then just move it out of your way (you dont even have to disconnect it).
4. remove the 3 bolts on the water pump pulley, remove the pulley.
5. break loose the 4 bolts holding the water pump to the motor, unthread them alittle to let the old coolent drain out of the motor past the pump, them remove the pump.
6. remove all the old gasket from the motor surface, use the new gasket that comes with the new pump and apply RTV to both sides of the new gasket.
7. install the new water pump by reversing the steps for removal, fill the car back up to spec with Dex-a-cool, you may wanna drive it around the block after filling to get the air out of the system, then recheck the coolant level.
then you are done!
Why would the hazard and turn signal fuse blow on a 1999 dodge ram pickup?
check for shorts in the system
How many quarts of oil does a 2002 Dodge Stratus 3.0 use 4 or 5?
With a new oil filter put 4 quarts in in it. Start it up let it run for 2 mins. Shut it off then check it.
Where is the camshaft position sensor located on a 2.4 twin cam 97 grand am?
its on top of motor front passenger side behind the throtle.
How do you replace o2 sensor on 1999 dodge durango?
If it is the bank 1 sensor its located on the manifold near plug # 1.(driver side) This is fairly easy to do, it took me a half hr to pull and replace. If it's bank 2 its right after the cat. converter extremely easy to replace. (be sure not to cut the wires unless absolutly necessary) ( you may need a special socket to get around the wires)
That's not quite right. On a V type engine, whether its an V-6, V-8 or V-10 etc, you will have 2 upstream sensors. One for bank 1 and one for bank 2. The upstream sensors are before the cat. Bank 1 is correct, the exhaust on the side of the number 1 cyl, usually the right side of the engine. Bank 2 will be the other side of the engine. You then have a sensor after EACH cat. This is the down stream sensor. If you only have 1 cat, then the down stream sensor isn't bank # 2, its just the down stream sensor. If you have 2 cats, then one will be the downstream, bank 1 sensor, the other will be the downstream bank 2 sensor. This is only for vehicles with more than one cat per bank.
How many spark plugs for a 1999 dodge durango v8 5.9 liter?
The 5.9 liter (360 CI) is a V8 type engine, thus there are 8 spark plugs.
How do you replace the turn signal-flasher relay on a 2001 Volkswagen Passat?
The turn signal flasher relay is incorporated into the emergency flasher switch on the center of the dash near the radio.
Pry off the switch cap, it clips in to the switch body and releases fairly easily. In any case you are about to remove the switch which the cap clips too, so no need to be careful with it. I found that prying upwards with a thin screwdriver released the cap easily. Don't pry against the 'wood' trim.
You will see a black rectangular rim with a red LED(push it and see) mounted in the center. Grasp the rim of the switch with a pair of pliers and pull it out of the dash. It should come fairly easily.
Unplug the connector from the back, plug the new switch in to the connector and push it back in to the dash.
The new relay is available at VW dealer for $30
How much does it cost to replace a 2003 Dodge Durango water pump?
To replace the water pump on your vehicle if you do it yourself would be about $65. To have a shop do it, it would cost $250 to $300.
What does heater hoses do on a vehicle?
a heater hose runs from intake to heater core to radiator. the heater core is were the heat comes from inside the car as well as defrost
What is the fault code P1193 for a 2003 Dodge Caravan?
it is intake air temp sensor code, either the sensor is malfunctioning or unplug,
