Ford Explorer

They are located at the end of the spark plug wires.

Don't know what your original reading was, but the O2 sensors before the cats moniter how the engine is running and the O2 sensors after the cats moniter how the cats are performing.

what is the cause of the exploration

Click on the link below

Click on Owner Guides

The Owner Guide ( which includes the fuse box diagram and location ) can be viewed online

The fuel pump is located on top and inside the fuel tank. You must drain and remove the fuel tank to replace the fuel pump.

On my ( 1995 ) Ford Explorer , # 19 is a 25 amp mini fuse for the ignition coil ,

PCM system

On a 1993 Ford Explorer :

None , unless it has been converted from R12

My daughter has replaced all the interior door handles on her 1998 Chevy Prism. We purchased new handles from a local dealer and she was able to install them herself by carefully removing the handle and reversing the process to install the new unit. However, she needs to replace an exterior door handle and we can't figure out how to start with this one.

I bought one from Ebay and uninstalled the previous one by removing the screw at the center, sliding the whole thing towards the steering wheel, prying it out a bit (at the side farthest from the steering wheel), popping out the "wire" that pulls the door opening mechanism from the plastic clip, and then prying the whole thing all the way. The wire is L shaped and goes through the yellow part (or white) first then continues to where the yellow parts meets the rest of the handle. To install, first pop the wire in, then push the whole thing in, then slide it back away from the steering wheel. Screw it in to secure.

drill peep holes first.. But drill shallow. After best guess a 1/4" pilot hole first then 3/8' the pump assembly is located from left to right, in the rear m iddle of the hump i did this to my 93 ta and it takes a long time due to the tank being so close to the body of the car. don't blow yourself up

I believe the horn is behind the " splash shield " in the drivers front fender , in front of the tire , mounted below the battery tray

No ( no turbocharger on the engine from the factory )

That depends on what model year the 4 door Ford Explorer is :

1995 to 2001 models are / or around ( 21 U.S. gallons )

2002 to 2010 models are , I believe ( 22.5 )

No , starting with the 1995 Ford Explorer the rear brakes are DISC

Going through the same thing on a 89. Pull the front of the dash off above the steering column. There are 4 screws holing in the gage cluster. Undo them and pull forward, then disconnect the cable from the gage cluster. Note: the (speedo) cable is just clipped to the instrument panel a good yank is all that is needed to remove the speedo cable.

5 w 30 ( for the 4.0 L - SOHC - V6 engine ) 5 w 20 ( for the 4.6 L - V8 engine )

They brought in diseases

yes it will

Does the engine crank ? If not , does the underhood light come on when you open the hood or the door chime sound if the keys are in the ignition with the drivers door open ? If you don't get any lights / door chime etc. it could be a bad battery cable connection or a dead battery If the engine cranks and does not start , it's either not getting fuel or spark

On a 1997 Ford Explorer :

The 4.0 liter SOHC , V6 engine ( 8th " character " of VIN is an " E " ) has ( 3 )

timing chains . A main chain from the crankshaft to the " jackshaft " and a chain

from the jackshaft to the drivers side cylinder head , at the front of the engine .

Also , a chain from the jackshaft to the passenger side cylinder head at the rear

of the engine

The 4.0 liter OHV / pushrod design V6 engine ( 8th " character " of the VIN is an

" X " and the 5.0 liter V8 engine ( 8th " character " of the VIN is a " P " ) both

use ( 1 ) timing chain

How to change mirror light/ signal on 2011 f250

On a 2000 Ford Explorer :

The 4.0 litre EFI engine ( the 8th " character " of the VIN is an " X' " ) is an

Over Head Valve / pushrod design engine and has ( 1 timing CHAIN )

----------------------------------------------------------------------------------------------------

The 4.0 litre Single Over Head Cam , V6 engine has ( 3 timing CHAINS )

( the 8th " character " of the VIN is an " E " )

-----------------------------------------------------------------------------------------------------

The 5.0 litre V8 engine has ( 1 timing CHAIN )

Yes

It's in the right front passenger footwell , by the kick panel , in the corner above the

carpet

it keeps the firing sequence

Trouble code P0125 means:Insufficent coolant temperature for closed loop fuel control.

Most likely thermostat stuck open,not allowing the engine to reach normal operating temperature,also check for always on electric cooling fans.