0
Mazda Protege
Also known as Familia in some markets, the Protégé was a compact car produced by Mazda Motor Corporation from 1964-2003 for the North American market. The Protégé was one of the company’s best sellers and was manufactured in eight generation models.
1,312 Questions
How do you replace the Oxygen Sensor in a 1999 Mazda Protege SE?
Yes, they are only good for either 60,000 or 100,000 mile depending on which type was used.
Where is the PCM located oa a 1998 Mazda Protege?
is under the transmission stick console, heres a web page for mre info.
http://www.scribd.com/doc/51604740/Mazda-Protege-Workshop-Manual-1994-1998R-English
Where is the ac charge on Mazda Protege?
On a 1998 Protege it's in-between the engine and the radiator (on top) directly behind the hood latch. I would tighten the cap by hand.
For all mechanical and electric connections (or any connection) my philosophy is: If it doesn't fit DON'T force it, look for the correct one or ask a qualified professional in that field because you can't make a wrong right.
Where's the oil dip-stick on the 1998 Mazda Protege?
As you arefacing the engine compartment with the hood up, on the left side you will see a yellow handle down by the belts. This is the oil dipstick.
Why does your 95 Mazda protege shut off on acceleration?
A 95 Mazda Protege will shut off during acceleration if the air and fuel mixture is drastically incorrect. A vacuum leak or fuel flow restrictions can both cause this problem.
114 ft lbs of torque. 125HP... edmuds.com is a good place for info like this!
What oil weight is recommended for a 1996 Mazda protege?
5w30 oil is recommended. conventional, semi-synthetic and full synthetic oils are all compatible with this engine.
The best way to start approaching the diagnostics of the problem is to isolate possibilities. Start by testing the fuse to ensure you don't have a bad fuse.
How much does it cost to repair a Mazda Protege 5 engine and muffler?
Brand new engines are quite expensive, around $7000. I would suggest buying a used engine from a garage that has LOW mileage. I did this in my 2002 Mazda Protege 5 3 years ago and it's running great. I paid 2500 for the engine w/ installation. I would NOT recommend a rebuilt engine b/c those have higher rates of failure. Hope this helps for the engine...The muffler is something I have NO idea about.
How do you replace brakes and rotors on a 2003 Mazda Protege 5?
On these cares its pretty simple...
- remove wheel
- remove two bolts that hold the caliper
-the pads could be removed then
- then there are two bolts that hold the bracket that holds the caliper, remove those.
-once removed the rotor should be loose so you just slide it off, if not hit it wit a hammer a couple times since it might be rusted and stuck.
do this backwards to re-install
How do you manually start the starter to make a car start?
Jump the wires on the starter solenoid - Jumper wire connected the large cable running to the starter and the smaller "trigger" wire
The solenoid in most vehicles today is located ON the starter. If you attempt the aforementioned answer, BE CAREFUL.
What does the hold button on the 92 Mazda Protege do?
I have a 1993 Protege. The hold button keeps the transmission from up shifting. I use it when I am coming down the hill in my neighborhood. Rather than braking the hold button keeps the trans in a lower gear and I remain at a safe neighborhood speed.
There is a 14 mm bolt on back of caliper. Remove this & use a 4 mm Allen wrench to back piston into caliper.
Where is the access cover for the flywheel and drive belt on a 1992 Mazda protege?
at the back of motor in front of transmission at the bottom have to remove 4 , 10mm bolts hope this helps
Where is the turn signal flasher located on a 1998 Mazda Protege?
In the driver's compartment on the left side above and slightly forward of the fuse box. It's the unit with a three wire connector.
WRONG! Its a 8 wire connector relay box.Thats from the schematic diagram in Mazdas wiring manual. The 3 wire is a relay for the emergency flasher relay. I don't know where it is.
What does check engine code P0171 mean for 2002 Mazda protege 5?
Trouble code P0171 means :System too lean (bank 1)
How do you tell if the water pump is not working on a 92 Mazda protege?
If it is leaking or noisy then it is bad. You should also be able to see the coolant flow with the engine cool and radiator cap off. Give it time to warm up and you will see the movement of coolant if it is working.
Why wont my 2000 Mazda protege start when I drive for a while?
needs a coil or distributor
it could also be that the alternator isn't working and the car may be draining the battery every time you drive it
Why do you hear a clicking noise when you turn the wheel on your 1993 Mazda Protege?
I had this issue with a Honda accord, the sound may be your CV joints and not the wheel itself.
