0
Dodge Ram
The Dodge Ram is a large pick-up truck produced by Chrysler from 1981 to present. The car, which features a front engine and rear/four-wheel drive, was named “Truck of the Year” three times by the Motor Trend magazine.
13,744 Questions
No bus means there is no signal from the PCM,most likely a bad PCM,but check all your fuses and connections on PCM
1999 dodge ram pickup 1500 What would cause check engine yellow light to come on?
Hi it could be a couple of hundred of things. Go to a auto zone or a advance auto and have them put on the code scanner and they will tell you the code and what the problem is. Or email me with the code number they give you and I can tell you how to fix it. My email is whisperingelmsfarm@gmail.com
Where can you find a carburetor hose diagram for a 88 corolla?
The vacuum hose diagram should be on a decal somewhere in the engine compartment. jb
Well I don't have the answer, but I do have the same problem. Any one out there know how to remedy this problem ?
There is a bigger fuse box under the hood my daughter put a penny in the cigarette lighter and took the big fuses out there. They look like little plastic containers and you can see the fuse that is blown No one could tell me that. I found it on my own. I think its a conversion van thing. I talked to napa and auto zone and they had no clue about that second fuse box.
Very simple! Take off the wheel, just slide the old one off, then slide the new onw on!
What is the value of a 1965 Magnavox console stereo?
It would probably be fairly low unless you find a niche buyer in your area, as this piece of furniture would be hard to ship, and may cost more than it is worth. At best, you may get as much as $100 I'm sorry to say...
I would like to add to this and mention that I just purchased one, in absolute PERFECT condition, and I mean without a scratch... and I only paid $20 dollars. Seems as if the value should be higher but the man in the thrift store said that they are so widely available that he has even thrown them away in the past.
the egr valve is located on the back left side of the engine. getting to it is easier from underneath the car. (up on jacks). I had the same thing on a 96 mx-6. we canged the egr boost solinoid sensor located on the air intake box
What does P0404 diagnostic code for dodge ram 1500 mean?
Trouble code P0404 means:Exhaust gas recirculation circuit range/performance
Can you put 15 inch tires on a 16 inch rim?
No. Even if you were able to stretch the tire on the rim, it will cause damage to the tire.
How do you clean dodge 6.7 diesel exhaust particulate filter?
One way is by doing the stationary desoot by a local dealer or mechanic shop !
Where is the fuel pump located on 2007 dodge 1500 V8 Pick up?
Mounted on top and inside the fuel tank.
What is the largest size tire you can fit on a 15 inch rim?
I have 35 x 15.5 x 15 on my 2004 jeep wrangler with a 3" body lift. No rub, and everything works great, except you cannot use 5th gear with the standard Dana rear end.
What does the error code P2106 mean on dodge ram 2003?
Trouble code P2106 means: Throttle actuator control (TAC) system-forced limited power mode
How can you get the rotor button to point to the number 1 cylinder on a 440 Dodge engine?
First of all, you cant point a rotor button. Rotor buttons are mounted inside the distributor cap. You can point the rotor. The rotor is whats mounted on the distributor shaft and turns with the shaft. Remove the #1 spark plug. Disable ignition so engine doesnt start. With a helper bumping the starter, put your finger over the #1 spark plug hole and have helper bump starter until you feel air blowing by your finger. Now, using a large wrench or socket, manually turn the crankshaft and line up the timing marks to TDC. Your rotor should be pointing directly at TDC on cylinder #1. transman
Where do you put steering fluid in a 1996 dodge ram wagon?
there should be a reservoir powered by a belt with a cap in the front of the engine
How do you replace an electric window regulator in a 1998 Dodge Ram?
I would recomend getting a chiltons manual from your local auto parts store, so you will know the exact location of the door panel retainer clips, and screw locations, even the best mechanic will end up breaking a clip he didn't know was there. I would also highly recommened buying a (trim puller) from your parts store it should only cost a couple bucks and it will remove the plastic clips without breaking them as a screwdriver most likely would. In case the guy at the parts store is an idot, the trim puller or trim remover is usully found around where they sell screwdrivers and wrenches. It looks like a tiny spatula with a gove cut in the middle, the thin flat spatula slide under the door panel and the grove squeezes the two release tabs on the side of the door panel clips.
Where is the turn signal flasher on a 2001 Buick LeSabre -Limited?
GM fuse panels for the interior electrical components are left of the steering column, just above where the drivers left shin would normally be. Open the panel door and you should be able to see a large round flasher module... that's it!
actually on a 2000 lesabre limited its NOT in the fuse panel... if you drop the plastic piece that covers the bottom of the dash by your feet on the drivers side and look at the bottom of the steering column you should see the round flasher there with an orange and brown wire going to it... it should be a 552 wagner flasher number
How do you change the front left cv axle on a 1997 Plymouth voyger 3.3 liter?
remove wheel and caliper. remove axle nut undo tie rod end remove horizontal bolt at the bottom of spring and strut assembly that attaches it to lower control arm pry down on lower control arm and the spring assembly will swing out and away from axle axle should now pull out of tranny
Where is the blower motor resistor on a 2002 dodge ram 1500?
On a 1997 Dodge Ram 1500 Van, open the hood. The resistor assembly is at your upper left on the heater/AC ducting, with a cable of wires going to it, a trapezoidal plate about 2" x 3" held on by two small screws. Inside, it has a shrouded set of three resistors plus an unknown gidget that looks like a resistor about 0.1" x 0.5". On my van, the resistors are fine but the gidget is open circuit, or else it's a capacitor to stop radio interference. I also have a blown out motor (open circuit), and a shredded up flimsy, chintzy plastic fan. The ducting was clean, no sign of debris to block the fan except for pieces of fan blades. The fan motor is about a foot below the resistor, hard to get at but better than on most vehicles. R B Britton/ Hetex Engines Inc.
How do you bleed the hydraulic clutch line on a 1999 dodge 1500 pick up?
There is a bleeder valve on the slave cylinder of a 1999 1500 pick up. Have a helper press the clutch down slowly while you open the bleeder valve. let the air escape, then close the valve. Have the helper pump the pedal again and repeat until all of the air is gone.
How do you change spark plugs 2007 dodge charger 3.5?
1 Disconnect the negative wire to the battery. I did this to be safe.
2 Disconnect the oxygen sensor from the air intake. Do not pull from the wires only pull from the boot. Be careful not to break the sensor either
3 Pull the tube connected to the left side of the air intake off then remove the air intake.
4 Disconnect the map sensor and all other electric components that are attached to the manifold
5 Disconnect the cable that is connected to the throttle body (you do not have to take the throttle body off of the manifold to do this).
6 On the left hand side of the manifold there are 2 manifold support brackets loosen them up but do not take them off. When they are loose just pull the top part of the bracket that is connected to the manifold back and off the screws. .
7 On the right hand side of the manifold there is another support bracket that is connected to the throttle body. First take off the screws then where the support bracket connects to the cylinder bellow the manifold loosen the two bolts until you are able to slide the bracket out of the way.
8 On top of the manifold there are six bolts unscrew them.
9 Important! Before you remove the manifold to get to the spark plugs be very careful and remove the manifold by lifting it straight up and then pull it towards you slow. The reason for this is because there is a valve connected to the manifold directly in the back that you do not want to break. The tubes that are connected are long enough so you can take the whole manifold and place it to the right just out of the way so you can get to the spark plugs. (before changing the spark plug it is recommended that you take compressed air and blow away the dirt surrounding the spark plug area. This is done so that no dirt gets into the combustion chamber when you remove the spark plug.)
10 Once the manifold is out of the way disconnect the electric connectors that are attached to every spark plug. Pull them from the boot of the connector.
11 Repeat for all spark plugs - Unbolt the spark plug tube then pull it straight out and then with the spark plug socket unscrew the spark plug and replace it with a new one.
12 After the spark plugs are in on the left hand side of the engine in the back you will see a tube that says pcv. Remove the tube from the engine and unscrew the valve and replace it with a new one.
