Mercury Topaz

it depends on its color and size. Keep in mind that topaz is more expensive than Quartz

The 1993 Mercury Topaz takes 19" wiper blades on both sides front. See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.

Most Likely A Leak, Caused By The Gasket Needing Replaced On Valve Cover. When You Install Gaskets Put In A New PCV Valve This Should Take Care Of It.

Not quite sure what you are looking for?

I believe some did come with a v-6. Most have the 2.3 L . Just remember if you do put a larger engine in the '87, you will most likely have problems with the front suspension. Also, with the added power you could just tear the front end out. These front ends are not very strong.

need diagram of rear brake lines for 1993 mercury topaz

My transmission was low on fluid. My gears would slip, I'd be driving and then I'd push on the gas and I wouldn't go any direction. I was checking my transmission fluid while the car was off and it said there was enough fluid in it. I started checking my fluid while it was running and found out I was out of transmission fluid. Once I put fluid in it, my problem went away and has been running good since.

I would be thinking it is a head gasket.

To replace the front right turn signal light, you would typically need to access it from inside the hood near the headlight assembly. Depending on the make and model of the vehicle, you may need to remove the headlight assembly or a cover to reach the turn signal bulb for replacement. It is recommended to consult the vehicle's manual for specific instructions.

The power seat belts in a 1994 Mercury Topaz are controlled by the fuse in the fuse panel under the dashboard. Consult your owner's manual or the fuse box cover for the exact fuse number associated with the power seat belts. Make sure to check the fuse with the ignition off and the seat belts in their normal position to prevent accidental deployment.

To install the front bumper on a 1993 Mercury Topaz, first, ensure the vehicle is securely lifted and stable. Remove any screws, bolts, or clips securing the old bumper, typically located at the top and bottom edges. Align the new bumper with the mounting points on the vehicle, then attach it using the same screws and bolts. Finally, double-check that all fasteners are tightened properly and reconnect any electrical connections if applicable.

Follow top rad. hose. It's in that housing.

A 1993 Mercury belt diagram can be obtained from most Ford dealerships. The belt diagram can also be found at most auto-parts stores.

Check the condition of the brake pads- may need replacement Checked the breaks they are Knew

Actually nobody knows as wire is at least 4000 years old. In ancient times, it was used for making jewelry.

On my 1993 Topaz, the transmission fluid dipstick is on the right side of the engine, near the front, just to the left of the battery. It looks a lot like the oil dipstick, but, when you pull it out, the writing on the dipstick clearly mentions that the fluid level should be checked when the engine is hot and idling, and that a certain type of Mercury automatic transmission fluid should be used to refill.

First of all you will need to snip the factory connector off near the speaker(s) you intend to replace. Then it is a matter of trial and error to get the correct polarity. If the polarity is reversed, you will still get sound out of the speaker, however, the tone coming out of the speaker will be higher (little to no bass). If that happens, reverse the wires and mount the speakers.

No. Mercury has a surface made of rock and a large metallic core. It has virtually no atmosphere.