0
Mitsubishi Mirage
The Mitsubishi Mirage was a car manufactured between 1978 and 2002. It was also marketed as the Mitsubishi Colt or Lancer Fiore. Five generations of this car were manufactured, all of which featured front-engine and front-wheel drive.
561 Questions
Where is the horn on a 1997 Mitsubishi Mirage LS 2 door?
well i have a 4 dr but it should be the same place and its in the right side back of the engine bay.
Where is turn signal flasher located on a 2001 Mitsubishi mirage?
The 2001 Mitsubishi signal flasher relay switch is located beneath the drivers side dashboard. The signal flasher relay switch will be above the accelerator pedal.
How do you replace the headlights in a 1997 Mitsubishi Mirage?
Where is the turn signal flasher on a 1997 Mitsubishi Mirage?
Above the driver's Left foot, on the firewall. It's the big one on top. I just you must push both sides to disengauge the snap lock in, the replacement doesn't have the snap locks. Just did mine, wasn't the problem
How do you change headlights on 1998 Mirage?
There two nuts and one bolt you have to remove. I believe all you need is a 10mm socket to remove these fasteners. Pry off the corner light and underneath are the two nuts. On the inside toward the grill is the other bolt. Take those off and the whole headlight and housing comes out. Make sure you unplug the headlight harness too!
If a 1997 mirage de has a heavy vibration in park and in gear how can you stop it?
Repair the misfire condition. Consider replacing spark plugs and wires.
Your gauges might not work on the 1997 Mitsubishi Mirage because of exposed wires or a short in the wiring. This could cause the problem when there is moisture or a lack of moisture in the panel. You might also have a faulty fuse.
How do you replace the headlamp on a 1997 Mitsubishi Mirage?
Did you learn how to do it? I have the same problem. Please share if you found the answer.
I removed the blinker and there are two bolts that I unscrewed but the headlight did not come out. I don't know what to do next.
New- Open the hood. Pull out the electrical plug by pulling straight back, horizontally.
- Next, remove the black rubber boot. (The plug you just pulled out was plugged into the middle of this boot).
There is a tab on the boot at the top. You will need to work/pull the boot awhile to get it to come loose.
- Release the old bulb with the clip that holds it in place.
- Put the new bulb it and secure it with the clip. (Remember not to touch the bulb with your bare hands as this can cause it to burn out quicker.)Put the boot back on and plug the electrical plug back in.
How to replace a Mitsubishi Mirage starter?
Disconnect the battery. Look under the hood and see if the starter is on the radiator side of the engine or the back side. Probably is on the back side. Jack the car, remove the bolts, making sure you remember which bolt secured which wire, remove the starter. Put the new starter in, making sure it is the right application, thread the bolts by hand, making sure to put the wires back correctly, then tighten them good. Reconnect the battery, and there you go.
Timing belt Mitsubishi mirage?
The timing belt on a Mitsubishi Mirage connects the camshafts with the crankshaft. This ensures that each valve is opened at precisely the right time based on the rotation of the engine.
How heavy is a Mitsubishi mirage?
The 1997 Mirage weighed in at 2127 lbs. If you really want an accurate weight we need the year and model of the Mirage.
What makes a 4.3 ECM different from a 5.7 ECM?
The injector pulse would be different the sensor readings would be different so engine would never run smooth IF even started.
How do you get a radio code for a 2001 Mistubishi Mirage?
The Mitsubishi dealership is the only place to get the code.
To give you the code they will need the serial number off of the radio its self. To access the code remove the ashtray, anything in the drink holders and items stored in the cubby under the radio. Next, using your finger nails, pry off the section of dashboard that surrounds the radio and houses the ashtray, cubby and cigarrete lighter. Start at one of the seams on the sides and lift first one side then the other. It should come off very easily due to the fact that this piece is secured by metal spring clips rather than the normal plastic clips that are not intended to be removed. Once the panel has released unplugg the cigarrette lighter noting which connector goes were and set the panel aside. You will see that the radio is secured to a bracket which in turn is secured to the dashboard by four Phillips head screws. Remove those screws. Now you can pull the radio out far enough that you can read the serial number. For reassembly reverse the above steps ensuring that you carefully guide the lighter connectors back thru there hole in the dash, if they get caught on the edge you risk damaging them and the panel will not go back on easily.
Now that you have the serial number, the dealership can quickly give you the code to restore function to your radio. They should require proof of ownership due to the fact that this is an antitheft feature. Detailed instuctions for entering the code can be found in the owners manual. If you don't have the owners manual the dealer can provide those instructions. Be careful entering the code because after a few incorrectly entered codes the radio with permanently disable itself. Once that happens the only solution is a new radio.
Where is the IAT sensor on a Mitsubishi FTO?
I belong to the FTO owners club here in England. I found some information you may be looking for. http://ftooc.org/phpbb/viewtopic.php?t=18530&postdays=0&postorder=asc&start=0
How do you change the transmission filter on 2000 Mitsubishi Mirage?
drain the transmission fluid drop the pan an you should see it. if not drop the next component in line an itll be there. reassemble replace fluid. DONT get any dirt on anything an DONT drop or bend anything. other wise your transmission wont work right if at all
Where can you find a radio wiring diagram for a 1997 Mitsubishi Mirage?
go to wal mart and get the wire harness it will tell you what goes where.
How do you change a timing belt on 97 Mitsubishi mirage?
what steps do i take to change a timing belt for a '97 mitsubishi mirage
Where can you find the timing setting for a 1992 Mitsubishi Mirage?
Where are the timing marks when installing a new timing belt in a 1993 Mitsubishi pickup?
Before changing any timing belt, it is recommended that you first line up the crankshaft timing and the camshaft timing. To get both aligned, you have to rotate the cranshaft twice. After rotating the crankshaft, align the mark to "0". Take note of any other markings and then you cane begin to disassemble the timing belt. It would be a great help if you can get some cam locking tool to hold the cam in place if you have a DOHC engine
Where can you find schematics for a 2002 Mitsubishi Mirage?
how do you change thew healdights on the drivers side of a 2002 Mitsubishi mirage de coupe???? plzzz help!!!
