0
Dodge Power Wagon
The Dodge Power Wagon was a four-wheel drive pickup truck manufactured between 1945 and 1980, with framework based on an Army truck. The Dodge Power Wagon served as a model for four-wheel drive pickup trucks used today.
387 Questions
Yes. But! You will have to change the rear out put casing and output shaft.
Why does 1984 dodge ramcharger stall under a load?
More than likely it is a fuel problem. When was the last time you changed you're fuel filter? Some times the pumps get weak and when the truck is under load the pump can't keep up. But don't roll out electrical.
What level do you have to fill your car fuel tank?
If you're asking how much gas do I need to get my car started it will run on a gallon or less in the tank on a flat surface You should always have at least 1/4 of a tank. If you just fill it up and keep it toped of then you don't have to worry about it.
About 6,500 lbs
What should the stock timing be set at on 83 dodge ramcharger 4x4?
You should be able to find that in any Chiltons manual. Read it through as you might have to disconnect the vacuum advance.
What axles did the 1972 power wagon come factory with?
Up to factory Dana 70 Drum Front and Dana 70 Rears. One ton that is. The Dana 70 Front stopped in 1974. 1975 was first year of D60 and 1978 was the first year for disc brakes on the D60. But To answer your question you probably had the Dana 44.
What is the Horse power rating for 1973 dodge 440 motor?
The 1973 Dodge 440 cubic inch engine was rated at 375 horsepower. That was with a single, four barrel carburetor.
Where to do I find parts for 1978 dodge power wagon 4x4?
When I need hard to find parts for my 1975 w200 and have exhausted everything I could think of I go to the web and check out mopartruckparts.com and seem to find the parts I need, and if I can't find new they could have used and I have had no problems with any of the parts
What is the 1956 chev v8 engine dis points setting for duel points?
.016 to.018 per set or 30 degrees dwell. Each set will have to be set seperately from the other.
Where can you get a wiring diagram for the electronic control unit in a 1986 Honda Accord LXi?
Try the technical dept of your library. I just got the complete wiring diagram for my 88 accord.
Where is a website you can order restoration parts for your 1974 Dodge Power Wagon?
One webiste that i go to for replacement panels is www.autobodyspecailt.com They are an excellent company that sell high quality parts at low prices.
How do you replace your broken oil dipstick tube on your 72 Dodge truck?
If you have the right kind of ez out,pull the piece out. Freeze the net tube over night and install it real quick.
What is the timing belt setting for a 2001 dodge 5.9 24 valve 6 cycle diesel?
The Cummins diesel does not have a timing belt.
How do you install a oil dip stick tube in 1984 dodge power wagon 318?
You will need to see if it is bolted to the side of motor, if so, remove fastener and clean the area where it goes into the engine. The dip-stick tube is generally pressed into place so you will need to attach a vice-grip to it and drive it out of the motor. Put a small amount of sealer on the end of the new one, and it must be started squarley (and orientated with the bolt hole lined up)into the block opening or it will bind.
usually it is just a matter of sliding the complete blade off. they can tough to get off. some types of penatrating liquids may help. make sure they are okay on the paint. You can ask the people at the parts store how with your vehicle. If they help you, then they know more than likely you will give them business in the future. hope it helps. duboff.
What should the stock timing be for your 1982 Dodge Ramcharger 4x4 with a 318 2bbl?
The timing should be set at 12 degrees before top dead center. If this is a Canadian heavy duty engine, it should be set at 2 degrees after top dead center.
If it has Power Steering, then it is driven by a drive belt. Look at the belts and what they are connected to. One of them is driving the P/S Pump.
How do you find the firing order for a 1978 Ford Thunderbird?
older fords have firing order cast into the intake manifold around calibrator
What is the Firing order for a 78 dodge power wagon?
1-8-4-3-6-5-7-2,all small block v-8s in that year were same
