0
Jeep Cherokee Laredo
The Jeep Cherokee Laredo was manufactured from 1985 to 1992 as a full-size SUV. Its earlier models had a 2.5-liter engine while the four-liter engine came out after 1987. It was designed primarily for the North American market.
1,043 Questions
What motor oil goes in a Jeep Laredo 2001?
4.0L uses 10w30
4.7L uses 5w30
4.0L uses 10w30
4.7L uses 5w30
The control unit for the transfer case is located in the kick panel. There's a technical service bulletin out advising that there's corrosion in the connector for the controller. Remove the kick panel, unplug the connector and use contact cleaner to clean the contacts. Use a small file if the corrosion is really bad. Then, purchase a small tube of silicon dielectric grease and coat the terminals before reinserting into the control box. The grease will seal out moisture. Do NOT use silicon RTV or any silicon calk to do this.
How do you replace an alternator on a 1991 Jeep Cherokee Laredo with air conditioning?
i have a 1993 Cherokee and you need to remove the battery holder to pull the alternator out its just unhooking the wires and and the two bolts. you need to find out how to loosen the belt tensioner
I have a 1992 Jeep Cherokee with air. Its quite a lot more effort than this. I just did it and it took me slightly under 3 hours.
You'll need a 15mm, 13mm, 10mm and 8mm sockets and a 3 inch and 6 inch socket extender. You will need the same sized for regular wrenches as well.
The problem is available room. You have to take out the battery and the battery holder (15mm nuts), then remove the fan housing and then the fan (4 13mm nuts that are hard to get off if the serpantine belt is not tight) - the fan is in the way and you won't be able to get the alternator out if its inplace.
Next, you need to remove tension on the belt - this is done with a 13mm socket and wrench (access is tight on some bolts). Remove the bolt in the back of the power stearing pump assembly, then down below the pump you'll find another to loosen (don't remove). the loosen the one at the top fo the power stearing pump - you'll find a bolt under the pump where you can loosen the tension on the belt. This may be stiff and will require a 6 inch extension (the air filter and water hoses are in the way)
Once the belt is loose, you can take the 2 bolts that hold the alternator off (15mm). There is are 2 cables attached. One to an insulated post (10mm socket) and another one that is ground and some other alternator connections. the cables are attached to the block via a 13mm nut - remove this and you can pull the alternator out (I had to wedge it out with a broom handle). remove the cables, and clean the contacts on them with some 150 grit emery cloth. Pull the Alternator out and put the new one down and re-attach the cables. You'll need an 8mm socket for 2 of these nuts.
Slide the Alternator in and get the bolts in (its a tight fit on the engine).
Reassemble in the reverse order (getting the bolts back on the fan assembly took me quite a while).
I spent $115 on a the new alternator.
What would cause a screeching sound in a 2000 Jeep Cherokee Laredo when it is put in park?
Loose or worn out serpentine belt.
How much oil do you need for an oil change in a 1995 Jeep Cherokee?
Start with five quarts and then check the dipstick. Add a quarter quart at a time til the dipstick reads full. Seems to me that if you have to be told this you should be taking your jeep to the instant oil change place and letting the high school dumbasses do your oil change. Just my opinion of course.......
Can i put a 4.0 engine into a 1989 jeep that had a 4.2 engine?
No it is to big of a cubic inch. But if you have time you can but you would have to redue the main frame and the engine mount.
How do you change 2001 jeep Cherokee window regulator?
http://www.jeepin.com/features/wj_window_regulator/Don't replace the regulator assembly. That's a more expansive and temporary fix. The plastic part at fault will fail again. For 30 bucks per window + shipping to anywhere in the world you can get this alluminum clip to permantly fix this problem. They have great instructions or if you feel you can't do it yourself (not that difficult) they can arrange to do it for you. I did this on one window. Now I wish I had done all of them because it is even easier to do before it breaks. Go to this web address. http://pocketlogger.com/?pid=jpw Problem Solved, Alan
How do you change the heater core on a 2001 jeep Cherokee 4.0 Automatic?
Its a tough job. You have to remove the dash panel, including the steering wheel and steering column and then remove the plenum box which involve evacuating the refrigerant system and draining the radiator. Once you get the heater box out, replacing the heater core will take about 10min and then you have to put it all back together and recharge the AC and fill the radiator.
If you are seeing leak problems with the system, you will have to go through this process. If the problem is lack of heat and/or AC control, the problem is more likely the blend door. This is a common fail on the Cherokee. You can get diagnostic information and an inexpensive fix on the HeaterTreater web site. Follow my user name to my Bio Page for a pointer or just search heatertreater on any search engine. ford4me
How much oil does a 1990 Jeep Cherokee Laredo need?
It requires about six quarts. I suggest putting in 5 and a half and checking the oil level on the dip stick. Then from there add a little at a time, until you get it just below the full level indicated on the oil dipstick.
the indicator light is powered by the transmission fuse(10 amp fuse) check the fuse and see if it's blown. the indicator light is powered by the transmission fuse(10 amp fuse) check the fuse and see if it's blown.
Could be a problem with the 'self parking' switch gone faulty The switch is under the metal cover of the actual wiper motor - so you would need to remove the motor to investigate further Hope this helps
Can you show picture of where is the alternator located on a 1992 jeep Cherokee Laredo?
its bottom passinger side. beneth a/c pump
you read the directions!HAHA!
Why do your Jeeps high beams stay on all the time?
your beam selector lever is prob. busted and needs 2 be replaced. or its a wiring prob. check some fuses and the wires to the selector if everything is ok there, then you prob need a new selector
Can you use a toggle switch to turn your windshield wipers on and off?
Yes you can. I did it to my 91 s10 however you wont have control over your wiper speed since its only a two position switch on/off. I have a 3 position switch on/off/on one for slow and one for high however I have not tried this out yet.
the most fun to drive would have to be the wrangler in my opinion..but the most reliable would be a cherokee..I've had mine since 1994 with barely any problems.
Is there an auto trans fluid overflow tube 89 Jeep Cherokee?
Are you asking because your transmission fluid leaked when warm and doesn't show any more signs of leaks???
Does a 2000 Jeep Grand Cherokee Laredo limited have factory remote engine starter?
No, remote start was not a factory option in 2000.
This light means that water has got into the fuel filter and is now due a filter change
Why would the interior lights flicker on a 1995 Mitsubishi montero while driving?
Sometimes when cornering, the overhead lights will flicker on in that model car. This is due to a flaw in the switch mechanism design, which holds the relay connection slightly apart from the bulb (when they touch the light is energized and turns on). When the car turns the centrifugal force will bring these two points together and the light turns on. To fix this, remove the plastic dome and switch cover and look for a tightening screw. If there is not a screw, you may be out of luck. If there is, tightening it should prevent this random flicker.
