0
BMW 7-Series
Introduced in 1977, the BMW 7-Series is the flagship car of German automaker BMW and is only available as a sedan or an extended-length limousine. This series of BMW car traditionally introduces technologies and exterior design theme before dropping down into the smaller sedan in BMW's lineup product.
787 Questions
yes there is a terminal in the engine compartment mine is by the heater control valve near the firewall on driver side you connect positive to this and negative to any good ground
How do you reset your computer?
To do this go to search>control panel>system> then navigate through the options there. This may depend on your OS but this is for Windows.
You would like a electrical schematic for a 1990 BMW 750il?
E38.org/E32 has all of the info and links.or here,http://manualspace.com/manual/search/1990-bmw-750il-shop-manual.htm
How do you reset the oil service light on a Mercedes 313 sprinter van?
turn key to 2nd setting then press km/mi twice-turn key back to 0-hold km/mi down and turn key back to 2nd setting after 10 sec or so it will reset . hope this helps
How do you reset the computer in a 1994 Bonneville?
I think you just disconnect the battery then reconnect
What is the curb weight of the 2008 BMW 7-Series?
The curb weight of the 2008 BMW 7-Series is 4486 lbs..
Where is Power steering fluid reservoir of 2003 BMW 745 IL?
wherr is the resovoir for 2004 BMW power steering fluid
How many gallons does the gas tank in the 2010 BMW 7-Series hold?
The gas tank on the 2010 BMW 7-Series holds 21.7 gal..
1993 BMW 740i not starting fuel pump location?
where is located the fuel pump for the 1994 BMW 7 series
Where are the oxygen sensors on a 1998 BMW 740il?
Theres four o2 sensors in this particular bmw. Two before and two after the cat converters.
How do you reset computer on your titan?
I have a Titan and you cannot reset the computer by diconnecting the battery. It must be taken to the Nissan dealer and have it cleared.
*edit:
ECU Resetting
Timing is extremely critical. If it is NOT DONE within the specifird time, the ECU will not reset and the Check Engine Light (CEL) will continue to remain ON. A stop watch or an analog clock with a second hand will be useful.
Operations Procedures:
1. Confirm that accelerator pedal is fully released, turn ignition switch "ON" and wait 3 seconds.
2. Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds.
2a. Fully depress the accelerator pedal (HARD).
2b. Fully release the accelerator pedal.
3. Wait 7 seconds, fully depress the accelerator pedal and hold for approx. 10 seconds until the CEL starts blinking.
4. Fully release the accelerator pedal (while the CEL is still blinking).
5. Wait 10 seconds.
6. Fully depress the accelerator pedal and hold for more than 10 seconds.
7. Fully release the accelerator pedal (The CEL light will continue to blink).
8. Turn ignition switch to "OFF" position and now you can start the car. The CEL light should be gone.
If the CEL light continues to remain ON, repeat the above steps. Timing is extremely critical for resetting the ECU.
Accelerator Pedal Release Position Learning
Operation Procedure:
1. Make sure that the accelerator pedal is fully released.
2. Turn ignition switch "ON" and wait at least 2 seconds.
3. Turn ignition switch "OFF" wait at least 10 seconds.
4. Turn ignition switch "ON" and wait at least 2 seconds.
5. Turn ignition switch "OFF" wait at least 10 seconds.
Throttle Valve Closed Position Learning
Operation Procedures:
1. Make sure that accelerator pedal is fully released.
2. Turn ignition switch is "ON."
3. Turn ignition switch is "OFF" wait at least 10 seconds.
Make sure that the throttle valve moves during above 10 seconds by confirming the operating sound.
Idle Air Volume Learning (Throttle Position Learning)
Operation Procedures:
1. Perform "Accelerator Pedal Released Position Learning."
2. Perform "Throttle Valve Closed Position Learning."
3. Start engine and warm it up to normal operating temperature.
4. Turn ignition switch "OFF" and wait at least 10 seconds.
5. Conform that accelerator pedal is fully released, turn ignition switch "ON" and wait 3 seconds.
6. Repeat the following (steps 7a, 7b) procedures quickly five times within 5 seconds.
7a. Fully depress the accelerator pedal (HARD)
7b. Fully release the accelerator pedal.
8. Wait 7 seconds, fully depress the accelerator pedal and hold for approx. 20 seconds until the Check Engine Light (CEL) stops blinking and turned ON.
9. Fully release the accelerator pedal within 3 seconds after the CEL is ON.
10. Start engine and let it idle.
11. Wait 20 seconds.
12. Rev up the engine two or three times and make sure the idle speed and ignition timing are within the specifications.
A fully charged battery is designed to maintain the parasytic load on an idle vehicle for 21 days. After that period (in most cases) the battery will have been drained and will require either charging or replacing.
Where is the pcv valve on a 1987 Lincoln Town Car?
This is a fun one. At the back of the intake manifold there is about a 6" gap between the manifold and the firewall. The PCV is back there at the base of the manifold, which is about 10" down.
Where do you put in the transmission fluid on a BMW 740 i 7 series?
it is fill to spill. fill from under neath tans. it must be pumped in. car must be runnign and trans. must be between 30 and 50 degrees "c" fluid temp. preferably closer to 30. once spilling out let drip to slowest drip and plug hole.
How do you change the spark plugs on your 2003 ford f-150 5.4 liter v-8?
Have fun. You have to pull the fuel rail to get the direct igniton off then you can get at the plugs. Tip from pro: If your CAREFULL you can sneak the coils out with the fuel rail still on. Then you can get the plugs out.
Where is the winshield wiper fuse in 740i?
If the wipers are not working it may be the wiper relay.....The fuses are usually listed in order on the top or inside of the fuse box cover.......Thats where they are listed for my 1980 733i...........Hope this helps.
How can you improve gas mileage for a 1988 BMW 735I?
Well it all really comes back to one thing, you can't punch it all of the time I know that might seem hard not to do but it's the only way that you can get "Good" gas mileage. Make sure that you keep the Transmission setting in the "Economy" mode (Represented by an "E" on the dash display). Keep the transmission from shifting at more than 2000 RPM. Use the cruise control a good majority of the time. Keep tire pressure at around 37 PSI. Modify the air in take with either a K&N or a Stainless Steel Spectre air filter. Make a "Make shift" heat shield, to block manifold heat out of the air intake. You can use the bottom half of the stock air box. Avoid unnecessary up shifts (i.e. going up hill). Keep the car running at tip top shape. Hope that this will help you!
crank sensor on the front of the engine has gone out
How can you increase the horsepower of a 1996 740iL?
I have installed everything from cold air intakes, exhaust and software mods to complete supercharging systems . depends on how much power you want and money you want to spend.
Where is fuel cutoff switch on a BMW 735i?
I beleave it's in the trunk next to the battery. it say "Fuel cut off" and it's a cable you pull.
