0
Oldsmobile Cutlass Supreme
Manufactured by General Motors from 1966 to 1997, the Oldsmobile Cutlass Supreme was a mid-size car produced in five generations. Its fifth generation model was available in three body styles: 2-door convertible, 2-door coupe and 4-door sedan.
2,211 Questions
Try pulling the hood release then going to the hood and pulling up on the hood by the edges. If it pops up manually then you can spray up the latch and mechanism real good and it should get better. If not then you will have to fish in the grill and try to release the latch.
Also you may need to crank out the spring loaded hood supports on each side of the hood to add more pressure on the hood so when you release the hood it would pop open because of added pressure. Just a half turn on each one or so counter clockwise;
How do you remove thermostat on 1994 cutlass supreme 31L?
You can remove the throttle body. It is then so much easier to get to the bolts for the thermostat housing.
Where is the engine fan relay for a 1993 Plymouth Acclaim located?
Behind battery mounted on the side of the strut housing. the connector color is GREY. F. Garay
Why is my 1986 cutlass dumping too much gas from the carb into the intake?
The choke could be in need of resetting, the floats could be off specs, your carb probably needs rebuilt or replaced.
check your ignition module, autozone can check it for free
What is the bolt pattern of a 1997 Oldsmobile Cutlass?
OLDSMOBILECUTLASS SUPREME (FWD)1988-97Metric: 5 X 115
Standard: 5 X 4.5216 X 6 12 X 1.5 70.3
It could be on your dash panel or possibly between the seats. Without a make or model, no one will ba able to help you. Consult you vehicle manual.
sounds like your back breaks are wore you use them the most when you are backing up.
How do you replace Alternator in an Oldsmobile Ciera?
first you need to remove the serpentine belt. best way to do this is to use a serpentine belt tool. then its actually very simple, there are three bolts that hold it in one up front, and two in the back, and then there is a plug on the bottom you have to unclip.
See: http://www.loc.gov/rr/print/resource/037_hist.html or http://www.philaprintshop.com/washngtn.html for resources that might help answer your question. The value of any work of art depends on demand and condition. The Library of Congress' copy was deposited for copyright in 1861. Sara W. Duke, Curator, Popular and Applied Graphic Art, Prints & Photographs Division, Library of Congress, Washington, DC 20540-4730.
Stock, 365 Horsepower @ 4600 RPM. However, this motor is the ultimate torque monster, 510 ft/lb @ 3000 RPM. If you have this motor, you are officially made of awesome! With mild mods it's easily a 400 horse motor. This is not true of 455 motors after 1969. 1968-9 motors are the strongest as they haven't been smogged down yet.
If your battery is good and you hear nothing when you turn over the key, you should check the starter and or solenoid to begin with. The solenoid should make a "click click" noise when you turn the key. Most parts stores will test it for free. If your battery and starter are good, then look to the ignition switch.
Hope this helps.
Answer 2You might also want to check for loose wiring or a loose battery cable,Answer 3
I own a 1985 Oldsmobile cutlass supreme. I had the same problem- it drove me nuts. it wasnt the battery, starter ingnition switch, nothin. It turned out to be the ignition module. Its located under the distributer cap. we swapped it out with another one we found, and it started right up. im not sure why these things go bad.
Where is the ignition fuse in a 1976 cutlass supreme?
The fuseable link for the ignition could be on the starter, or running along the firewall.
on that year it should have a in-line fusible link near the starter. you can find at any auto parts place.
How do i remove the front speakers in a 1992 cutlass cierra s?
pull out the speaker covers, get a 7mm socket, & remove the 2 screws..
Where do you find the actual horn on a 1992 Olds Cutlass Supreme?
should be up near the front on either the front finders or in front of the radiator near the bumper.
Why would the security light blink in a Cutlass Supreme?
Check your fuses behind the glovebox. I had the same problem and turned out to be the fuse to the "lighter" was out. May, or may not be the same fuse but this light was letting me know that something was not "right."
Working on 1993 Olds Cutlass Ciera 'S' right now with the exact same situation! Basically, the usual problem here is that the P/S pump driveshaft seal is what fails so you have P/S fluid leaking out there. The easiest solution is to replace the P/S pump with a re-built one, but in my case I have already taken the pump off, and removed the pulley from it because my plan is to just replace the pump driveshaft seal since I know that the pump itself is fine because it worked perfectly prior to the leaking problem, and I am incredibly cheap! Because replacing only the driveshaft seal requires a higher level of skill, this may not be for the average do-it-youselfer so in that case replacing the entire pump would definitely be much easier but you'll probably still have to remove the pulley from the old pump, and then re-install it on the replacement pump. A puller is required to remove the pulley, and a simple installation tool will put it on the new pump! This is really not that difficult if you have these tools, which can be rented for a few dollars at some large auto parts stores. A little experience is also helpful. To me, this is not really that difficult a job, but then I've been doing my own work on cars since I was about 15, which is about 30 years. Be sure to clean everything so as to remove all P/S fluid from all pulleys and belts, and also be sure use the appropriate new P/S fluid for this vehicle when filling the reservoir to the proper cold level, and do not over-tighten belts! Thanks
How can you open the hood on a 1984 Cavalier if the hood release cable is broken?
Take it to a body shop as they have to open then on wrecks.
