0
Mazda
Founded in 1920 by Jujiro Matsuda as Toyo Cork Kogyo Co., Ltd, Mazda Motor Corporation is a Japan-based automotive manufacturer that sold over 1 million vehicles in 2007. Some of the popular vehicles manufactured by the company are Spiano, AZ-Wagon, MX-5/Roadster, RX-8 and BT-50.
1,848 Questions
No. Honda does not produce the Mazda vehicles and does not own any percentage of Mazda. Mazda is only a small percentage owned by Ford.
Where is located vehicle speed sensor on Mazda mx3?
Necessity speedometer sensor que va en el panel de instrument cluster vin jm1ec4313p0212457 mazda mx-3, 1.6l , 4 cylinder's, automatic ano 1993
Where is the location of the horn on a 1992 Mazda Protege?
It is buried up under the right front fender. I am going to replace mine as it is not sounding very loud. You can get at the feed wire easy enough. So I will mount the new horn in a more accessable location
Does a Mazda etude 2001 model have a fuel filter and if so where is it located?
If there is no fuel filter on the fuel lines or near the engine or fuel tank then it has a permanent filter mounted inside the fuel tank that requires no maintenance.
How do you program the remote key fob on a Mazda 6?
1. Open the car door, then turn ON and OFF the ignition switch for 3 times, don't take out the key.
2. Close door then open it, repeat for 3 times, the door lock should activate, and system enter learning status.
3. Press any button on the remoter, the door lock should activate.
4. Remove the key, the car door should activate again, and the remoter programming successful.
Also you could use SKP-100 or SKP-900 OBD2 Key programmer for it.
http://www.ecutool.com/productshow.asp?id=11272&cso=autoshop
Also could contact me for more details about key programming technicals
Skype: llifang2012
Where is the horn fuse in 1993 Mazda Protege?
If you open the fuse panel (to the left under the steering wheel), is is the upper most left fuse. It's a yellow one (20), but it also controls your stop lights so be careful. Hope that helps!
How do you install a front windshield on a Mazda RX-7?
PRY UP THE RETAING CLIPS SECURING THE COVER BAND AROUND THE WINDOW GLASS WITH A SMALL SCREW DRIVER CAREFULLY. LIFT AWAY COVER BAND AND STORE SAFELY OUT OF THE WAY AS THIS CAN EASILY BE BENT. GLASS IS GLUED IN PLACE AND NEEDS TO BE HEATED SLIGHTLY AROUND TOTAL OUTSIDE AREA OF WINDOW TO SOFTEN GLUE. THEN THE WINSIELD CAN BE PRYED OFF SURFACE. CLEAN AWAY ALL OLD GLUE TOTALLY. FOLLOW NEW GLASS INSTRUCTIONS TO INSTALL. BE VERY CAREFUL NOT TO BUMP NEW GLASS ON ANYTHING. I'VE DONE THIS ON MY 93 NISSAN 300ZX. GOOD LUCK. RGL, AKA, RGL
How many engines does a 737 have?
It actually has 3 engines. Two that propel it in the air and one in the tail called the APU. This is a small jet that provides power for the aircraft systems while on the ground when main engines are off. It is shut off in flight.
Where is the fuel filter located on a 1996 Mazda b2300?
Where exactly it the fuel filter located on my 1996 Mazda protege 1.5 motor.
Depends on what that fuse is protecting. My advice is leave it alone.
the ECU is likely different as the 89 engine has several changes that increase the power from previous versions. see if you can have the idle adjusted, if not find an ECU from an 89
What is the highest odometer reading Mazda rx8?
It is the odometer in kilometers, the first is in miles.
Where does the transmission fluid go in a 1991 Mazda 121?
Hello, I just rang Mazda - about my wifes Mazda 121 1.3 liter manual DB Bubble. They told me that the transmission fluid goes into through the speedo cable. I unscrewed the speedo cable and you will see a bolt that needs to be undone to pull out the speedo gear peice. This peice looks like a tube of metal with a little plastic screw gear on the bottom end. Poor about 2.5 litres of transmission fluid in this should be the correct amount (that's what came out)
Put the parts back together again and it should work.
to line up the speedo cable onto the tube thing you took out there is a metal notch on the cable that only goes on one way.
Hope this helps
Ian Macleod
What size engine does a Mazda MPV have?
MPV came a 4 cyl 2.6 liter and a 6 cyl 3.0 liter tom_fdee2002 at yohoo dot com ^^ that's the 89-98 body. The 2000-2001 has a 2.5 litre Duratec DOHC as found in the Contour and the 2002-2006 has the 3 litre version of it as found in Taurus, Tribute and others.
Can power steering fluid be used as transmission fluid?
It's probably best not too. Considering transmission fluid comes in larger containers at generally a cheaper price you're better off just getting that. Some transmission fluids (depending on car make and model) can be used in place of power steering fluids however. This can be useful if you start hearing that whiney sound when you steer and only have transmission fluid. If it doubt, consult the owner's manual.
How do you replace the headlight bulb on a 1996 Mazda truck?
Just changed mine about 30 minutes ago. First, get the replacement bulbs from any automotive part store. Lift the hood, and behind the lamp, there is a plastic twist coupling that you unscrew. Withdraw the bulb assembly. That was the easy part. You'll find that the lamp is held to the rest of the assembly with a plastic latch. Take a small flathead screwdriver and lightly pry the latch. Then pull, not too hard. Once detached, remove the old lamp from the coupling. Install the new bulb in the coupling, then reattach to the wire. That process should take about 5 minutes. Now comes the hard part. You not only have to line up the coupling with the back of the lamp, you have to make sure you're holding the assembly just right so the there is enough clearance to allow you to twist it back on. It took me about 10 minutes and alot of cussing to get just one back in. You'll have to move the battery back to get enough clearance to work on the light assembly in front of that. Overall, it took about 25 minutes to do both. Good luck.
What does it mean when the hold light flashes on youir Mazda Familia 1997 model?
It can mean several things if the hold light flashes on your Mazda Familia 1997 model. It can indicate a shortage in the wiring or a blown fuse.
How do you get the dome light and the Door Ajar light to go off on a 2001 Mazda B400?
OK on the Mazda B4000, make sure the seat belts are retracted and the ends on the doors are facing up. If they are not up, it will cause the rear doors to not close all the way and the stupid light stays on! you can also use wD40 and spray the locking mechanisms ( all 4 doors) John
Why is the ABS light on in your 1991 B2600i Mazda pick up truck?
try checking underneath your brake petal for the brake switch might be sticking. or possibly needing brake pads. check calipers and shield for possible mishap(brush or limb got caught and pushed shield next to caliper or in that nature)
hi i am looking for the torque settings for a proton gen 2 cylinder head bolt and crank shaft bolts both big ends and main bearing bolts
