0
Mazda
Founded in 1920 by Jujiro Matsuda as Toyo Cork Kogyo Co., Ltd, Mazda Motor Corporation is a Japan-based automotive manufacturer that sold over 1 million vehicles in 2007. Some of the popular vehicles manufactured by the company are Spiano, AZ-Wagon, MX-5/Roadster, RX-8 and BT-50.
1,848 Questions
hi i am looking for the torque settings for a proton gen 2 cylinder head bolt and crank shaft bolts both big ends and main bearing bolts
What was the fastest lap time posted on the Mazda Laguna Seca Raceway by who and in what car?
Lorenzo ona r1
A rotary engine has how many pistons?
0. A Rotary Engine does not have any pistons.
The rotary engine is an early type of combustion engine. There is no particular quantity of pistons to a rotary engine, but usually an odd number. The type of engine known as the Wankel engine and sometimes known as a rotary engine has no pistons, but has one rotor per combustion chamber.
Where is the O2 sensor for a 4 cylinder 1999 Mazda ES?
Start at the exhaust manifold and work backward toward the rear of the car. It may have more than one. They will be located somewhere on the exhaust system. Looks like a spark plug with a wire coming out the top.
How many miles do Mazdas usually get before having to replace valves?
Approximately 141 thousand...if it is cared for to the letter with monthly maintenances scheduled and followed....
Will a 1993 Mazda miata 1.6 liter engine fit in 1992 Mazda b2200?
Is very possible but it is a wate of time and money, I have B2200 and trust me the smallest engine that can manage the weight of that mini pick up is a 2.0L anything smaller is a waste, I tried with RX7 engine and it is not that reliable, unless is turbo and have to play with diferential ratios
What is the material piston engine car?
It depends on the type of car u're looking at but generally they are Aluminum and Silicon. Or cast iron.
How do you repair a clutch in your Mazda 1991 pu b2600i?
See if your public library has a Chilton's for your car to replace the clutch.
Where is an 1988 Mazda 626 fuel pump relay located?
On a 1988 Mazda 626, the fuel pump relay is located in the fuel tank. Always disconnect the battery before beginning work on a fuel system.
What is a diagnostic code of P0134 mean for a Mazda?
Trouble code P0134 means:O2 sensor circuit no activity detected (Bank 1 Sensor 1)
How many miles per gallon should a six cylinder get?
I have gotten anywhere from 15-26 mpg deoending upoin whether I'm towing or riding 55 mph straight and level.
No thermostat, no coolant, no waterpump. Basically you have no coolant circulating.
Where is the heat sensor on Mazda mx 3?
There is a coolant temperature sensor and a temperature gauge sensor. the coolant sensor is located on driver side of the cylinder head. screws right into it, and the temperature gauge sensor is on the front side of the cylinder head right under the distributor. hope this helps
When should i engage 4wd on a Mazda tribute?
1) When your vehicle is stuck and unable to achieve movement in 2WD mode.
2) While driving on soft (unpaved) surface such as mud, deep snow, or sand.
3) When otherwise unable to climb over an obstacle.
Do Japanese vehicles also have 17 digits in VIN numbers?
Yes, and they start with the letter J to indicate built in Japan.
Where is the speed sensor on a Ford Ranger XLT or Mazda Drifter 2.5TD?
The speed sensor is located on the differential (rear end) I have a 99 Ford Ranger and have recently replaced one. EASY! Good luck!
Look for a broken or missing rubber vacuum cap on a vacuum port on the front side of the intake. If it is broken or missing, the vacuum leak will cause certain sensors to misread and it may overfuel the engine. ANY substantial vacuum leak will do that also. The classic symptom is that it runs fine for up to 15 minutes froma cold start. If it cools down and runs good again until it warms up, that is the clue. It has to do with the point where the fuel system goes from open loop into a closed loop operation.
Your 1995 Mazda 626 tries to stall while idling or accelerating from being stopped any ideas?
I have a 2000 Mazda 626 with the same problem and the mechanic is dumbfounded. My best guess after ruling out any fuel problems is the catalytic converter. Does the stalling/cutting out get worse if the A/C is on? Does it get better for a while after the car has been sitting cold?
How do change a blown head gasket on a 1989 Nissan 240SX?
try using steel seal. you put it in your coolant and it seal the leak if theres exhaust gases in your radiator fluid or if your getting radiator fluid into your piston area. check out steel seal and i swear it will work for you its great!
Ford, Mazda, it doesn't matter, it's the same transmission in both Mazda and ford.
1994 Mazda protege location of the fuel filter?
Fuel filter is located in left rear (firewall) corner of engine compartment. check near the brake booster/master cylinder.
Does the Mazda rx8 have a v6 0r v8 engine?
It is in fact neither. It is a rotary type of engine, there is nothing v about it.
Why won't 1984 Mazda B2000 front brakes release?
More than likely the slides are corroded. They have a funky chrome plated slide setup. Once the chrome wears/corrodes off, they like to hang up. Try disassembling the system and cleaning/lubricating the slides. Rhese trucks seeb to absorb moisture in the brake system over the years causing the front calipers to fail. I've owned 4 of these trucks (1982-1984) and have had problems with the calipers on 3 of them. I would suggest changing the front calipers and bleeding the brake fluid of the entire brake system. If it is a manual transmission I would suggest changing the fluid in that sytem as well. They both use DOT 3 brake fluid. If you ever have any questions or need any parts for this truck, my email is ImDrunkOrUrCute@sbcglobal.net. Hope this helps. -- Chris
Same as with most cars, failure in the ignition system, electrical failure, failure in fuel supply. The only time mine has failed to start in over 220k miles was a knackered battery which spontaneously died.
